Effect of extremely low frequency electromagnetic field parameters on the proliferation of human breast cancer.

Extremely low-frequency electromagnetic field (ELF-EMF) exposures influence many biological systems. These effects are mainly related to the intensity, duration, frequency, and pattern of the ELF-EMF. Our intent was to characterize the effect of specific pulsed electromagnetic fields on the in vitro proliferation of MCF-7 adenocarcinoma and MDA-MB-231 breast cancer cell lines and one non-cancerous M10 breast epithelial cell line. The following four important parameters of ELF-EMF were examined: frequencies (7.83 ± 0.3, 23.49 ± 0.3, and 39.15 ± 0.3 Hz), flux density (0.5 and 1 mT), exposure duration (12, 24, and 48 h), and the exposure methodology (continuous exposure versus switching exposure). The viability of MDA-MB-231 cells exposed to the optimized ELF-EMF pattern (7.83 ± 0.3 Hz, 1 mT, and 6 h switching exposure) was 40.1%. By contrast, the optimized ELF-EMF parameters that were most cytotoxic to breast cancer MDA-MB-231 cells were not damaging to normal M10 cells. In vitro studies also showed that exposure of MDA-MB-231 cells to the optimized ELF-EMF pattern promoted Ca2+ influx and resulted in apoptosis. These data confirm that exposure to this specific ELF-EMF pattern can influence cellular processes and inhibit cancer cell growth. The specific ELF-EMF pattern determined in this study may provide a potential anti-cancer treatment in the future.

Inhibition of B16F10 Cancer Cell Growth by Exposure to the Square Wave with 7.83+/-0.3Hz Involves L- and T-Type Calcium Channels.

Extremely low-frequency electromagnetic field (ELF-EMF) exposure influences many biological systems; these effects are mainly related to the intensity, duration, frequency, and pattern of the ELF-EMF. In this study, exposure to square wave with 7.83±0.3 Hz (sweep step 0.1 Hz) was shown to inhibit the growth of B16F10 melanoma tumor cells. In addition, the distribution of the magnetic field was calculated by Biot-Savart Law and plotted using MATLAB. In vitro studies demonstrated a decrease in B16F10 cell proliferation and an increase of Ca2+ influx after 48 h of exposure to the square wave. Ca2+ influx was also partially blocked by inhibition of voltage-gated L- and T-type Ca2+ channels. The data confirmed that the specific time-varying ELF-EMF had an anti-proliferation effect on B16F10 cells and that the inhibition is related to Ca2+ and voltage-gated L- and T-type Ca2+ channels.

Effects of extremely low-frequency electromagnetic fields on B16F10 cancer cells.

This paper presents a method to inhibit B16F10 cancer cells using extremely low-frequency electromagnetic fields (ELF-EMFs) and to evaluate cell viability using MTT (3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyl tetrazolium bromide) assay. The study examined the effect of a natural EMF resonance frequency (7.83 Hz) and a power line frequency (60 Hz) on B16F10 cancer cells for 24 and 48 h. The B16F10 cancer cells were also exposed to sweep frequencies in several sweep intervals to quantitatively analyze the viability of cancer cells. The results yielded a 17% inhibition rate under 7.83 Hz compared with that of the control group. Moreover, sweep frequencies in narrow intervals (7.83 ± 0.1 Hz for the step 0.05 Hz) caused an inhibition rate of 26.4%, and inhibitory effects decreased as frequency sweep intervals increased. These results indicate that a Schumann resonance frequency of 7.83 Hz can inhibit the growth of cancer cells and that using a specific frequency type can lead to more effective growth inhibition.

Impedance measurement system for automatic determination of glycated hemoglobin.

In this study, an automatic glycated hemoglobin (HbA1c) impedance measurement system (AHMS) is developed for the detection of HbA1c. The proposed device removes some of the drawbacks of common instruments for HbA1c detection (i.e., large, expensive, difficult to operate) by detecting the ratio of HbA1c to Hb. The method is label-free and requires only a small sample volume; no additional reagents are required. The manpower consumption and bulk of the instrument are also reduced. The method provides a simple way to analyze impedance deviation and effectively reduces the effort required by the operator. The ratios of HbA1c to Hb (4%-7%) are well distinguished, and the experiment is used to build a database for AHMS. To check the reliability of the proposed system, a sample test using three different ratios of HbA1c is applied in this study. The sample test uses HbA1c to Hb ratios of 4.7%, 5.6%, and 6.8%, and the determined experimental values are 4.93%, 5.8%, and 6.83%, respectively. The sample test has an accuracy of approximately 96.99%. Based on these results, the proposed system for detecting HbA1c through protein coverage is both effective and feasible.

