Pyrolysis Pathways of the Furanic Ether 2-Methoxyfuran.

Substituted furans, including furanic ethers, derived from nonedible biomass have been proposed as second-generation biofuels. In order to use these molecules as fuels, it is important to understand how they break apart thermally. In this work, a series of experiments were conducted to study the unimolecular and low-pressure bimolecular decomposition mechanisms of the smallest furanic ether, 2-methoxyfuran. Electronic structure (CBS-QB3) calculations indicate this substituted furan has an unusually weak O-CH3 bond, approximately 190 kJ mol(-1) (45 kcal mol(-1)); thus, the primary decomposition pathway is through bond scission resulting in CH3 and 2-furanyloxy (O-C4H3O) radicals. Final products from the ring opening of the furanyloxy radical include 2 CO, HC≡CH, and H. The decomposition of methoxyfuran is studied over a range of concentrations (0.0025-0.1%) in helium or argon in a heated silicon carbide (SiC) microtubular flow reactor (0.66-1 mm i.d., 2.5-3.5 cm long) with reactor wall temperatures from 300 to 1300 K. Inlet pressures to the reactor are 150-1500 Torr, and the gas mixture emerges as a skimmed molecular beam at a pressure of approximately 10 µTorr. Products formed at early pyrolysis times (100 µs) are detected by 118.2 nm (10.487 eV) photoionization mass spectrometry (PIMS), tunable synchrotron VUV PIMS, and matrix infrared absorption spectroscopy. Secondary products resulting from H or CH3 addition to the parent and reaction with 2-furanyloxy were also observed and include CH2═CH-CHO, CH3-CH═CH-CHO, CH3-CO-CH═CH2, and furanones; under the conditions in the reactor, we estimate these reactions contribute to at most 1-3% of total methoxyfuran decomposition. This work also includes observation and characterization of an allylic lactone radical, 2-furanyloxy (O-C4H3O), with the assignment of several intense vibrational bands in an Ar matrix, an estimate of the ionization threshold, and photoionization efficiency. A pressure-dependent kinetic mechanism is also developed to model the decomposition behavior of methoxyfuran and provide pathways for the minor bimolecular reaction channels that are observed experimentally.

Pyrolysis Reactions of 3-Oxetanone.

The pyrolysis products of gas-phase 3-oxetanone were identified via matrix-isolation Fourier transform infrared spectroscopy and photoionization mass spectrometry. Pyrolysis was conducted in a hyperthermal nozzle at temperatures from 100 to 1200 °C with the dissociation onset observed at ∼600 °C. The ring strain in the cyclic structure of 3-oxetanone causes the molecule to decompose at relatively low temperatures. Previously, only one dissociation channel, producing formaldehyde and ketene, was considered as significant in photolysis. This study presents the first experimental measurements of the thermal decomposition of 3-oxetanone demonstrating an additional dissociation channel that forms ethylene oxide and carbon monoxide. Major products include formaldehyde, ketene, carbon monoxide, ethylene oxide, ethylene, and methyl radical. The first four products stem from initial decomposition of 3-oxetanone, while the additional products, ethylene and methyl radical, are believed to be due to further reactions involving ethylene oxide.

Pyrolysis of furan in a microreactor.

A silicon carbide microtubular reactor has been used to measure branching ratios in the thermal decomposition of furan, C4H4O. The pyrolysis experiments are carried out by passing a dilute mixture of furan (approximately 0.01%) entrained in a stream of helium through the heated reactor. The SiC reactor (0.66 mm i.d., 2 mm o.d., 2.5 cm long) operates with continuous flow. Experiments were performed with a reactor inlet pressure of 100-300 Torr and a wall temperature between 1200 and 1600 K; characteristic residence times in the reactor are 60-150 µs. The unimolecular decomposition pathway of furan is confirmed to be: furan (+ M) ⇌ α-carbene or ß-carbene. The α-carbene fragments to CH2=C=O + HC≡CH while the ß-carbene isomerizes to CH2=C=CHCHO. The formyl allene can isomerize to CO + CH3C≡CH or it can fragment to H + CO + HCCCH2. Tunable synchrotron radiation photoionization mass spectrometry is used to monitor the products and to measure the branching ratio of the two carbenes as well as the ratio of [HCCCH2]/[CH3C≡CH]. The results of these pyrolysis experiments demonstrate a preference for 80%-90% of furan decomposition to occur via the ß-carbene. For reactor temperatures of 1200-1400 K, no propargyl radicals are formed. As the temperature rises to 1500-1600 K, at most 10% of the decomposition of CH2=C=CHCHO produces H + CO + HCCCH2 radicals. Thermodynamic conditions in the reactor have been modeled by computational fluid dynamics and the experimental results are compared to the predictions of three furan pyrolysis mechanisms. Uncertainty in the pressure-dependency of the initiation reaction rates is a possible a source of discrepancy between experimental results and theoretical predictions.

