A Study on the Gas/Humidity Sensitivity of the High-Frequency SAW CO Gas Sensor Based on Noble-Metal-Modified Metal Oxide Film.

In order to improve the response characteristics of the surface acoustic wave (SAW) sensor to trace gases, a SAW CO gas sensor based on a Pd-Pt/SnO2/Al2O3 film with a high-frequency response performance is proposed in this paper. The gas sensitivity and humidity sensitivity of trace CO gas are tested and analyzed under normal temperatures and pressures. The research results show that, compared with the frequency response of the Pd-Pt/SnO2 film, the CO gas sensor based on a Pd-Pt/SnO2/Al2O3 film has a higher frequency response performance, and the sensor has high-frequency response characteristics to CO gas with a concentration in the range of 10-100 ppm. The average response recovery time of 90% ranges from 33.4 s to 37.2 s, respectively. When the CO gas with a concentration of 30 ppm is tested repeatedly, its frequency fluctuation is less than 5%, indicating that the sensor has good stability. In the range of relative humidity (RH) from 25% to 75%, it also has high-frequency response characteristics for CO gas with a 20 ppm concentration.

Dissecting the genetic basis of heterosis in elite super-hybrid rice.

Y900 is one of the top hybrid rice (Oryza sativa) varieties, with its yield exceeding 15 t·hm-2. To dissect the mechanism of heterosis, we sequenced the male parent line R900 and female parent line Y58S using long-read and Hi-C technology. High-quality reference genomes of 396.41 Mb and 398.24 Mb were obtained for R900 and Y58S, respectively. Genome-wide variations between the parents were systematically identified, including 1,367,758 single-nucleotide polymorphisms, 299,149 insertions/deletions, and 4,757 structural variations. The level of variation between Y58S and R900 was the lowest among the comparisons of Y58S with other rice genomes. More than 75% of genes exhibited variation between the two parents. Compared with other two-line hybrids sharing the same female parent, the portion of Geng/japonica (GJ)-type genetic components from different male parents increased with yield increasing in their corresponding hybrids. Transcriptome analysis revealed that the partial dominance effect was the main genetic effect that constituted the heterosis of Y900. In the hybrid, both alleles from the two parents were expressed, and their expression patterns were dynamically regulated in different tissues. The cis-regulation was dominant for young panicle tissues, while trans-regulation was more common in leaf tissues. Overdominance was surprisingly prevalent in stems and more likely regulated by the trans-regulation mechanism. Additionally, R900 contained many excellent GJ haplotypes, such as NARROW LEAF1, Oryza sativa SQUAMOSA PROMOTER BINDING PROTEIN-LIKE13, and Grain number, plant height, and heading date8, making it a good complement to Y58S. The fine-tuned mechanism of heterosis involves genome-wide variation, GJ introgression, key functional genes, and dynamic gene/allele expression and regulation pattern changes in different tissues and growth stages.

Study on SAW Methane Sensor Based on Cryptophane-A Composite Film.

Surface Acoustic Wave (SAW) methane-sensing technology is a new way to detect methane at room temperature. However, the material and structure of the sensitive film are the important factors affecting the detection performance of the sensor. In this paper-with a SAW methane sensor using graphene-nickel cavitation-a composite film is proposed, which can work at room temperature. A delay linear dual-channel differential oscillator with center frequency of 204.3 MHz and insertion loss of -5.658 dB was designed; Cryptophane-A material was prepared by the "three-step method". The composite sensitive film was synthesized by a drop coating method, electrochemical deposition method and electroplating method. The composite film was characterized by SEM. The sensor performance test system and gas sensitivity test system were constructed to determine the response performance of the sensor at concentrations of 0~5% CH4. The results showed that the sensor had a good response recovery performance in the test concentration range, and the frequency offset was positively correlated with methane concentration. The 90% average response time and recovery times were 41.2 s and 57 s, respectively. The sensor sensitivity was 809.4 ± 6.93 Hz/(1% CH4). This study provides a good theoretical basis for the development of surface acoustic-wave methane sensors.

Cyclic Digestion and Ligation-Mediated PCR Used for Flanking Sequence Walking.

Ligation-mediated PCR (LM-PCR) is a classical method for isolating flanking sequences; however, it has a common limitation of reduced success rate owing to the circularization or multimerization of target restriction fragments including the known sequence. To address this limitation, we developed a novel LM-PCR method, termed Cyclic Digestion and Ligation-Mediated PCR (CDL-PCR). The novelty of this approach involves the design of new adapters that cannot be digested after being ligated with the restriction fragment, and cyclic digestion and ligation may be manipulated to block the circularization or multimerization of the target restriction fragments. Moreover, to improve the generality and flexibility of CDL-PCR, an adapter precursor sequence was designed, which could be digested to prepare 12 different adapters at low cost. Using this method, the flanking sequences of T-DNA insertions were obtained from transgenic rice and Arabidopsis thaliana. The experimental results demonstrated that CDL-PCR is an efficient and flexible method for identifying the flanking sequences in transgenic rice and Arabidopsis thaliana.

In Vitro Seamless Stack Enzymatic Assembly of DNA Molecules Based on a Strategy Involving Splicing of Restriction Sites.

The standard binary enzymatic assembly, which operates by inserting one DNA fragment into a plasmid, has a higher assembly success rate than the polynary enzymatic assembly, which inserts two or more fragments into the plasmid. However, it often leaves a nucleotide scar at the junction site. When a large DNA molecule is assembled stepwise into a backbone plasmid in a random piecewise manner, the scars will damage the structure of the original DNA sequence in the final assembled plasmids. Here, we propose an in vitro Seamless Stack Enzymatic Assembly (SSEA) method, a novel binary enzymatic assembly method involving a seamless strategy of splicing restriction sites via a stepwise process of multiple enzymatic reactions that does not leave nucleotide scars at the junction sites. We have demonstrated the success and versatility of this method through the assembly of 1) a 4.98 kb DNA molecule in the 5' → 3' direction using BamHI to generate the sticky end of the assembly entrance, 2) a 7.09 kb DNA molecule in the 3' → 5' direction using SmaI to generate the blunt end of the assembly entrance, and 3) an 11.88 kb DNA molecule by changing the assembly entrance.