Effect of Electrode Shape on Impedance of Single HeLa Cell: A COMSOL Simulation.

In disease prophylaxis, single cell inspection provides more detailed data compared to conventional examinations. At the individual cell level, the electrical properties of the cell are helpful for understanding the effects of cellular behavior. The electric field distribution affects the results of single cell impedance measurements whereas the electrode geometry affects the electric field distributions. Therefore, this study obtained numerical solutions by using the COMSOL multiphysics package to perform FEM simulations of the effects of electrode geometry on microfluidic devices. An equivalent circuit model incorporating the PBS solution, a pair of electrodes, and a cell is used to obtain the impedance of a single HeLa cell. Simulations indicated that the circle and parallel electrodes provide higher electric field strength compared to cross and standard electrodes at the same operating voltage. Additionally, increasing the operating voltage reduces the impedance magnitude of a single HeLa cell in all electrode shapes. Decreasing impedance magnitude of the single HeLa cell increases measurement sensitivity, but higher operational voltage will damage single HeLa cell.

Battery-powered portable instrument system for single-cell trapping, impedance measurements, and modeling analyses.

A battery-powered portable instrument system for the single-HeLa-cell trapping and analyses is developed. A method of alternating current electrothermal (ACET) and DEP are employed for the cell trapping and the method of impedance spectroscopy is employed for cell characterizations. The proposed instrument (160 mm × 170 mm × 110 mm, 1269 g) equips with a highly efficient energy-saving design that promises approximately 120 h of use. It includes an impedance analyzer performing an excitation voltage of 0.2-2 Vpp and a frequency sweep of 11-101 kHz, function generator with the sine wave output at an operating voltage of 1-50 Vpp with a frequency of 4-12 MHz, cell-trapping biochip, microscope, and input/output interface. The biochip for the single cell trapping is designed and simulated based on a combination of ACET and DEP forces. In order to improve measurement accuracy, the curve fitting method is adopted to calibrate the proposed impedance spectroscopy. Measurement results from the proposed system are compared with results from a precision impedance analyzer. The trapped cell can be modeled for numerical analyses. Many advantages are offered in the proposed instrument such as the small volume, real-time monitoring, rapid analysis, low cost, low-power consumption, and portable application.

Glycated hemoglobin (HbA1c) affinity biosensors with ring-shaped interdigital electrodes on impedance measurement.

Glycated hemoglobin (HbA1c) is one of the most important diagnostic assays for the long-term mark of glycaemic control in diabetes. This study presents an affinity biosensor for HbA1c detection which is label-free based on the impedance measurement, and it features low cost, low sample volume, and requires no additional reagent in experiments. The ring-shaped interdigital electrodes (RSIDEs) are designed to promote the distribution uniformity and immobilization efficiency of HbA1c, and are further employed to characterize the impedance change and identify various concentrations of HbA1c. The self-assembled monolayer (SAM) of thiophene-3-boronic acid (T3BA) is provided to modify the gold electrode surface. Afterwards, the esterification reaction between HbA1c and T3BA produces a relative change of electrical property on the electrode surface. The RSIDEs with SAM of T3BA exhibit a wide range from 100 to 10 ng/µL producing an approximate logarithmic decrease of impedance, a low detection limit of 1 ng/µL, a good selectivity and short-term stability for HbA1c determination. The remarkable advantages (miniaturization and low-cost) fill the bill of point-care diagnostics for portable sensor development.

Adjustable trapping position for single cells using voltage phase-controlled method.