Biomass pyrolysis: thermal decomposition mechanisms of furfural and benzaldehyde.

The thermal decompositions of furfural and benzaldehyde have been studied in a heated microtubular flow reactor. The pyrolysis experiments were carried out by passing a dilute mixture of the aromatic aldehydes (roughly 0.1%-1%) entrained in a stream of buffer gas (either He or Ar) through a pulsed, heated SiC reactor that is 2-3 cm long and 1 mm in diameter. Typical pressures in the reactor are 75-150 Torr with the SiC tube wall temperature in the range of 1200-1800 K. Characteristic residence times in the reactor are 100-200 µsec after which the gas mixture emerges as a skimmed molecular beam at a pressure of approximately 10 µTorr. Products were detected using matrix infrared absorption spectroscopy, 118.2 nm (10.487 eV) photoionization mass spectroscopy and resonance enhanced multiphoton ionization. The initial steps in the thermal decomposition of furfural and benzaldehyde have been identified. Furfural undergoes unimolecular decomposition to furan + CO: C4H3O-CHO (+ M) → CO + C4H4O. Sequential decomposition of furan leads to the production of HC≡CH, CH2CO, CH3C≡CH, CO, HCCCH2, and H atoms. In contrast, benzaldehyde resists decomposition until higher temperatures when it fragments to phenyl radical plus H atoms and CO: C6H5CHO (+ M) → C6H5CO + H → C6H5 + CO + H. The H atoms trigger a chain reaction by attacking C6H5CHO: H + C6H5CHO → [C6H6CHO]* → C6H6 + CO + H. The net result is the decomposition of benzaldehyde to produce benzene and CO.

Thermal decomposition of CH3CHO studied by matrix infrared spectroscopy and photoionization mass spectroscopy.

A heated SiC microtubular reactor has been used to decompose acetaldehyde and its isotopomers (CH(3)CDO, CD(3)CHO, and CD(3)CDO). The pyrolysis experiments are carried out by passing a dilute mixture of acetaldehyde (roughly 0.1%-1%) entrained in a stream of a buffer gas (either He or Ar) through a heated SiC reactor that is 2-3 cm long and 1 mm in diameter. Typical pressures in the reactor are 50-200 Torr with the SiC tube wall temperature in the range 1200-1900 K. Characteristic residence times in the reactor are 50-200 µs after which the gas mixture emerges as a skimmed molecular beam at a pressure of approximately 10 µTorr. The reactor has been modified so that both pulsed and continuous modes can be studied, and results from both flow regimes are presented. Using various detection methods (Fourier transform infrared spectroscopy and both fixed wavelength and tunable synchrotron radiation photoionization mass spectrometry), a number of products formed at early pyrolysis times (roughly 100-200 µs) are identified: H, H(2), CH(3), CO, CH(2)=CHOH, HC≡CH, H(2)O, and CH(2)=C=O; trace quantities of other species are also observed in some of the experiments. Pyrolysis of rare isotopomers of acetaldehyde produces characteristic isotopic signatures in the reaction products, which offers insight into reaction mechanisms that occur in the reactor. In particular, while the principal unimolecular processes appear to be radical decomposition CH(3)CHO (+M) → CH(3) + H + CO and isomerization of acetaldehyde to vinyl alcohol, it appears that the CH(2)CO and HCCH are formed (perhaps exclusively) by bimolecular reactions, especially those involving hydrogen atom attacks.