Assessment of gamma radiation from a limited area of forest floor using a cumulative personal dosimeter.

To elucidate long term changes in gamma radiation from a limited region of interest of the forest floor, a simple monitoring procedure using a cumulative personal dosimeter (D-shuttle) was examined from 2016 to 2017. The test site was in a small forest in Abiko, Japan, where the initial radiocesium contamination from the Fukushima Dai-ichi Nuclear Power Plant was 60-100 kBq m-2. Three experimental plots basically containing a set of two 5 × 5 m2 observation areas were arranged at the site. The litterfall and decomposing organic layer of one area (D: decontaminated) were fully eliminated before the monitoring, whereas the other area (N: natural) was left unchanged. Five D-shuttle sets (i.e., D-shuttle, lead shield, and holder) per area were set up. One D-shuttle set could monitor the specific gamma radiation from radiocesium distributed within a limited area of ground (0.5 m radius of circle = ca. 0.8 m2 area of flat ground). The results indicated significant differences in the accumulated doses among each of the plots and areas, reflecting their soil radiocesium inventories. Interestingly, every index decreased with time, but the decreases were slower than the theoretical decay of radiocesium (134Cs and 137Cs). In addition, the accumulated dose decreased during heavy rainfall events. One possible explanation for these changes of the accumulated dose is a combination of meteorological and tree phenological phenomena, such as radiocesium from the forest canopy being newly added to the floor primarily by litterfall and soil moisture content disturbing radiation emitted from soils. This simple procedure enables long-term observation of gamma radiation from a limited area of forest floor non-invasively and semi-quantitatively.

Poly(n-alkylsilsesquioxane) liquids prepared by cosolvent-free hydrolytic polycondensation of n-alkyltrialkoxysilanes: effects of liquid-liquid phase separation during aging and alkyl chain length on structure and viscosity.

The effect of the alkyl chain length and alkoxy groups on the viscosity and related properties of polysilsesquioxanes (PSQs) prepared by cosolvent-free hydrolytic polycondensation from n-alkyltrialkoxysilane-water binary systems via aging was investigated. n-Alkyltrialkoxysilanes with ethyl, n-propyl, and n-butyl groups gave PSQ liquids, whereas those with methyl groups yielded gels. The viscosity of the PSQ liquids remained stable over a month at room temperature despite the presence of many SiOH groups, and decreased with an increase in the alkyl chain length. The aging step was crucial for obtaining PSQ liquids with low viscosities, and both n-alkyltrimethoxysilane and n-alkyltriethoxysilane with the same alkyl group produced PSQ liquids with comparable viscosities. However, during aging, liquid-liquid phase separation occurred only in the solutions derived from alkyltrimethoxysilanes. These observations confirmed that liquid-liquid phase separation is not essential for the preparation of PSQ liquids. The temperature dependence of the viscosity indicated that the PSQ liquids are fragile.

Changes in the distribution of radiocesium in the wood of Japanese cedar trees from 2011 to 2013.

The changes in the distribution of (137)Cs in the wood of Japanese cedar (Cryptomeria japonica) trunks within three years after the Fukushima Dai-ichi Nuclear Power Plant (FDNP) accident in 2011 were investigated. Thirteen trees were felled to collect samples at 6 forests in 2 regions of the Fukushima prefecture. The radial distribution of (137)Cs in the wood was measured at different heights. Profiles of (137)Cs distribution in the wood changed considerably from 2011 to 2013, and the process of (137)Cs distribution change in the wood was clarified. From 2011 to 2012, the active transportation from sapwood to heartwood and the radial diffusion in heartwood proceeded quickly, and the radial (137)Cs distribution differed according to the vertical positon of trees. From 2012 to 2013, the vertical diffusion of (137)Cs from the treetop to the ground, probably caused by the gradient of (137)Cs concentration in the trunk, was observed. Eventually, the radial (137)Cs distributions were nearly identical at any vertical positions in 2013. Our results suggested that the active transportation from sapwood to heartwood and the vertical and radial diffusion in heartwood proceeded according to the vertical position of the tree and (137)Cs distribution in the wood approached the equilibrium state within three years after the accident.

Intercalation of a surfactant with a long polyfluoroalkyl chain into a clay mineral: unique orientation of polyfluoroalkyl groups in clay layers.

Eight novel polyfluorinated surfactants (C(n)F(2n+1)CONH(CH2)2 N(+)(CH3)2C16H33 Br(-); abbreviated as CnF-S, where n = 1, 2, 3, 4, 5, 6, 8, 10) were synthesized and their intercalation into cation-exchangeable clay was investigated. All of the polyfluorinated surfactants intercalated in amounts exceeding the cation exchange capacity (CEC) of the clay. The C4F-S and C5F-S surfactants exhibited intercalation up to 480% of the CEC as a saturated adsorption limit. On the basis of X-ray analysis, CnF-S surfactants intercalated between clay nanosheets to form a bilayer structure in which the surfactant molecules tilt at an angle of ∼60° with respect to the clay surface. The saturated adsorption limits and layer distances differed between surfactants with short (n = 1, 2) and long (n = 3-10) perfluoroalkyl chains. For long-chain surfactants, their saturated adsorption limits were independent of the perfluoroalkyl chain length and the layer distances systematically increased with increasing perfluoroalkyl chain length. These results suggest that the microscopic orientation differed between the short and long chains. X-ray analysis showed that the long-chain surfactants orient the perfluoroalkyl chains at a tilt of 41 ± 5° with respect to the clay layer. This value was in good agreement with polarized IR measurements of 42 ± 2° for this angle.

