RESUMO
Purpose: Formulation viscosity and patient-specific parameters such as age are important considerations in achieving patient comfort for prolonged anterior segment surgical procedures. In this study, we report pharmacodynamic and pharmacokinetic parameters of topical 2% lidocaine anesthetic decay based on formulation viscosity and subject age. Methods: Extemporaneous 2% lidocaine solution was compounded with varying percentages of carboxymethylcellulose (CMC) to adjust product viscosity. Juvenile and adult New Zealand White rabbits were utilized as a model for lidocaine-induced corneal anesthesia analysis. Following application of 20 µL in 1 eye of each animal, corneal sensitivity was measured using a Cochet-Bonnet esthesiometer at baseline and at 1-min intervals until recovery to baseline. Subsequent to washout period, the experiment was repeated for 3 replicate experiments. Results: A one-phase exponential decay model was utilized to describe rate of anesthesia decay. Bioavailability increased in a manner disproportionate to both tear film concentration and solution viscosity. In adult animals, half-life of anesthetic decay was found to range from 6.03 min with 2% lidocaine in 0.5% CMC to 9.45 min with 2% lidocaine in 1.5% CMC. In juveniles, half-life was found to be 4.46 and 3.58 min for 2% lidocaine in 1.5% CMC and commercial 2% lidocaine gel, respectively. Conclusions: Decay parameters of lidocaine-induced corneal anesthesia appear disparate from viscosity. It is postulated that viscosity-related increase in corneal contact time through reduced drainage plays a critical role in increasing bioavailability of topical anesthetics in our experimental findings, although nonlinear in character. Age is found to be an important mediator of lidocaine-induced corneal anesthesia.
Assuntos
Anestesia , Lidocaína , Animais , Coelhos , Lidocaína/farmacologiaRESUMO
Femtosecond laser desorption ionization mass spectrometry was used to obtain mass spectrometric (MS) images of lipids in human pancreatic tissue. The resulting MS images were analyzed using multivariate analysis, specifically principal component analysis and maximum a posteriori (MAP) reconstruction. Both analysis methods showed that the MS images can be separated into lipid and non-lipid areas. MAP analysis further indicated that the lipid areas are composed of phosphatidylcholines and fatty acids. However, definitive identification of the lipids cannot be made because none of the intact parent ions of phosphatidylcholine, sphingomyelins, and/or other lipids were observed. The MAP analysis also revealed that the non-lipid areas could be separated into components that are due to the sample chemical treatment and topography.
Assuntos
Ácidos Graxos/análise , Espectrometria de Massas/métodos , Pâncreas/química , Fosfatidilcolinas/análise , Humanos , Análise MultivariadaRESUMO
A hand-held diode laser is implemented for solid sampling in portable ambient mass spectrometry (MS). Specifically, a pseudocontinuous wave battery-powered surgical laser diode is employed for portable laser diode thermal desorption (LDTD) at 940 nm and compared with nanosecond pulsed laser ablation at 2940 nm. Postionization is achieved in both cases using atmospheric pressure photoionization (APPI). The laser ablation atmospheric pressure photoionization (LAAPPI) and LDTD-APPI mass spectra of sage leaves (Salvia officinalis) using a field-deployable quadrupole ion trap MS display many similar ion peaks, as do the mass spectra of membrane grown biofilms of Pseudomonas aeruginosa. These results indicate that LDTD-APPI method should be useful for in-field sampling of plant and microbial communities, for example, by portable ambient MS. The feasibility of many portable MS applications is facilitated by the availability of relatively low cost, portable, battery-powered diode lasers. LDTD could also be coupled with plasma- or electrospray-based ionization for the analysis of a variety of solid samples.
Assuntos
Biofilmes , Lasers , Pseudomonas aeruginosa/metabolismo , Salvia officinalis/química , Pressão Atmosférica , Espectrometria de Massas , Processos Fotoquímicos , Folhas de Planta/químicaRESUMO
Ultrashort pulse length lasers operating in the near-infrared region show promise for submicrometer lateral resolution by laser desorption-based mass spectrometry (MS) imaging. However, these experiments must balance lateral resolution and molecular fragmentation since abundant atomic ions are observed at the high laser irradiances that can be generated by tightly focused ultrashort pulse laser beams. It is shown here that combining ultrashort pulse laser desorption with laser postionization (fs-LDPI) allows for a considerable increase of molecular ion signal while operating with lower laser irradiances, yielding the added benefit of reduced molecular fragmentation. This Letter presents several experimental results in support of the fs-LDPI approach for MS imaging. First, the lateral resolution for MS imaging of molecular species desorbed by â¼75 fs, 800 nm laser pulses was determined to be <2 µm for a simulated organic electronic device under vacuum. Next, the dependence of precursor ion survival on both desorption laser fluence and delay between desorption and photoionization laser pulses was observed for a small molecule desorbed from an organic multilayer that was originally devised as a model of a bacterial biofilm. When considered in light of recent results in the literature (Milasinovic et al. J. Phys. Chem. C 2014, DOI: 10.1021/jp504062u), these experiments demonstrate the potential for submicrometer spatial resolution MS imaging by fs-LDPI.
