Face mask as an indicator and shield of human exposure to traditional and novel organophosphate esters.

Herein, the trapping effectiveness of N95, filter KN95, medical surgical masks (MSMs), and disposable medical masks (DMMs) against 19 airborne traditional and novel organophosphate esters (OPEs) was evaluated. Laboratory simulations (n = 24 for each type of mask) showed that time-dependent accumulation of ∑19OPEs on the four types of masks ranged between 30.1 and 86.6 ng in 24 h, with the highest and lowest median amounts trapped by the N95 masks (53.3 ng) and DMMs (43.2 ng), respectively. The trapping efficiency of the four types of masks for ∑19OPEs decreased over time from 84 % to 39 % in 24 h, with N95 masks showing the highest median efficiency (70 %). Further, field investigations were conducted in five types of microenvironments (train, hospital, bus, supermarket, and canteen), and an analysis of 200 samples showed that ∑19OPEs were accumulated in the masks with a variable amount from 3.7 to 117 ng/mask. Consistent with the laboratory simulations, the N95 masks (29.0 ng/mask) exhibited the highest hourly median amount of trapped OPEs, followed by the KN95 masks (24.5 ng/mask), MSMSs (17.4 ng/mask), and DMMs (15.8 ng/mask). Triethyl phosphate (TEP), tris(1-chloro-2-propyl) phosphate (TCIPP), tri-n-butyl phosphate (TNBP), and cresyl diphenyl phosphate (CDP) as well as 4-isopropylphenyl diphenyl phosphate (4IPPDPP) and 2,4-diisopropylphenyl diphenyl phosphate (24DIPPDPP) were the most commonly detected traditional and novel OPEs. Based on the amount of OPEs trapped on the masks, we estimated the concentration of ∑19OPEs in the train microenvironment to be the highest (222 ng/m3), which is approximately 2-5 times higher than that in the other microenvironments. The results of this study prove that masks can effectively protect humans from exposure to OPEs and act as low-cost indicators of indoor contamination.

Methods for the characterisation of dermal uptake: Progress and perspectives for organophosphate esters.

Organophosphate esters (OPEs) are a group of pollutants that are widely detected in the environment at high concentrations. They can adversely affect human health through multiple routes of exposure, including dermal uptake. Although attention has been paid to achieving an accurate and complete quantification of the dermal uptake of OPEs, existing evaluation methods and parameters have obvious weaknesses. This study reviewed two main categories of methodologies, namely the relative absorption (RA) model and the permeability coefficient (PC) model, which are widely used to assess the dermal uptake of OPEs. Although the PC model is more accurate and is increasingly used, the most important parameter in this model, the permeability coefficient (Kp), has been poorly characterised for OPEs, resulting in considerable errors in the estimation of the dermal uptake of OPEs. Thus, the detailed in vitro methods for the determination of Kp are summarised and sorted. Furthermore, the commonly used skin membranes are identified and the factors affecting Kp and corresponding mechanisms are discussed. In addition, the experimental conditions, conclusions, and available data on Kp values of the OPEs are thoroughly summarised. Finally, the corresponding knowledge gaps are proposed, and a more accurate and sophisticated experimental system and unknown Kp values for OPEs are suggested.

Amlodipine removal via peroxymonosulfate activated by carbon nanotubes/cobalt oxide (CNTs/Co3O4) in water.

Amlodipine (AML) is an effective drug that has been widely used for hypertension and angina. However, AML is frequently detected in aqueous environments, posing potential risks to human and ecological health. In this study, the degradation of AML via peroxymonosulfate (PMS) activated by CNTs/Co3O4 was investigated. CNTs/Co3O4 was prepared via a facile method, and multiple characterizations suggested that Co3O4 were uniformly dispersed on the surface of MWCNTs-COOH. Experimental results indicated that complete removal of 10 µM AML was achieved within 30 min by using 2 mg/L CNTs/Co3O4 and 4 µM PMS at 25 °C in PBS buffered solution (pH 7.0). The observed pseudo-first-order rate constant was calculated to be 0.1369 min-1. Interestingly, the presence of 100 mM Cl- resulted in a slight enhancement of AML removal rate from 0.0528 to 0.0642 min-1. The addition of 100 mM HCO3-, 5 mg/L Pony Lake fulvic acid (PLFA), or Suwannee River humic acid (SRHA) retarded AML degradation by 15.5, 0.7, and 1.6 times, respectively. As per the quenching experiments, SO4⦁- rather than ⦁OH were verified to be the dominant reactive oxygen species (ROS). Additionally, ten major intermediates were identified using TOF-LC-MS and three associated reaction pathways including ether bond broken, H-abstraction, and hydroxylation were proposed. We outlook these findings to advance the feasibility of organic contaminants removal via CNTs/Co3O4 + PMS systems that have extremely low-level PMS.

Image-based modeling of unwrappable façades.

In this paper, we propose an unwrappable representation for image-based façade modeling from multiple registered images. An unwrappable façade is represented by the mutually orthogonal baseline and profile. We first reconstruct semidense 3D points from images, then the baseline and profile are extracted from the point cloud to construct the base shape and compose the textures of the building from the images. Through our unwrapping process, the reconstructed 3D points and composed textures are further mapped to an unwrapped space that is parameterized by the baseline and profile. In doing so, the unwrapped space becomes equivalent to the planar space in which planar façade modeling techniques can be used to reconstruct the details of the buildings. Finally, the augmented details can be wrapped back to the original 3D space to generate the final model. This newly introduced unwrappable representation extends the state-of-the-art modeling for planar façades to a more general class of façades. We demonstrate the power of the unwrappable representation with a few examples in which the façade is not planar.