Elderly unilateral transtibial amputee gait on an inclined walkway: a biomechanical analysis.

The greatest population of amputees in developed nations are elderly dysvascular transtibial amputees. Conventional prostheses, e.g. the solid ankle cushioned heel (SACH) foot, create difficulties in walking on inclines. The aim of this study was to analyse the gait characteristics of elderly amputees walking on an incline, through quantitative three-dimensional biomechanical analysis, by comparing them to age-matched controls. Participants walked up and down an inclined (5 degrees) instrumented walkway at a self-selected pace. A Vicon System 370 was used to acquire gait data, including temporo-spatial characteristics, ground reaction forces (GRF), electromyography (EMG), kinematics, and kinetics of the lower limb. Compared to the age-matched controls, the amputees demonstrated reduced speed, knee and hip range of motion, hip moments, vertical GRF, along with increased amplitude and periods of muscle activation. The residual limb also had shorter single support stance phase, small stance phase knee moments, and the smallest moments and powers. These differences demonstrate instability in stance of the residual limb. The sources of this instability include the prosthesis' limited range of ankle motion and ankle power generation, coupled with the residual limb's limited proprioception and tolerance of force. For these amputees to regain a gait pattern equivalent to their able-bodied counterparts on inclined walkways, they must be equipped with a prosthesis that has a full range of ankle motion and active power generation at the ankle. Prosthesis design and rehabilitation training should also improve the proprioception of their residual limb and increase their tolerance of force through the residual limb.

Gait dynamics on an inclined walkway.

OBJECTIVE: This paper documents research that quantifies and describes the biomechanics of normal gait on inclined surfaces. DESIGN: Experimental, investigative. BACKGROUND: It is necessary to walk on inclined surfaces to negotiate the natural and built environments. Little research has been conducted on the biomechanics of normal gait on inclined surfaces. METHODS: The gait of 11 healthy male volunteers was measured using a Vicon system 370 on an inclinable walkway. Gait was measured at 0 degrees , 5 degrees , 8 degrees and 10 degrees of incline. Passive optical markers were placed on each subject and they walked at a self-selected speed up and down the walkway. Ground reaction forces and EMG were measured. Gait data were analysed in Vicon Clinical Manager. RESULTS: Changes in the dynamics of the lower limbs with respect to incline angles are described. Between subject and between condition differences in biomechanical parameters were significant. Hip flexion increased at heel strike with inclines from -10 degrees to +10 degrees . Knee flexion and ankle dorsiflexion at heel strike increased with increasing angle walking up, but not down. Changes in joint moments and powers due to change in the angle of incline or direction of walking were observed. CONCLUSIONS: The mechanisms by which the body enables walking up and downhill, specifically raising and lowering the centre of mass, and preventing slipping, can be seen in the alteration in the dynamics of the lower limbs. Increases in range of motion and muscle strength requirements need to be considered in the design of lower limb prostheses and in orthopaedic and neurological rehabilitation. RELEVANCE: Gait, prosthetics, rehabilitation, balance and falls.