Novel methodology to control the adsorption structure of cationic porphyrins on the clay surface using the "size-matching rule".

Saponite-type clays that have different cation exchange capacities were successfully synthesized by hydrothermal synthesis. The structure and properties were analyzed by X-ray diffraction, X-ray fluorescence, (27)Al NMR, FT-IR, thermogravimetric and differential thermal analysis, atomic force microscopy, and cation exchange capacity measurement. The intercharge distances on the synthetic saponite (SS) surfaces were calculated to be 0.8-1.9 nm on the basis of a hexagonal array. The complex formation behavior between SS and cationic porphyrins was examined. It turns out that the average intermolecular distance between porphyrin molecules on the SS surface can be controlled, depending on the charge density of the SS. In the case of tetrakis(1-methylpyridinium-4-yl)porphyrin (H(2)TMPyP(4+)), the average intermolecular distances on the SS surface can be controlled from 2.3 to 3.0 nm on the basis of a hexagonal array. It was also found that absorption maxima of porphyrins depend on the charge density of the SS. The adsorption behavior of porphyrin on the SS surface can be rationally understood by the previously reported "size-matching rule". This methodology using host-guest interaction can realize a unique adsorption structure control of the porphyrin molecule on the SS surface, where the gap distance between guest porphyrin molecules is rather large. These findings will be highly valuable to construct photochemical reaction systems such as energy transfer in the complexes.

Order-order and order-disorder transitions in thin films of an amphiphilic liquid crystalline diblock copolymer.

In this study, we quantitatively investigated the temperature-dependent phase transition behaviors of thin films of an interesting amphiphilic diblock copolymer, poly(ethylene oxide)-b-poly(11-[4-(4-butylphenylazo)phenoxy]undecyl methacrylate) (p(EO)-b-p(MAAZ)) and the resulting morphological structures by using synchrotron grazing incidence X-ray scattering (GIXS) and differential scanning calorimetry. The quantitative GIXS analysis showed that the diblock copolymer in the homogeneous, isotropic melt state undergoes phase-separation near 190 degrees C and then forms a body-centered cubic (BCC) structure of spherical p(EO) domains in the p(MAAZ) matrix, at which point the p(EO) domains and the p(MAAZ) matrix are both in amorphous, liquid states. The BCC structure of spherical p(EO) domains is converted to a hexagonal cylinder structure near 120 degrees C, which is induced by the transformation of the isotropic phase of the p(MAAZ) matrix to the smectic A phase, which is composed of a laterally ordered structure of p(MAAZ) blocks with fully extended side groups. The resulting hexagonal cylinder structure is very stable below 120 degrees C. This microscopic hexagonal cylinder structure is retained as the smectic A phase of the p(MAAZ) matrix undergoes further transitions to smectic C near 104 degrees C and to a smectic X phase near 76 degrees C, while the amorphous, liquid phase of the p(EO) cylinders undergoes crystallization near -15 degrees C. These complicated temperature-dependent disorder-order and order-order phase transitions in the films were found to take place reversibly during the heating run. A face-centered orthorhombic structure of p(EO) domains was also found during the heating run and is an intermediate structure in the hexagonal cylinder structure to BCC structure transformation. We use these structural analysis results to propose molecular structure models at various temperatures for thin films of the diblock polymer.

Synthesis, liquid-crystalline properties, and supramolecular nanostructures of dendronized poly(isocyanide)s and their precursors.

A series of novel dendronized pi-conjugated poly(isocyanide)s were synthesized successfully by using a Pd-Pt mu-ethynediyl dinuclear complex ([ClPt{P(C2H5)3}2C[triple bond]CPt{P(C2H5)3}2Cl]) as the initiator. The polymerizations of the dendronized monomers follow first-order kinetics, indicating that living polymerization takes place. The obtained polymers exhibit narrow polydispersities in the range of 1.03-1.20. Thermal properties of the poly(isocyanide)s as well as their isocyanide monomers and precursors with formamido (HCONH-) moieties as apexes were investigated by using differential scanning calorimetry (DSC), polarized optical microscopy (POM) and wide-angle X-ray diffraction (WAXD). Both the peripheries and the apex groups of the dendrons affect the formation of supramolecular column and/or cubic phases of the precursors and monomers. The formamido precursor forms a liquid-crystalline phase due to intermolecular hydrogen bonding. The isocyanide monomer lacks this hydrogen-bonding ability and does not display an organized mesophase. All of the rigid poly(isocyanide)s with the monodendrons exhibit columnar liquid-crystalline phases. Interestingly, cylindrical structures of a poly(isocyanide) were directly visualized by using transmission electron microscopy (TEM).