RESUMO
The use of electrospun polymeric biodegradable materials for medical applications is becoming increasingly widespread. One of the most important parameters regarding the functionality of nanofiber scaffolds during implantation and the subsequent regeneration of damaged tissues concerns their stability and degradation behavior, both of which are influenced by a wide range of factors (the properties of the polymer and the polymer solution, the technological processing approach, the sterilization method, etc.). This study monitored the degradation of nanofibrous materials fabricated from degradable polyesters as a result of the sterilization method applied (ethylene oxide and gamma irradiation) and the solvent system used to prepare the spun polymer solution. Aliphatic polyesters PCL and PLCL were chosen for this study and selected with respect to the applicability and handling in the surgical setting of these nanofibrous materials for vascular bandaging. The results revealed that the choice of solvent system exerts a significant impact on degradation during sterilization, especially at higher gamma irradiation values. The subsequent enzyme-catalyzed degradation of the materials following sterilization indicated that the choice of the sterilization method influenced the degradation behavior of the materials. Whereas wave-like degradation was evident concerning ethylene oxide sterilization, no such behavior was observed following gamma-irradiation sterilization. With concern for some of the tested materials, the results also indicated the potential for influencing the development of degradation within the bulk versus degradation from the surface of the material. Both the sterilization method and the choice of the spinning solvent system were found to impact degradation, which was observed to be most accelerated in the case of PLCL (L-lactide-co-caprolactone copolymer) electrospun from organic acids and subsequently sterilized using gamma irradiation. Since we planned to use these materials in cardiovascular applications, it was decided that their hemocompatibility would also be tested. The results of these tests revealed that changes in the structures of the materials initiated by sterilization may exert thrombogenic and anticoagulant impacts. Moreover, the microscopic analysis suggested that the solvent system used in the preparation of the materials potentially affects the behavior of erythrocytes; however, no indication of the occurrence of hemolysis was detected.
RESUMO
Hexachlorocyclohexanes (HCH) belong to the banned pesticides with short-time production and use during the last century. However, the consequences of this short period are still present as persistent environmental contamination. This study represents the large lab-scale experiment focused on the HCH accumulation and metabolism in selected wetland plants (Juncus effuses, Typha latifolia, Phragmites australis) and trees (Alnus glutinosa) after the exposure to the technical mix of HCH isomers (t-HCH) or δ-HCH at three different concentration. During the three-month exposure, morphological (biomass, height, relative chlorophyll content) and physiological (photosynthetic measurements - photosynthetic rate, stomatal conductance, transpiration and dark transpiration) parameters were measured to assess the HCH effect on plant's growth. The results showed that all selected plant species supported HCH removal from the soil. The total removal efficiency was lower for the t-HCH than for δ-HCH exposure, and the best results were provided by Alnus glutinosa tree. Also, no isomer preference was observed in plants exposed to t-HCH. Most HCH remained accumulated in the root biomass, and mainly α-HCH and δ-HCH were transported to the above-ground parts due to their physicochemical properties. Simultaneously, HCH uptake and metabolization to chlorobenzenes (CB) and chlorophenols (CP) occur. Non-targeted analysis showed that CP could be conjugated to glucose and malonyl in plant tissue, and secondary plant metabolism is affected positively and negatively after exposure to t-HCH depending on plant species and chemical concentration. Luteolin, quercetin and quercetin-3-O-glucoside found common to all species showed quantitative changes due to HCH. Nevertheless, most morphological and physiological parameters were adversely affected without statistical significance. This large-scale study provides information on the fate of HCH in the soil-plant system, the suitability of selected plants and their adaptation to chemical stress for use in the phytoremediation process.
Assuntos
Hexaclorocicloexano , Áreas Alagadas , Hexaclorocicloexano/análise , Bioacumulação , Biodegradação Ambiental , Plantas/metabolismo , SoloRESUMO
Although the pesticide hexachlorocyclohexane (HCH) and its isomers have long been banned, their presence in the environment is still reported worldwide. In this study, we investigated the bioaccumulation potential of α, ß, and δ hexachlorocyclohexane (HCH) isomers in black alder saplings (Alnus glutinosa) to assess their environmental impact. Each isomer, at a concentration of 50 mg/kg, was individually mixed with soil, and triplicate setups, including a control without HCH, were monitored for three months with access to water. Gas chromatography-mass spectrometry revealed the highest concentrations of HCH isomers in roots, decreasing towards branches and leaves, with δ-HCH exhibiting the highest uptake (roots-14.7 µg/g, trunk-7.2 µg/g, branches-1.53 µg/g, leaves-1.88 µg/g). Interestingly, α-HCH was detected in high concentrations in ß-HCH polluted soil. Phytohormone analysis indicated altered cytokinin, jasmonate, abscisate, and gibberellin levels in A. glutinosa in response to HCH contamination. In addition, amplicon 16S rRNA sequencing was used to study the rhizosphere and soil microbial community. While rhizosphere microbial populations were generally similar in all HCH isomer samples, Pseudomonas spp. decreased across all HCH-amended samples, and Tomentella dominated in ß-HCH and control rhizosphere samples but was lowest in δ-HCH samples.