Development of a safer and improved analytical method for polycyclic aromatic hydrocarbons in creosote products.

Polycyclic aromatic hydrocarbons (PAHs) in creosote products used for wood preservation are regulated in Japan. Although the analytical method for this regulation has been stipulated by law, two main problems have been highlighted, namely the use of dichloromethane, a potential carcinogen, as a solvent and inadequate purification. Therefore, an analytical method to solve these problems was developed in this study. Actual creosote-treated wood samples were examined, and it was found that acetone could be used as an alternative solvent. Purification methods using centrifugation, silica gel cartridges, and strong anion exchange (SAX) cartridges were also developed. It was found that the SAX cartridges strongly retained PAHs, and an effective purification method was developed using this phenomenon, in which contaminants were removed by washing with diethyl ether/hexane (1/9 v/v), which could not be achieved with a silica gel cartridge. This strong retention was attributed to cation-π interactions. The analytical method developed in this study yielded good recoveries (81.4-113.0%) with low relative standard deviations (<6.8%), and the limit of quantification (0.02-0.29 µg/g) was significantly lower than the current creosote product regulation. Therefore, this method can safely and effectively extract and purify PAHs from creosote products.

[Examination of Analytical Method for Mothproofing Agents to Revise the Official Methods Based on "Act on the Control of Household Products Containing Harmful Substances"].

In Japan, the use of mothproofing agents [dieldrin and 4,6-dichloro-7-(2,4,5-trichlorophenoxy)-2-trifluoromethylbenzimidazole; DTTB] in textiles is regulated by the Act on the Control of Household Products Containing Harmful Substances. Since official analytical methods for these agents have been in place for approximately 40 years, we developed an improved method in a previous study. In the present study, we validated this method. Accordingly, six laboratories analyzed the sample prepared at 3 µg/g (1/10 of the regulation value) and 30 µg/g (the regulation value). The high accuracy of the results for these samples in almost all the cases (accuracy: 70-120%, repeatability: <10%, reproducibility: <15%), confirmed the validity of the method. In addition, we examined three samples that were distributed before the introduction of the regulation. The analysis results for these samples showed little variation between laboratiories, indicating that our method is also applicable to actual samples. Meanwhile, the quantitative value was clearly lower in one laboratory than in the others. We presumed that the enhanced effect of the sample matrix (matrix effect) on the internal standards in GC-MS analysis was the main cause for this trend. Therefore, we examined the analytical method using polyethylene glycol 300 (PEG) as an analyte protectant. As PEG minimized the GC-MS response difference between the standard solution and the matrix-containing solution, GC-MS analysis with PEG would be useful for matrix effect measurements in this method.

[Examination of Analytical Methods for Methanol, Trichloroethylene, and Tetrachloroethylene to Revise the Official Methods Based on the Act on the Control of Household Products Containing Harmful Substances].

In Japan, the use of methanol, trichloroethylene, and tetrachloroethylene in aerosol household products is banned under the Act on the Control of Household Products Containing Harmful Substances. As the official analytical methods for testing for these substances have not been revised for over 35 years, several issues have been pointed out. Thus, we developed a new method to revise the official method in our previous study. In this study, validation of the proposed method for detecting the target substances was conducted using two aerosol-product samples (A and B), which contained methanol, trichloroethylene, and tetrachloroethylene. Sample A comprised regulated values of these compounds, while sample B comprised one-tenth of the regulated amounts. They also contained several volatile compounds that served as interfering substances. Subsequently, the samples were analyzed using head space/gas chromatography-mass spectrometry, and it was confirmed that the three target substances were separated from the other chemicals on chromatograms. Validation tests were conducted at seven laboratories to evaluate the proposed method using the prepared samples. In one laboratory, the recovery of trichloroethylene and tetrachloroethylene in sample B was slightly higher at 120%, while the recoveries obtained from the other tests were between 70% and 120%. Relative standard deviation at each laboratory was less than 10%. Furthermore, the relative standard deviations between the validation tests with respect to each chemical were less than 15%. Therefore, the method validated in this study was considered to be effective as a revised method for testing for methanol, trichloroethylene, and trichloroethylene in household aerosol products.

[Analysis of Dieldrin and DTTB in Textiles].