We present an advanced technique improving upon the micron-sized particle trap integrated in biochip systems using a planar structure to generate an adjustable trapping position by utilizing voltage phase-controlled (VPC) method and negative dielectrophoresis (nDEP) theory in high conductivity physiological media. The designed planar and split structure is composed of independent components of measuring and trapping micro-electrodes. Through different voltage configurations on the device, the trapped position of single particles/cells was selected and adjusted in vertical and horizontal directions. The numerical simulations verify our theoretical predictions of the effects at the various voltages. It shows that the trapped position can be adjusted in the vertical (0 to 26 µm) and horizontal (0 to 74 µm) directions. In experiments, the single particles/cells is captured, measured, and then released, with the same process being repeated twice to demonstrate the precision of the positioning. The measurement results determined that particles at various heights result in different magnitude values, while the impedance error is less than 5% for the proposed electrode layout. Finally, the experiments are performed to verify that a particle/cell can be precisely trapped on the selected site in both the vertical and horizontal directions.

Single HeLa and MCF-7 cell measurement using minimized impedance spectroscopy and microfluidic device.

This study presents an impedance measurement system for single-cell capture and measurement. The microwell structure which utilizes nDEP force is used to single-cell capture and a minimized impedance spectroscopy which includes a power supply chip, an impedance measurement chip and a USB microcontroller chip is used to single-cell impedance measurement. To improve the measurement accuracy of the proposed system, Biquadratic fitting is used in this study. The measurement accuracy and reliability of the proposed system are compared to those of a conventional precision impedance analyzer. Moreover, a stable material, latex beads, is used to study the impedance measurement using the minimized impedance spectroscopy with cell-trapping device. Finally, the proposed system is used to measure the impedance of HeLa cells and MCF-7 cells. The impedance of single HeLa cells decreased from 9.55 × 10(3) to 3.36 × 10(3) Ω and the impedance of single MCF-7 cells decreased from 3.48 × 10(3) to 1.45 × 10(3) Ω at an operate voltage of 0.5 V when the excitation frequency was increased from 11 to 101 kHz. The results demonstrate that the proposed impedance measurement system successfully distinguishes HeLa cells and MCF-7 cells.

Effects of electrode geometry and cell location on single-cell impedance measurement.

Measurements on single cells provide more accurate and in-depth information about electrical properties than those on pathological tissues. The relationship between electrode geometry and the location of a cell on microfluidic devices greatly affects the accuracy of single-cell impedance measurement. Accordingly, this study presents numerical solutions from the FEM simulation of the COMSOL multiphysics package and experimental measurements to analyze the effects of electrode geometry and cell location on microfluidic devices. An equivalent electrical circuit model is developed to obtain the impedance and sensitivity of various cell locations on various electrode geometries using FEM simulation. According to the simulation results, the parallel electrodes have the largest sensing area (39 microm(2)) and the highest sensitivity (0.976) at a voltage of 0.1 V and a frequency of 100 kHz. Increasing the width of electrodes provides a large sensing area but reduces sensitivity, whereas decreasing the gap between electrodes increases both sensing area and sensitivity. In experiments, the results demonstrate that the magnitude is inversely proportional to the overlap area of the cell and electrodes. Moreover, the impedance of single HeLa cells measured at various cell locations can be modified using equations determined from the modeling and experimental results.

A systematic investigation into the electrical properties of single HeLa cells via impedance measurements and COMSOL simulations.

The electrical properties of single cells provide fundamental insights into their pathological condition and are therefore of immense interest to medical practitioners. Accordingly, this study captures single HeLa cells using a microfluidic device and then measures their impedance properties using a commercial impedance spectroscopy system. The experimental system is modeled by an equivalent electrical circuit and COMSOL simulations are then performed to establish the conductivity, permittivity and impedance of single HeLa cells under various operational frequencies and voltages. At an operational voltage of 0.2 V, the maximum deviation between the experimental and simulation results for the magnitude and phase of the HeLa cell impedance is found to be 9.5% and 4.2%, respectively. In general, both sets of results show that the conductivity and permittivity of single HeLa cells increase with an increasing operational voltage. Moreover, an increasing frequency is found to increase the conductivity of HeLa cells at all values of the operational voltage, but to reduce the permittivity for operational voltages in the range 0.6-1.0 V. Based upon the simulation and experimental results, empirical equations are constructed to predict the conductivity and permittivity of single HeLa cells under specified values of the operational voltage and frequency, respectively. The maximum discrepancy between the predicted results and the simulation results for the permittivity and conductivity of the HeLa cells at an operational voltage of 0.2 V is found to be just 0.5% and 4.5%, respectively.