Bacterial Septic Arthritis of the Adult Native Knee Joint: A Review.

¼ Acute bacterial septic arthritis of the knee is an orthopaedic emergency and, if left untreated, can result in substantial joint degradation. ¼ Important risk factors for development of septic arthritis include age of >60 years, recent bacteremia, diabetes, cancer, cirrhosis, renal disease, drug or alcohol abuse, a history of corticosteroid injection, a recent injury or surgical procedure, a prosthetic joint, and a history of rheumatoid arthritis. ¼ The diagnosis is primarily based on history and clinical presentation of a red, warm, swollen, and painful joint with limited range of motion. Laboratory values and inflammatory markers from serum and joint fluid may serve as adjuncts when there is clinical suspicion of septic arthritis. ¼ The initial and general antibiotic regimen should cover methicillin-resistant Staphylococcus aureus and gram-negative and gram-positive organisms. The antibiotic regimen should be specified following the culture results of the infected joint. ¼ Operative management involves either arthrotomy or arthroscopy of the knee with thorough irrigation and debridement of all infected tissue. The Gächter classification is useful in establishing a prognosis or in determining the need for an extensive debridement.

External fixator-augmented flexible intramedullary nailing of an unstable pediatric femoral shaft fracture model: a biomechanical study.

The objective of this study was to test the compressive strength and torsional stiffness provided by the addition of a two-pin external fixator to an unstable pediatric femoral shaft fracture model after being instrumented with flexible intramedullary nailing (FIMN), and to compare this to bridge plating and FIMN alone. A length-unstable oblique diaphyseal fracture was created in 15 pediatric sized small femur models. Fracture stabilization was achieved by three constructs: standard retrograde FIMN with two 3.5-mm titanium (Ti) nails (Group 1), FIMN augmented with a two-pin external fixator (Group 2), and a 4.5-mm bridge plate (Group 3). Groups I and II were tested in 10 cycles of axial rotation to 10° in both directions at 0.1 Hz under 36 kg of compression. Torsional stiffness was calculated. Compressive strength was calculated by applying an axial load of 5 mm/min until failure was encountered. Failure was defined as the force required to achieve 10° varus at the fracture site or shortening of 2 cm. Group II demonstrated a greater compressive strength compared to Group I (1067.32 N vs 453.49 N, P < 0.001). No significant difference in torsional stiffness was found between Groups I and II (0.45 vs 0.38 Nm/deg, P = 0.18). Group III showed superior compressive strength and rotational stiffness compared to Groups I and II. In an unstable pediatric femoral shaft fracture model, augmenting FIMN with a two-pin external fixator increased the compressive strength by 147%, but did not increase torsional stiffness. Bridge plating with a 4.5-mm plate provided superior compressive strength and torsional stiffness.

Intrapelvic Femoral Head Dislocation without Associated Proximal Femur Fracture: A Case Report and Description of Closed Reduction Technique.

Traumatic hip dislocations are potentially devastating injuries, especially in young patients, and require emergent orthopedic treatment. Given the significant amount of energy required to cause these injuries, a high index of suspicion is necessary to identify related injuries. The associated injuries, direction of dislocation, and time between injury and reduction represent the known prognostic factors, based on limited available research. Intrapelvic hip dislocations represent an uncommon variant of the traumatic hip dislocation, with all previously reported cases involving ipsilateral proximal femur fractures. We present a case of intrapelvic femoral head dislocation without an associated proximal femur fracture, as well as the maneuvers used to treat the patient via a closed reduction.