RESUMO
OBJECTIVE: To evaluate the effect of different desensitizing toothpastes and coffee staining on the discoloration rate of natural human tooth and composite materials. MATERIALS AND METHODS: A total of 56 human teeth and 56 composite specimens were used. After initial color measurements were taken, specimens and teeth were exposed to simulated toothbrushing with six desensitizing toothpastes containing different active ingredients: stannous fluoride, strontium acetate, potassium citrate and hydroxyapatite, cetylpyridinium chloride, arginine, and novamin. Specimens were then exposed to coffee staining. Throughout the staining procedure, the storing solution was refreshed every day and the specimens were brushed with the tested toothpastes. Color measurements and changes were recorded at each stage and analyzed with one-way ANOVA, Dunnett tests, and paired sample t-test (p<0.05). RESULTS: The largest color change was obtained with the stannous fluoride toothpaste after coffee staining for natural teeth (2.6 ΔE 00 â) and composite specimens (3.1 ΔE 00 â). Coffee staining resulted in significant changes for ΔE 00 â values of all groups, except for natural teeth brushed with a novamin-based (p= 0.06) toothpaste. For composite specimens, only the stannous fluoride and cetylpyridinium chloride-based toothpastes resulted in significant color changes relative to the control group. ΔLâ and Δbâ values were also increased after staining for all groups (p<0.05). CONCLUSIONS: Desensitizing toothpastes alone did not cause perceptible color changes; however, in combination with coffee staining, it tended to increased discoloration for both composites and natural teeth.
Assuntos
Café , Pigmentação/efeitos dos fármacos , Dente , Escovação Dentária , Cremes Dentais/farmacologia , HumanosRESUMO
PURPOSE: The purpose of this study was to evaluate whether surface treatments affect the translucency of laminate veneers with different shades and thicknesses. MATERIALS AND METHODS: A total of 224 disc-shaped ceramic veneers were prepared from A1, A3, HT (High Translucent) and HO (High Opaque) shades of IPS e.max Press (Ivoclar Vivadent) with 0.5 mm and 1.0 mm thicknesses. The ceramics were divided into four groups for surface treatments. Group C: no surface treatments; Group HF: etched with hydrofluoric acid; Group SB: sandblasted with 30-µm Al2O3 [corrected]; and Group L; irradiated with an Er;YAG laser. A translucent shade of resin cement (Rely X Veneer, 3M ESPE) was chosen for cementation. The color values of the veneers were measured with a colorimeter and translucency parameter (TP) values were calculated. A three-way ANOVA with interactions for TP values was performed and Bonferroni tests were used when appropriate (α=0.05). RESULTS: There were significant interactions between the surface treatments, ceramic shades and thicknesses (P=.001). For the 0.5-mm-thick specimens there were significant differences after the SB and L treatments. There was no significant difference between the HF and C treatments for any shades or thicknesses (P>.05). For the 1-mm-thick ceramics, there was only a significant difference between the L and C treatments for the HT shade ceramics (P=.01). There were also significant differences between the SB and C treatments except not for the HO shades (P=.768). CONCLUSION: The SB and L treatments caused laminate veneers to become more opaque; however, HF treatment did not affect the TP values. When the laminate veneers were thinner, both the shade of the ceramic and the SB and laser treatments had a greater effect on the TP values.
RESUMO
PURPOSE: Oral rinses are widely used to promote periodontal health with provisional restorations during the interim period. The aim of this study was to compare the discoloration of provisional restoration materials with different oral rinses. MATERIAL AND METHODS: A total of 140 disc-shaped specimens (shade A2) (10 mm x 2 mm) were prepared from one PMMA-based (TemDent Classic(®)) and three different bis-acrylic-based (Protemp II(®), Luxatemp(®) and Fill-In(®)) provisional restoration materials (n=7). The color values (L*, a*, and b*) of each specimen were measured before and after exposure with a colorimeter, and the color changes (∆E) were calculated according to the CIE L*a*b* system. The specimens were immersed in each of the 4 oral rinses (alcohol-containing mouthwash, chlorhexidine, benzydamine HCl, benzydamine HCl and chlorhexidine) twice a day for 2 minutes. After 2 minutes of immersion in the oral rinses, the specimens were immersed in artificial saliva. The specimens were exposed to the oral rinses and the artificial saliva for 3 weeks. Two-way ANOVA, the Bonferroni test and the paired sample t-test were used for statistical analyses (p<0.05). RESULTS: Comparison of the discoloration from the oral rinses after immersion for three weeks revealed no significant differences (p>0.05). The lowest color change was observed in PMMA-based Temdent in all oral rinses (p<0.05). There were no significant differences between the bis-acryl composites after immersion in saliva or the mixture of benzydamine HCl and chlorhexidine and the alcohol-containing mouthwash for 3 weeks (p>0.05). After immersion in chlorhexidine, the color change values of Protemp II and Fill-in showed significant differences (p=0.018). Protemp II also showed less discoloration than the other bis-acryl composites, and this color change was statistically significant (p <0.05). For all oral rinses, the L* value decreased while b* values increased, and this color change was found to be statistically significant (p <0.05). A* values were found to be significantly higher with oral rinses (p<0.05), except Protemp II immersed in benzydamine HCl or alcohol-containing mouthwash. CONCLUSIONS: The type of the oral rinse did not affect the discoloration process. For long-term esthetic results, choosing MMA-based materials for provisional restorations appears to be more effective.
Assuntos
Antissépticos Bucais/química , Benzidamina/química , Clorexidina/química , Humanos , Saliva/químicaRESUMO
INTRODUCTION: In attempting to provide a solution for cases that have been compromised by malpositioned anterior teeth, clinicians traditionally decide orthodontic approach. Nevertheless, in some cases changes in tooth morphology, tooth size, and shape is compulsory for optimal aesthetics. The advent in contemporary aesthetic materials and preparation techniques empowered the clinicians to deliver a promising result with minimal biologic cost. This article presents the clinical considerations that must be addressed when providing a prosthetic restoration for crowded teeth. CASE PRESENTATION: A 23 years old Turkish female patient who had malaligned anterior teeth was rehabilitated with ceramic veneers due to her rejection of orthodontic treatment. The paper describes ceramic veneers can be an alternative treatment to orthodontic therapy under variety of preparation forms when patient has anterior malalignment and rejects the orthodontic treatment. CONCLUSION: The new smile line was satisfactory for the patient and the esthetics was considered as excellent.