Reliability and validity of the patient disability-oriented diagnostic nomenclature system for prosthetic dentistry.

PURPOSE: The Japan Prosthodontic Society (JPS) has proposed a new diagnostic nomenclature system (DNS), based on pathogenesis and etiology, to facilitate and improve prosthodontic treatment. This system specifies patient disability and the causative factor (i.e. "B (disability) caused by A (causative factor)"). The purpose of this study was to examine the reliability and validity of this DNS. STUDY SELECTION: The JPS Clinical Guideline Committee assessed mock patient charts and formulated disease names using the new DNS. Fifty validators, comprising prosthodontic specialists and dental residents, made diagnoses using the same patient charts. Reliability was evaluated as the consistency of the disease names among the validators, and validity was evaluated using the concordance rate of the disease names with the reference disease names. RESULTS: Krippendorff's α was 0.378 among all validators, 0.370 among prosthodontic specialists, and 0.401 among dental hospital residents. Krippendorff's α for 10 validators (3 specialists and 7 residents) with higher concordance rates was 0.524. Two validators (1 specialist and 1 resident) with the highest concordance rates had a Krippendorff's α of 0.648. Common disease names had higher concordance rates, while uncommon disease names showed lower concordance rates. These rates did not show correlation with clinical experience of the validator or time taken to devise the disease name. CONCLUSIONS: High reliability was not found among all validators; however, validators with higher concordance rates showed better reliability. Furthermore, common disease names had higher concordance rates. These findings indicate that the new DNS for prosthodontic dentistry exhibits clinically acceptable reliability and validity.

Japan Prosthodontic Society position paper on "occlusal discomfort syndrome".

PURPOSE: Dentists may encounter patients who present with a sense of a malocclusion but in whom no objective findings can be detected. For the patient who insists that there is occlusal discomfort, in the absence of evidence some dentists elect to perform an occlusal adjustment that not only fails to alleviate symptoms, and may, in fact, exacerbate the discomfort. The patient-dentist relationship is then likely compromised because of a lack of trust. STUDY SELECTION: In 2011, the Clinical Practice Guidelines Committee of the Japan Prosthodontic Society formulated guidelines for the management of occlusal discomfort. When formulating clinical practice guidelines, the committee bases their recommendations on information derived from scientific evidence. For "occlusal dysesthesia," however, there are an insufficient number of high-quality papers related to the subject. Therefore, a consensus meeting was convened by the Japan Prosthodontic Society to examine evidence in the Japanese- and English-language literature and generate a multi-center survey to create an appropriate appellation for this condition. RESULTS: As a result of the consensus meeting and survey findings, this condition may be justifiably termed "occlusal discomfort syndrome." CONCLUSIONS: The Japan Prosthodontics Society believes that identification of an umbrella term for occlusal discomfort might serve as a useful guide to formulating clinical practice guidelines in the future. This position paper represents summary findings in the literature combined with the results of a multicenter survey focused on dental occlusal treatment and the condition of patients who present with occlusal discomfort syndrome.

Clinical application of removable partial dentures using thermoplastic resin. Part II: Material properties and clinical features of non-metal clasp dentures.

This position paper reviews physical and mechanical properties of thermoplastic resin used for non-metal clasp dentures, and describes feature of each thermoplastic resin in clinical application of non-metal clasp dentures and complications based on clinical experience of expert panels. Since products of thermoplastic resin have great variability in physical and mechanical properties, clinicians should utilize them with careful consideration of the specific properties of each product. In general, thermoplastic resin has lower color-stability and higher risk for fracture than polymethyl methacrylate. Additionally, the surface of thermoplastic resin becomes roughened more easily than polymethyl methacrylate. Studies related to material properties of thermoplastic resin, treatment efficacy and follow-up are insufficient to provide definitive conclusions at this time. Therefore, this position paper should be revised based on future studies and a clinical guideline should be provided.

Clinical application of removable partial dentures using thermoplastic resin-part I: definition and indication of non-metal clasp dentures.