Assuntos
Clorobenzoatos/análise , Lasers , Imagem Molecular , Naftacenos/análise , Espectrometria de Massas por Ionização e Dessorção a Laser Assistida por Matriz/métodos , Íons , Naftacenos/química , Silício/química , VácuoRESUMO
In materials science and engineering it is often necessary to obtain quantitative measurements of surface topography with micrometer lateral resolution. From the measured surface, 3D topographic maps can be subsequently analyzed using a variety of software packages to extract the information that is needed. In this article we describe how white light interferometry, and optical profilometry (OP) in general, combined with generic surface analysis software, can be used for materials science and engineering tasks. In this article, a number of applications of white light interferometry for investigation of surface modifications in mass spectrometry, and wear phenomena in tribology and lubrication are demonstrated. We characterize the products of the interaction of semiconductors and metals with energetic ions (sputtering), and laser irradiation (ablation), as well as ex situ measurements of wear of tribological test specimens. Specifically, we will discuss: i. Aspects of traditional ion sputtering-based mass spectrometry such as sputtering rates/yields measurements on Si and Cu and subsequent time-to-depth conversion. ii. Results of quantitative characterization of the interaction of femtosecond laser irradiation with a semiconductor surface. These results are important for applications such as ablation mass spectrometry, where the quantities of evaporated material can be studied and controlled via pulse duration and energy per pulse. Thus, by determining the crater geometry one can define depth and lateral resolution versus experimental setup conditions. iii. Measurements of surface roughness parameters in two dimensions, and quantitative measurements of the surface wear that occur as a result of friction and wear tests. Some inherent drawbacks, possible artifacts, and uncertainty assessments of the white light interferometry approach will be discussed and explained.
Assuntos
Interferometria/métodos , Terapia a Laser/métodos , Teste de Materiais/métodos , Software , Propriedades de SuperfícieRESUMO
RATIONALE: Although the fundamental physical limits for depth resolution of secondary ion mass spectrometry are well understood in theory, the experimental work to achieve and demonstrate them is still ongoing. We report results of high-resolution TOF SIMS (time-of-flight secondary ion mass spectrometry) depth profiling experiments on a nanolayered structure, a stack of 16 alternating MgO and ZnO ~5.5 nm layers grown on a Si substrate by atomic layer deposition. METHODS: The measurements were performed using a newly developed approach implementing a low-energy direct current normally incident Ar(+) ion beam for ion milling (250 eV and 500 eV energy), in combination with a pulsed 5 keV Ar(+) ion beam at 60° incidence for TOF SIMS analysis. By this optimized arrangement, a noticeably improved version of the dual-beam (DB) approach to TOF SIMS depth profiling is introduced, which can be dubbed gentleDB. RESULTS: The mixing-roughness-information model was applied to detailed analysis of experimental results. It revealed that the gentleDB approach allows ultimate depth resolution by confining the ion beam mixing length to about two monolayers. This corresponds to the escape depth of secondary ions, the fundamental depth resolution limitation in SIMS. Other parameters deduced from the measured depth profiles indicated that a single layer thickness is equal to 6 nm so that the 'flat' layer thickness d is 3 nm and the interfacial roughness σ is 1.5 nm, thus yielding d + 2σ = 6 nm. CONCLUSIONS: We have demonstrated that gentleDB TOF SIMS depth profiling with noble gas ion beams is capable of revealing the structural features of a stack of nanolayers, resolving its original surface and estimating the roughness of interlayer interfaces, information which is difficult to obtain by traditional approaches.
RESUMO
There are four generally mutually exclusive requirements that plague many mass spectrometric measurements of trace constituents: (1) the small size (limited by the depth probed) of many interesting materials requires high useful yields to simply detect some trace elements, (2) the low concentrations of interesting elements require efficient discrimination from isobaric interferences, (3) it is often necessary to measure the depth distribution of elements with high surface and low bulk contributions, and (4) many applications require precise isotopic analysis. Resonant ionization mass spectrometry has made dramatic progress in addressing these difficulties over the past five years.
