Rapid turbidimetric assay to potency evaluation of tigecycline in lyophilized powder.

Tigecycline, a first-in-class glycylcycline and an analog of the semisynthetic antibiotic minocycline, is a potent, broad-spectrum antibiotic that acts by the inhibition of protein translation in bacteria. This glycylcycline inhibits Gram-positive, Gram-negative, atypical, anaerobic and antibiotic-resistant organisms. There is no microbiological analytical method for tigecycline in lyophilized powder reported yet. Thus, this paper reports the development and validation of a simple, sensitive, accurate and reproducible turbidimetric method to quantify tigecycline in lyophilized powder, using Staphylococcus aureus as microorganism test and 3×3 parallel line assay design, with twenty tubes for each assay. The validated method showed good results of linearity in the concentration range from 3 to 4.32µg/mL (r(2)=0.9999), selectivity, precision, robustness and accuracy of 99.74%. The results demonstrated the validity of the proposed bioassay, which allows reliable quantitation of tigecycline in pharmaceutical samples and therefore can be used as a useful alternative methodology for the routine quality control of this medicine.

Quality evaluation of the Finasteride polymorphic forms I and II in capsules.

Finasteride (FNS) is a specific competitive inhibitor of steroid type-II 5α-reductase and is widely used for the treatment of benign prostatic hyperplasia, prostate cancer, and androgenetic alopecia. FNS has two polymorphic forms identified as Form I and Form II. It is known that polymorphism can cause significant differences in the physicochemical properties of a compound such as melting point, density, morphology, solubility, and color. Thus, proper qualitative and quantitative monitoring of the solid-state forms is crucial to ensure high-quality products. There are no published papers studying the influence of the FNS polymorphs on the physicochemical quality of capsules. Furthermore, the available analytical methods are time-consuming, expensive, use buffer or do not demonstrate stability-indicating capacity. The aim of this work was to validate a rapid high-performance liquid chromatography (HPLC) method to evaluate FNS in capsules and to study the physicochemical properties of polymorphic forms, evaluating their possible influence in the dissolution profile and stability of FNS in capsules. Capsules containing Forms I and II of FNS were prepared and subjected to quality control studies, dissolution profiles and a stability study at 50°C. A significant effect of polymorphism on the FNS solubility and dissolution properties was observed. These results suggest that changes in the effects of FNS can occur if a suitable control study is not performed on the raw material used to produce the capsules.

Development and validation of a stability-indicating size-indicating size-exclusion LC method for the determination of rhIFN-alpha2a in pharmaceutical formulations.

A size-exclusion LC method was validated for the determination of interferon-a2a (rhlFN-alpha2a) in pharmaceutical formulations without interference from human serum albumin. Chromatographic separation was performed on a BioSep-SEC-S 2000 column (300 x 7.8 mm id). The mobile phase consisted of 0.001 M monobasic potassium phosphate, 0.008 M sodium phosphate dibasic; 0.2 M sodium chloride buffer, pH 7.4, run at a gradient flow rate and using photodiode array detection at 214 nm, was used. Chromatographic separation was achieved with a retention time of 17.2 min, and the analysis was linear over the concentration range of 1.98 to 198 microg/mL (r2 = 0.9996). The accuracy was 101.39%, with bias lower than 1.67%. The LOD and LOQ were 0.87 and 1.98 microg/mL, respectively. Moreover, method validation demonstrated acceptable results for precision and robustness. The method was applied to the assessment of rhlFN-alpha2a and related proteins in biopharmaceutical dosage forms, and the content/potencies were correlated to those given by a validated RP-LC method and an in vitro bioassay. It was concluded that use of the methods in conjunction allows a great improvement in monitoring stability and QC, thereby ensuring the therapeutic efficacy of the biotechnology-derived medicine.

Validation of a stability-indicating RP-LC method for the determination of tigecycline in lyophilized powder.

A reversed-phase liquid chromatography (RP-LC) method was validated for the determination of tigecycline in lyophilized powder. The LC method was conducted on a Luna C18 column (250 × 4.6 mm i.d.), maintained at room temperature. The mobile phase consisted of buffer containing sodium phosphate monobasic (0.015M) and oxalic acid (0.015M) (pH 7.0)-acetonitrile (75:25, v/v), run at a flow rate of 1.0 mL/min and using ultraviolet detection at 280 nm. The chromatographic separation was obtained with a retention time of 8.6 min, and was linear in the range of 40-100 µg/mL (r(2) = 0.9997). The specificity and stability-indicating capability of the method was proven through forced degradation studies, which also showed no interference of the excipients. The accuracy was 99.01% with a bias lower than 1.81%. The limits of detection and quantitation were 1.67 and 5.05 µg/mL, respectively. Moreover, method validation demonstrated satisfactory results for precision and robustness. The proposed method was applied for the analysis of the lyophilized powder formulation, contributing to improve the quality control and to assure the therapeutic efficacy.

Determination of fluticasone propionate in nasal sprays by a validated stability-indicating MEKC method.

A micellar electrokinetic chromatography method (MEKC) is developed and validated for the analysis of fluticasone propionate (FP) in nasal sprays. The MEKC method is performed on a fused-silica capillary (50 mum i.d.; effective length, 40 cm). The background electrolyte consists of 25 mM borate and 25 mM anionic detergent SDS solution at pH 9. The capillary temperature is maintained at 35 degrees C, and the applied voltage is 20 kV. The injection is performed using the hydrodynamic mode at 50 mbar for 6 s with detection at 238 nm. The method is linear in the range of 2-80 mug/mL (r(2) = 0.9956). The specificity and stability-indicating capability are proven through forced degradation studies inclusive by mass spectrometry, which also shows that there is no interference of the excipients. The limit of detection and limit of quantitation are 0.56 and 2 mug/mL, respectively. Moreover, method validation demonstrates acceptable results for accuracy, precision, and robustness. The proposed method was successfully applied for the quantitative analysis of FP nasal sprays, and the results were compared to a validated reversed-phase liquid chromatographic method, showing non-significant difference (P > 0.05).