This position paper proposes a definition and naming standard for removable partial dentures (RPDs) using thermoplastic resin, and presents a guideline for clinical application. A panel of 14 experts having broad experience with clinical application of RPDs using thermoplastic resin was selected from members of the Japan Prosthodontic Society. At a meeting of the panel, "non-metal clasp denture" was referred as the generic name of RPDs with retentive elements (resin clasps) made of thermoplastic resin. The panel classified non-metal clasp dentures into two types: one with a flexible structure that lacks a metal framework and the other having a rigid structure that includes a metal framework. According to current prosthetic principles, flexible non-metal clasp dentures are not recommended as definitive dentures, except for limited cases such as patients with a metal allergy. Rigid non-metal clasp dentures are recommended in cases where patients will not accept metal clasps for esthetic reasons. Non-metal clasp dentures should follow the same design principles as conventional RPDs using metal clasps.

Oral health in the Japan self-defense forces - a representative survey.

BACKGROUND: The oral health of military populations is usually not very well characterized compared to civilian populations. The aim of this study was to investigate two physical oral health characteristics and one perceived oral health measure and their correlation in the Japan self-defense forces (JSDF). METHODS: Number of missing teeth, denture status, and OHRQoL as evaluated by the Japanese 14-item version of the Oral Health Impact Profile (OHIP-J14) as well as the correlation between these oral health measures was investigated in 911 personnel in the JSDF. RESULTS: Subjects did not have a substantial number of missing teeth and only 4% used removable dentures. The mean OHIP-J14 score was 4.6 ± 6.7 units. The magnitude of the correlation between the number of missing teeth with OHIP-J14 scores was small (r = 0.22, p < 0.001). Mean OHIP-J14 scores differed between subjects with and without dentures (8.6 and 4.4, p < 0.001). CONCLUSIONS: Compared to Japanese civilian populations, personnel of the JSDF demonstrated good oral health. Two physical oral health characteristics were associated with perceived oral health.

Enhancement of bone morphogenetic protein-2-induced ectopic bone formation by transforming growth factor-ß1.

Bone morphogenetic proteins (BMPs) possess osteoinductive activities and are useful for clinical treatments, including bone regeneration. We found that transforming growth factor (TGF)-ß1 strongly enhances the osteoinductive activity of BMP-2. Collagen sponges containing 5 µg of BMP-2 were implanted into mouse muscle tissues, after which lump-like masses appeared and grew until day 7. Subsequently, calcification occurred in the lump-like masses by day 14. Addition of 50 ng of TGF-ß1 to the BMP-2-containing sponges markedly accelerated the growth of the lump-like masses and resulted in a fivefold increase in total bone volume as compared with BMP-2 alone. The number of osteoblasts in ectopic bone tissues at 14 days after implantation induced by BMP-2+TGF-ß1 was twofold greater than that with BMP-2 alone, whereas the number of osteoclasts was decreased by half. On the other hand, TGF-ß1 accelerated the differentiation of both osteoblasts and osteoclasts in the early stage (2-7 days after implantation) of ectopic bone formation. We also implanted collagen sponges into bone defects surgically created in mouse calvaria. Sponges containing 2.5 µg of BMP-2 and 25 ng of TGF-ß1 caused complete filling of the defects with orthotopic bone, whereas those containing 2.5 µg of BMP-2 alone caused only partial filling. These results suggest that TGF-ß1 enhances BMP-2-induced ectopic bone formation by accelerating the growth of lump-like masses, and regulates osteoblast and osteoclast generation. Our findings may contribute to the development of a new treatment method for skeletal disorders.

[Establishment of simultaneous measurement method of 8 salivary components using urinary test paper and clinical evaluation of oral environment].