Standard analytical methods for the detection of dieldrin and 4,6-dichloro-7-(2,4,5-trichlorophenoxy)-2-trifluoromethylbenzimidazole (DTTB) in textiles, which are regulated by Japanese law ("Act on the Control of Household Products Containing Harmful Substances"), have been in place for more than 30 years. In this study, we developed an improved analytical method, based on GC-MS, that uses safe reagents and can simultaneously detect dieldrin and DTTB analytes. In the standard (existing) analytical method, dimethyl sulfate, which is a potential carcinogen, is used to derivatize DTTB. In the developed method, phenyltrimethylammonium hydroxide, as an alternative reagent, was used to derivatize DTTB in good results. Dieldrin and the derivatized DTTBs gave highly linear calibration curves when analyzed by GC-MS. Moreover, we found that both analytes are adequately extracted from textiles by refluxing in hydrochloric acid and methanol. Furthermore, we established a purification method using the Bond Elut PRS column that effectively removed interfering substances in woolen products. Finally, we developed an improved analysis method by combining the above-mentioned techniques; the developed method exhibited a recovery rate of 94-104% and a relative standard deviation of less than 7% for both analytes. In addition, the limits of quantitation (dieldrin: 1.3 µg/g, DTTB: 0.72 µg/g) were sufficiently lower than the Japanese regulatory value of 30 µg/g.

Microbial Degradation of Amino Acid-Containing Compounds Using the Microcystin-Degrading Bacterial Strain B-9.

Strain B-9, which has a 99% similarity to Sphingosinicella microcystinivorans strain Y2, is a Gram-negative bacterium with potential for use in the degradation of microcystin-related compounds and nodularin. We attempted to extend the application area of strain B-9 and applied it to mycotoxins produced by fungi. Among the tested mycotoxins, only ochratoxin A was completely hydrolyzed to provide the constituents ochratoxin α and l-phenylalanine, and levels of fumonisin B1 gradually decreased after 96 h. However, although drugs including antibiotics released into the aquatic environment were applied for microbial degradation using strain B-9, no degradation occurred. These results suggest that strain B-9 can only degrade amino acid-containing compounds. As expected, the tested compounds with amide and ester bonds, such as 3,4-dimethyl hippuric acid and 4-benzyl aspartate, were readily hydrolyzed by strain B-9, although the sulfonamides remained unchanged. The ester compounds were characteristically and rapidly hydrolyzed as soon as they came into contact with strain B-9. Furthermore, the degradation of amide and ester compounds with amino acids was not inhibited by the addition of ethylenediaminetetraacetic acid (EDTA), indicating that the responsible enzyme was not MlrC. These results suggest that strain B-9 possesses an additional hydrolytic enzyme that should be designated as MlrE, as well as an esterase.

[Examination of analytical method for triphenyltin (TPT) and tributyltin (TBT) to revise the official methods based on "Act on the Control of Household Products Containing Harmful Substances"].

The use of triphenyltin (TPT) and tributyltin (TBT) in some household products is banned by "Act on the Control of Household Products Containing Harmful Substances" in Japan. To revise the official analytical method, the method for detecting these organotin compounds was examined in six laboratories using a textile product, water-based adhesive, oil-based paint, which contained known amounts of TPT and TBT (0.1, 1.0, 10 µg/g). TPT and TBT were measured by GC-MS after ethyl-derivation with sodium tetraethylborate. The TBT recoveries in the samples were 70-120%. The TPT recoveries in the water-based adhesive samples were 80-110%, while its concentrations in the textile product and oil-based paint samples decreased because of dephenylation during storage. However, the precision of the method examined was satisfactory because most coefficients of variation for TPT and TBT in the samples were less than 10%. Furthermore, the revised method was able to detect concentrations lower than the officially regulated value. However, the sample matrix and the condition of analytical instrument might affect the estimated TPT and TBT concentrations. Therefore, the revised method may not be suitable for quantitative tests; rather, it can be employed to judge the acceptable levels of these organotin compounds by comparing the values of control sample containing regulated amounts of TPT and TBT with those for an unknown sample, with deuterated TPT and TBT as surrogate substances. It is desirable that TPT in textile and oil-based paint samples are analyzed immediately after the samples obtained because of the decomposition of TPT.

Crossover behavior in static and dynamic properties of a single DNA molecule from three to quasi-two dimensions.

We studied the conformation and dynamics of a single DNA molecule in a thin slit by a fluorescent microscope. In a slit thinner than the Flory radius in three dimensions, the length of the major axis, the translational self-diffusion coefficient and the rotational relaxation time in a dilute solution show the apparent dependence on the thickness of the slit. The observed dependence is in agreement with that predicted by blob theory, despite the number of blobs is very small. The radial distribution of the segments around the center of mass of a single molecule was also studied and compared with that calculated for a Gaussian and an excluded volume chain. The influence of the polymer concentration on the geometrical confinement by slits was also studied in a semidilute solution near the overlap concentration c∗. The confinement effect is found to be not so serious near c∗ and is only significant in the so-called "two-dimensional pancake" region.