Solar photocatalytic degradation of pesticides over TiO2-rGO nanocomposites at pilot plant scale.

Two TiO2-rGO nanocomposites were prepared by hydrothermal method from commercial TiO2 (P25 and Hombikat UV100, HBK). In both cases TiO2 nanoparticles appeared intimate and homogeneously distributed on rGO surface, but forming a dense network in P25-rGO nanocomposite, and a more open structure in HBK-rGO. Zeta potential and particle size distribution favored the ease of HBK-rGO nanocomposite to form stable suspensions. A comparative analysis of these two photocatalysts was performed on the pilot plant scale solar assisted photodegradation of a 200 µg·L-1 or 5 mg·L-1 mixture of persistent and biorecalcitrant pollutants in deionized water (methomyl, pyrimethanil, isoproturon and alachlor, all used as pesticides). Complete removal of pesticides was achieved, though faster with P25-rGO when O2 was the oxidant. However, the use of hydrogen peroxide (H2O2) dosage as oxidant speeded up pesticides removal, but HBK-rGO performance resulted much improved. Finally, at realistic very low concentrations of 200 µgeach pesticide·L-1, the complete removal of pesticides was achieved at very short times (<25 min), showing the efficiency of the synthetized TiO2-rGO nanocomposites in this pilot-plat scale solar process to mitigate refractory and biorecalcitrant contaminants on effluents as a sustainable and efficient process.

Solar-assisted photodegradation of isoproturon over easily recoverable titania catalysts.

An easily recoverable homemade TiO2 catalyst (GICA-1) has been evaluated during the overall photodegradation process, understood as photocatalytic efficiency and catalyst recovery step, in the solar light-assisted photodegradation of isoproturon and its reuse in two consecutive cycles. The global feasibility has been compared to the commercial TiO2 P25. The homemade GICA-1 catalyst presented better sedimentation efficiency than TiO2 P25 at all studied pHs, which could be explained by its higher average hydrodynamic particle size (3 µm) and other physicochemical surface properties. The evaluation of the overall process (isoproturon photo-oxidation + catalyst recovery) revealed GICA-1 homemade titania catalyst strengths: total removal of isoproturon in less than 60 min, easy recovery by sedimentation, and reusability in two consecutive cycles, without any loss of photocatalytic efficiency. Therefore, considering the whole photocatalytic cycle (good performance in photodegradation plus catalyst recovery step), the homemade GICA-1 photocatalyst resulted in more affordability than commercial TiO2 P25. Graphical abstract.