PURPOSE: Clinical findings were compared with glucose, protein, albumin, bilirubin, creatinine, pH, occult blood, ketone body, nitrite, and white blood cells contained in whole saliva to investigate the components that most markedly reflect the periodontal condition. MATERIAL AND METHOD: The subjects were staff of the Prosthodontics Department, Showa University, and patients who visited for dental treatments (57 subjects in total). At the first time, saliva samples were gargled with 1.5 ml of distilled water for 15 seconds and collected by spitting out into a paper cup. At the second time, saliva samples were collected by the same method. At the third time, saliva samples after chewing paraffin gum for 60 seconds were collected by spitting out into a paper cup. Thus whole saliva collecting that was divided on three times. After sampling, 8 mul of the saliva sample was dripped in reagent sticks for the 10 items of urinary test paper and the reflectance was measured using a specific reflectometer. In the periodontal tissue evaluation, the degree of alveolar bone resorption, probing value, and tooth mobility and the presence or absence of lesions in the root furcation were examined and classified into 4 ranks. The mean values in each periodontal disease rank and correlation between the periodontal disease ranks and the components were statistically analyzed. RESULTS: Bilirubin and ketone body were not measurable. The components density of the 8 items was increased as the periodontal disease rank increased. Regarding the correlation between the periodontal disease ranks and the components, high correlations were noted for protein, albumin, creatinine, pH, and white blood cells. CONCLUSION: The simultaneous measurement method of 8 salivary components using test paper may be very useful for the diagnosis of periodontal disease of abutment teeth.

Identification and characterization of the precursors committed to osteoclasts induced by TNF-related activation-induced cytokine/receptor activator of NF-kappa B ligand.

Osteoclasts are terminally differentiated from cells of monocyte/macrophage lineage by stimulation with TNF-related activation-induced cytokine (TRANCE) (receptor activator of NF-kappaB ligand/osteoprotegerin ligand/osteoclast differentiation factor/TNFSF11/CD254). In the present study, we attempted to determine when and how the cell fate of precursors becomes committed to osteoclasts following TRANCE stimulation. Although mouse bone marrow-derived macrophages (BMMs) were able to differentiate into either osteoclasts or dendritic cells, the cells no longer differentiated into dendritic cells after treatment with TRANCE for 24 h, indicating that their cell fate was committed to osteoclasts. Committed cells as well as BMMs were still quite weak in tartrate-resistant acid phosphatase activity, an osteoclast marker, and incorporated zymosan particles by phagocytosis. Interestingly, committed cells, but not BMMs, could still differentiate into osteoclasts even after incorporation of the zymosan particles. Furthermore, IL-4 and IFN-gamma, potent inhibitors of osteoclast differentiation, failed to inhibit osteoclast differentiation from committed cells, and blocking of TRANCE stimulation by osteoprotegerin resulted in cell death. Adhesion to culture plates was believed to be essential for osteoclast differentiation; however, committed cells, but not BMMs, differentiated into multinucleated osteoclasts without adhesion to culture plates. Although LPS activated the NF-kappaB-mediated pathway in BMMs as well as in committed cells, the mRNA expression level of TNF-alpha in the committed cells was significantly lower than that in BMMs. These results suggest that characteristics of the committed cells induced by TRANCE are distinctively different from that of BMMs and osteoclasts.

Strategies for training standardized patient instructors for a competency exam.

The Common Achievement Test (CAT) in Japan, which will be implemented in 2005, involves a medical interview that is the core task to be completed by students during an Objective Structured Clinical Examination (OSCE). Standardized/Simulated Patient instructors (SPs), posing as patients in medical interviews, are trained in standard fashion in terms of expression of symptoms as well as the emotional affect of actual patients. Institution of appropriate training programs for SP instructors in the CAT is also necessary. We trained seven individuals to function as standardized patients (in-school SPs) during a three-day SP training program described in this article. Following completion of the OSCE, we conducted a comparison study among evaluations completed by the evaluators and two types of SP instructors. We observed high correlation, according to Spearman significance testing, between scores of evaluators and those of both newly trained in-school SPs and veteran SPs who had more than five years of experience. Correlation coefficients between the veteran SPs (r=0.77) and the in-school SPs (r=0.73) were nearly identical. These results suggest that our training program for SP instructors is an effective protocol, particularly with respect to reliability and efficiency.