Validation of a stability-indicating RP-HPLC method for the determination of entecavir in tablet dosage form.

An RP-HPLC method was validated for the determination of entecavir in tablet dosage form. The HPLC method was carried out on a Gemini C18 column (150 x 4.6 mm id) maintained at 30 degrees C. The mobile phase consisted of acetonitrile-water (95 + 5, v/v)/potassium phosphate buffer (0.01 M, pH 4; 9 + 91, v/v) pumped at a flow rate of 1.0 mL/min. Photodiode array detection was at 253 nm. The chromatographic separation was obtained with a retention time of 4.18 min, and the method was linear in the range of 0.5-200 microg/mL (r2 = 0.9998). The specificity and stability-indicating capability of the method was proven through forced degradation studies, which also showed that there was no interference of the excipients and an increase of the cytotoxicity only by the basic condition. The accuracy was 101.19%, with bias lower than 1.81%. The LOD and LOQ were 0.39 and 0.5 microg/mL, respectively. Method validation demonstrated acceptable results for precision and robustness. The proposed method was applied for the analysis of tablet formulations, to improve QC and assure therapeutic efficacy.

Tigecycline: a review of properties, applications, and analytical methods.

Tigecycline is a new glycylcycline with an expanded broad-spectrum antibiotic, including inhibition of Gram-positive, Gram-negative, atypical, anaerobic, and antibiotic-resistant organisms. Trials have demonstrated that tigecycline is noninferior to the comparators for the treatment of complicated skin and skin structure infections as well as complicated intra-abdominal infections. Tigecycline is only available as an intravenous preparation and analytical methods to its quantitation in pharmaceutical products has not been published to date. This review examined tigecycline characteristics, the spectrum and mechanism of action, pharmacokinetics, applications, and, mainly, the instrumental conditions of published chromatographic methods used to measure tigecycline, its metabolites, and some analogs in clinical and biologic research.

Development and validation of a capillary zone electrophoresis method for assessment of recombinant human granulocyte colony-stimulating factor in pharmaceutical formulations and its correlation with liquid chromatography methods and bioassay.

A capillary zone electrophoresis (CZE) method was validated for the analysis of recombinant human granulocyte colony-stimulating factor (rhG-CSF) and performed on a fused-silica capillary, with detection at 195 nm. The background electrolyte solution consisted of 50 mM sodium tetraborate solution at pH 9. The method was linear in the concentration range of 1-200 microg/mL and the limit of quantitation (LOQ) was 1 microg/mL, with acceptable validation parameters. The method was applied for the analysis of pharmaceutical formulations, and the results were correlated to the reversed-phase HPLC method (RP-HPLC), size-exclusion HPLC method (SE-HPLC) and in vitro bioassay method.

Determination of rupatadine in pharmaceutical formulations by a validated stability-indicating MEKC method.

A stability-indicating MEKC was developed and validated for the analysis of rupatadine in tablet dosage forms, using nimesulide as internal standard. The MEKC method was performed on a fused-silica capillary (50 microm id; effective length, 40 cm). The BGE consisted of 15 mM borate buffer and 25 mM anionic detergent SDS solution at pH 10. The capillary temperature was maintained at 35 degrees C and the applied voltage was 25 kV. The injection was performed using the hydrodynamic mode at 50 mbar for 5 s, with detection by photodiode array detector set at 205 nm. The method was linear in the range of 0.5-150 microg/mL (r2=0.9996). The specificity and stability-indicating capability of the method were proven through degradation studies inclusive by MS, and showing also that there was no interference of the excipients and no increase of the cytotoxicity. The accuracy was 99.98% with bias lower than 1.06%. The LOD and LOQ were 0.1 and 0.5 microg/mL, respectively. The proposed method was successfully applied for the quantitative analysis of rupatadine in pharmaceutical formulations, and the results were compared to a validated RP-LC method, showing non-significant difference (p>0.05).

Validation of a capillary zone electrophoresis method for the comparative determination of etoricoxib in pharmaceutical formulations.

A CZE method was developed and validated for the analysis of etoricoxib in pharmaceutical dosage forms, using prilocaine as an internal standard. The CZE method was carried out on a fused-silica capillary (50 microm id, effective length 40 cm). The BGE consisted of 25 mM tris-phosphate solution at pH 2.5. The capillary temperature was maintained at 35 degrees C, the applied voltage was 25 kV, the injection was performed using the pressure mode at 50 mbar for 5 s, with detection at 234 nm using a photodiode array detector. The method was linear in the range of 2-150 microg/mL (r(2) = 0.9999). The specificity and stability-indicating capability were proven through the degradation studies and showing also that there was no interference of the excipients of the formulation. The accuracy was 99.49% with RSD of 0.66%. The limits of quantitation and detection were 2 and 0.58 microg/mL, respectively. Moreover, method validation demonstrated acceptable results for the precision, sensitivity, and robustness. The proposed method was successfully applied for the quantitative analysis of etoricoxib pharmaceutical formulations, and the results compared to the HPLC and LC-MS/MS methods, showing nonsignificant difference (p >0.05).