RESUMO
Ultraviolet (UV) light-emitting diodes (LEDs) emitting at 260â nm were evaluated to determine the inactivation kinetics of bacteria, viruses, and spores compared to low-pressure (LP) UV irradiation. Test microbes were Escherichia coli B, a non-enveloped virus (MS-2), and a bacterial spore (Bacillus atrophaeus). For LP UV, 4-log10 reduction doses were: E. coli B, 6.5â mJ/cm(2); MS-2, 59.3â mJ/cm(2); and B. atrophaeus, 30.0â mJ/cm(2). For UV LEDs, the 4-log10 reduction doses were E. coli B, 6.2â mJ/cm(2); MS-2, 58â mJ/cm(2); and B. atrophaeus, 18.7â mJ/cm(2). Microbial inactivation kinetics of the two UV technologies were not significantly different for E. coli B and MS-2, but were different for B. atrophaeus spores. UV LEDs at 260â nm are at least as effective for inactivating microbes in water as conventional LP UV sources and should undergo further development in treatment systems to disinfect drinking water.
Assuntos
Água Potável , Purificação da Água/métodos , Água Potável/análise , Água Potável/microbiologia , Água Potável/virologia , Mercúrio , Raios UltravioletaRESUMO
There is growing interest in studying the toxicity and health risk of exposure to multi-pollutant mixtures found in ambient air, and the U.S. Environmental Protection Agency (EPA) is moving towards setting standards for these types of mixtures. Additionally, the Health Effects Institute's strategic plan aims to develop and apply next-generation multi-pollutant approaches to understanding the health effects of air pollutants. There's increasing concern that conventional in vitro exposure methods are not adequate to meet EPA's strategic plan to demonstrate a direct link between air pollution and health effects. To meet the demand for new in vitro technology that better represents direct air-to-cell inhalation exposures, a new system that exposes cells at the air-liquid interface was developed. This new system, named the Gillings Sampler, is a modified two-stage electrostatic precipitator that provides a viable environment for cultured cells. Polystyrene latex spheres were used to determine deposition efficiencies (38-45%), while microscopy and imaging techniques were used to confirm uniform particle deposition. Negative control A549 cell exposures indicated the sampler can be operated for up to 4h without inducing any significant toxic effects on cells, as measured by lactate dehydrogenase (LDH) and interleukin-8 (IL-8). A novel positive aerosol control exposure method, consisting of a p-tolualdehyde (TOLALD) impregnated mineral oil aerosol (MOA), was developed to test this system. Exposures to the toxic MOA at a 1 ng/cm(2) dose of TOLALD yielded a reproducible 1.4 and 2-fold increase in LDH and IL-8 mRNA levels over controls. This new system is intended to be used as an alternative research tool for aerosol in vitro exposure studies. While further testing and optimization is still required to produce a "commercially ready" system, it serves as a stepping-stone in the development of cost-effective in vitro technology that can be made accessible to researchers in the near future.
Assuntos
Aerossóis/análise , Monitoramento Ambiental/instrumentação , Material Particulado/análise , Eletricidade Estática , Ar/análise , Humanos , Látex/química , Poliestirenos/química , Células Tumorais Cultivadas , Estados UnidosRESUMO
Inactivation of the pathogenic Escherichia coli serotype O157:H7 and a non-pathogenic E. coli strain isolated from dairy cattle manure was evaluated with batch tests at 50 and 55 degrees C in biosolids from a thermophilic anaerobic digester treating the manure. Using differential-selective plating on sorbitol-MacConkey (SMAC) agar to quantify E. coli, the decline in concentrations of both the sorbitol-negative (putative E. coli O157:H7) and sorbitol-positive (putative non-pathogenic E. coli) organisms followed a model that assumed there was a heat-sensitive fraction and a heat-resistant fraction. Inactivation rates of the heat-sensitive fractions were similar for both colony types at each temperature, suggesting that wild-type E. coli can be used as an indicator of inactivation of serotype O157:H7. The decimal reduction time for the heat-sensitive fractions was in the order of 10min at 55 degrees C and ranged from approximately 1-3h at 50 degrees C. Concentrations of heat-resistant organisms at 55 degrees C were 1.4-1.7log(10)cfu/mL. Confirmatory analyses conducted on 30 randomly selected colonies of heat-resistant sorbitol-negative cells from treatment at 55 degrees C indicated that none were serotype O157:H7, nor were they E. coli. Similar analyses on 10 sorbitol-negative isolates from untreated manure indicated that none were serotype O157:H7, although 16S rRNA gene sequence analysis indicated that eight were E. coli or closely related enteric bacteria. These findings suggest that plating on differential-selective media to quantify E. coli, including serotype O157:H7, in effluent samples from thermophilic anaerobic digestion can lead to false positive results. Therefore, more specific methods should be used to evaluate the extent of thermal inactivation of both pathogenic and non-pathogenic E. coli in manure treatment systems.