RESUMO
Laser-induced acoustic desorption (LIAD) from thin metal foils is a promising technique for gentle and efficient volatilization of intact organic molecules from surfaces of solid substrates. Using the single-photon ionization method combined with time-of-flight mass spectrometry, we have examined the neutral component of the desorbed flux in LIAD and compared it to that from direct laser desorption. These basic studies of LIAD, conducted for molecules of various organic dyes (rhodamine B, fluorescein, anthracene, coumarin, BBQ), have demonstrated detection of intact parent molecules of the analyte even at its surface concentrations corresponding to a submonolayer coating. In some cases (rhodamine B, fluorescein, BBQ), the parent molecular ion peak was accompanied by a few fragmentation peaks of comparable intensity, whereas for others, only peaks corresponding to intact parent molecules were detected. At all measured desorbing laser intensities (from 100 to 500 MW/cm2), the total amount of desorbed parent molecules depended exponentially on the laser intensity. Translational velocities of the desorbed intact molecules, determined for the first time in this work, were of the order of hundreds of meters per second, less than what has been observed in our experiments for direct laser desorption, but substantially greater than the possible perpendicular velocity of the substrate foil surface due to laser-generated acoustic waves. Moreover, these velocities did not depend on the desorbing laser intensity, which implies the presence of a more sophisticated mechanism of energy transfer than direct mechanical or thermal coupling between the laser pulse and the adsorbed molecules. Also, the total flux of desorbed intact molecules as a function of the total number of desorbing laser pulses, striking the same point on the target, decayed following a power law rather than an exponential function, as would have been predicted by the shake-off model. To summarize, the results of our experiments indicate that the LIAD phenomenon cannot be described in terms of simple mechanical shake-off or direct laser desorption. Rather, they suggest that multistep energy-transfer processes are involved. Two possible (and not mutually exclusive) qualitative mechanisms of LIAD that are based on formation of nonequilibrium energy states in the adsorbate-substrate system are proposed and discussed.
Assuntos
Corantes Fluorescentes/análise , Corantes Fluorescentes/efeitos da radiação , Lasers , Metais/química , Metais/efeitos da radiação , Antracenos/análise , Antracenos/efeitos da radiação , Cumarínicos/análise , Cumarínicos/efeitos da radiação , Fluoresceína/análise , Fluoresceína/efeitos da radiação , Estrutura Molecular , Fótons , Reprodutibilidade dos Testes , Rodaminas/análise , Rodaminas/efeitos da radiação , Sensibilidade e Especificidade , Propriedades de Superfície , Espectrometria de Massas em Tandem/métodos , VolatilizaçãoRESUMO
A novel analytical method based on laser desorption postionization mass spectrometry (LDPI-MS) was developed to investigate the competence and sporulation factor-a pentapeptide of amino acid sequence ERGMT-within intact Bacillus subtilis biofilms. Derivatization of the neat ERGMT peptide with quinoline- and anthracene-based tags was separately used to lower the peptide ionization potential and permit direct ionization by 7.87-eV vacuum ultraviolet radiation. The techniques of mass shifting and selective ionization of the derivatized peptide were combined here to permit detection of ERGMT peptide within intact biofilms by LDPI-MS, without any prior extraction or chromatographic separation. Finally, imaging MS specific to the derivatized peptide was demonstrated on an intact biofilm using LDPI-MS. The presence of ERGMT in the biofilms was verified by bulk extraction/LC-MS. However, MALDI imaging MS analyses were unable to detect ERGMT within intact biofilms.
Assuntos
Bacillus subtilis/fisiologia , Biofilmes , Peptídeos/análise , Percepção de Quorum , Espectrometria de Massas por Ionização e Dessorção a Laser Assistida por Matriz/métodos , Sequência de AminoácidosRESUMO
Experiments demonstrate that peptides with ionization potentials (IPs) above 7.87 eV can be single-photon-ionized in the gas phase with a molecular fluorine laser following prior chemical derivatization with one of several aromatic tags acting as chromophores. 4-(Dimethylamino)benzoic acid, 1-naphthylacetic acid, and 9-anthracenecarboxylic acid (denoted Benz, Naph and Anth, respectively) behave as chromophores, allowing single-photon ionization for vacuum ultraviolet (VUV) laser light by lowering the IP of the tagged peptide. Anth-tagged peptides that are laser-desorbed from a substrate and subsequently postionized produce mass spectra dominated by the intact radical cation, although protonated ions and fragmented species are also observed. Electronic structure calculations on Anth-tagged peptides indicate that in addition to lowering the ionization potential, the presence of the aromatic tag increases charge localization on and delocalization across the ring structure, which presumably stabilizes the radical cation. Measurements on several tagged peptides confirm this calculation and show that the stabilizing effect of the tag increases with the size of the conjugated system in the order Benz < Naph < Anth. The tagged hexapeptide Anth-GAPKSC exhibits the parent ion, whereas the Benz- and Naph-tagged peptides do not. These results are supported by the experimental comparison of Anth-tagged vs untagged tryptophan, further suggesting that VUV postionization of tagged high-IP species is a promising method for expanding the capabilities of mass spectrometric analyses of molecular species.