Assuntos
Reatores Biológicos , Escherichia coli O157/isolamento & purificação , Esterco/microbiologia , Anaerobiose , Animais , Bovinos , Desinfecção , Escherichia coli O157/genética , Temperatura Alta , Filogenia , RNA Bacteriano/análise , RNA Ribossômico 16S/análise , Análise de Sequência de DNARESUMO
Thermophilic-anaerobic digestion in a single-stage, mixed, continuous-flow reactor is not approved in the United States as a process capable of producing Class A biosolids for land application. This study was designed to evaluate the inactivation of pathogens and indicator organisms in such a reactor followed by batch treatment in a smaller reactor. The combined process was evaluated at 53 degrees C with sludges from three different sources and at 51 and 55 degrees C with sludge from one of the sources. Feed sludge to the continuous-flow reactor was spiked with the pathogen surrogates Ascaris suum and vaccine-strain poliovirus. Feed and effluent were analyzed for these organisms and for indigenous Salmonella spp., fecal coliforms, Clostridium perfringens spores, and somatic and male-specific coliphages. No viable Ascaris eggs were observed in the effluent from the continuous reactor at 53 or 55 degrees C, with greater than 2-log removals across the digester in all cases. Approximately 2-log removal was observed at 51 degrees C, but all samples of effluent biosolids contained at least one viable Ascaris egg at 51 degrees C. No viable poliovirus was found in the digester effluent at any of the operating conditions, and viable Salmonella spp. were measured in the digester effluent in only one sample throughout the study. The ability of the continuous reactor to remove fecal coliforms to below the Class A monitoring limit depended on the concentration in the feed sludge. There was no significant removal of Clostridium perfringens across the continuous reactor under any condition, and there also was limited removal of somatic coliphages. The removal of male-specific coliphages across the continuous reactor appeared to be related to temperature. Overall, at least one of the Class A pathogen criteria or the fecal coliform limit was exceeded in at least one sample in the continuous-reactor effluent at each temperature. Over the range of temperatures evaluated, the maximum time required to meet the Class A criteria by batch treatment of the continuous-reactor effluent was 1 hour for Ascaris suum and Salmonella spp. and 2 hours for fecal coliforms.
Assuntos
Anaerobiose , Reatores Biológicos , MicrobiologiaRESUMO
There is increasing interest in the United States in producing biosolids from municipal wastewater treatment that meet the criteria for Class A designation established by the U.S. Environmental Protection Agency. Class A biosolids are intended to be free of pathogens and also must meet requirements for reduction of the vector-attraction potential associated with untreated sludge. High-temperature processes are considered to produce Class A biosolids if the combination of operating temperature and treatment time exceeds minimum criteria, but this option is not applicable to mixed, continuous-flow reactors. Such reactors, or any combination of reactors that does not meet the holding time requirement at a specific temperature, must be demonstrated to inactivate pathogens to levels consistent with the Class A criteria. This study was designed to evaluate pathogen inactivation by thermophilic anaerobic digestion in a mixed, continuous-flow reactor followed by batch or plug-flow treatment. In this first of a two-part series, we describe the performance of a continuous-flow laboratory reactor with respect to physical and chemical operating parameters; microbial inactivation in the combined continuous-flow and batch treatment system is described in the second part. Sludges from three different sources were treated at 53 degrees C, while sludge from one of the sources was also treated at 55 and 51 degrees C. Relatively short hydraulic retention times (four to six days) were used to represent a conservative operating condition with respect to pathogen inactivation. Treatment of a fermented primary sludge led to an average volatile-solids (VS) destruction efficiency of 45%, while VS destruction for the other two sources was near or below 38%, the Class A criterion for vector attraction reduction. Consistent with other studies on thermophilic anaerobic digestion of sludges at short residence times, effluent concentrations of volatile fatty acids (VFAs) were relatively high. Also consistent with other studies, the most abundant VFA in the effluent was propionate. Gas production ranged from 0.3 to 0.5 m3/kg VS fed and from 0.8 to 1.3 m3/kg VS destroyed.
Assuntos
Anaerobiose , Reatores Biológicos , Laboratórios , Estados UnidosRESUMO
There is considerable interest in the United States in production of Class A (low pathogen content) biosolids from the treatment of municipal wastewater sludge. Current requirements imposed by the U.S. Environmental Protection Agency make it difficult for thermophilic anaerobic digestion, in its simplest process configurations, to achieve Class A status. In particular, the time-temperature requirements necessitate long batch treatment times at temperatures associated with thermophilic anaerobic digestion. The time-temperature requirements are meant to ensure extensive inactivation of helminth eggs and enteric viruses, considered to be the most heat-resistant of the relevant pathogen classes. However, data on inactivation kinetics of these pathogens at precisely controlled and well-characterized temperatures are scarce. We measured inactivation of vaccine-strain poliovirus and eggs from the helminth Ascaris suum at temperatures from 49 to 55 degrees C in a lab-scale batch reactor containing biosolids from a continuous-flow thermophilic anaerobic digester. Both microbes were inactivated rapidly, with Ascaris more resistant to inactivation than poliovirus, and the relationships between inactivation rate and temperature were steep. The Arrhenius correlation between inactivation rate and temperature over the range 49-53 degrees C is consistent with protein denaturation as the inactivation mechanism for both microbes. The least stringent of the EPA time-temperature equations for thermal processes requires batch treatment times more than 2 orders of magnitude greater than would be required for three-log reduction of Ascaris at the rates we measured, suggesting an overly conservative regulatory approach. Such a grossly conservative approach can hinder full-scale implementation of thermophilic anaerobic digestion.