Accuracy of the measurements from multiplanar and sagittal reconstructions of CBCT.

OBJECTIVES: The purpose of this study was to assess the accuracy of linear measurements performed in multiplanar reconstructions (MPR) and sagittal reconstructions (SR) of the left hemiface obtained from cone-beam computed tomography (CBCT) with 3D® Dolphin Imaging software by comparing them with the same measurements made on lateral cephalograms and on dry skulls. SETTING AND SAMPLE POPULATION: Lateral cephalograms and CBCT (with voxels of 0.25, 0.3 and 0.4 mm) were taken of 10 dry skulls. MATERIALS AND METHODS: Linear distances were measured using the software's electronic rulers. Measurements performed on dry skulls using a digital caliper were considered the gold standard. The measurements were performed twice by two evaluators. RESULTS: No significant difference was found in the measurements performed with the different imaging modalities and on the dry skulls. The highest mean error was observed in the lateral cephalograms, followed by MPR and SR. CONCLUSIONS: Cephalometric measurements performed on multiplanar and sagittal reconstructions from CBCT, with different spatial resolutions, are accurate when compared with the measurements obtained in lateral cephalograms.

Laser and LED phototherapy on midpalatal suture after rapid maxilla expansion: Raman and histological analysis.

The aim of this study was to analyze the effect of laser or LED phototherapy on the acceleration of bone formation at the midpalatal suture after rapid maxilla expansion. Forty-five rats were divided into groups at 7 days (control, expansion, expansion and laser irradiation, and expansion and LED irradiation) and into 14 days (expansion, expansion and laser in the 1st week, expansion and LED in the 1st week, expansion and laser in the 1st and 2nd weeks, expansion and LED in the 1st and 2nd weeks). Laser/LED irradiation occurred every 48 h. Expansion was accomplished with a spatula and maintained with a triple helicoid of 0.020-in stainless steel orthodontic wire. A diode laser (λ780 nm, 70 mW, spot of 0.04 cm2, t = 257 s, SAEF of 18 J/cm2) or a LED (λ850 ± 10 nm, 150 ± 10 mW, spot of 0.5 cm2, t = 120 s, SAEF of 18 J/cm2) was applied in one point in the midpalatal suture immediately behind the upper incisors. Raman spectroscopy and histological analyses of the suture region were carried and data was submitted to statistical analyses (p ≤ 0.05). Raman spectrum analysis demonstrated that irradiation increases hydroxyapatite in the midpalatal suture after expansion. In the histological analysis of various inflammation, there was a higher production of collagen and osteoblastic activity and less osteoclastic activity. The results showed that LED irradiation associated to rapid maxillary expansion improves bone repair and could be an alternative to the use of laser in accelerating bone formation in the midpalatal suture.

Severe Anterior Open Bite during Mixed Dentition Treated with Palatal Spurs.

Deleterious oral habits, such as non-nutritive sucking or tongue thrusting, if not intercepted at an early stage can cause complex malocclusions. This manuscript describes a clinical case report of a successful interception of a severe anterior dental open bite caused by thumb sucking and tongue thrusting habits. The case involved a six-year-old female patient treated with the use of palatal spurs and maxillary removable crib followed by monitoring the development of dental occlusion. At the end of the interceptive phase acceptable results were achieved, showing the efficacy of the treatment undertaken as well the importance of an early intervention to remove harmful oral habits.

Effect of the laser and light-emitting diode (LED) phototherapy on midpalatal suture bone formation after rapid maxilla expansion: a Raman spectroscopy analysis.

The aim of this study was to analyze the effect of laser or light-emitting diode (LED) phototherapy on the bone formation at the midpalatal suture after rapid maxilla expansion. Twenty young adult male rats were divided into four groups with 8 days of experimental time: group 1, no treatment; group 2, expansion; group 3, expansion and laser irradiation; and group 4, expansion and LED irradiation. In groups 3 and 4, light irradiation was in the first, third, and fifth experimental days. In all groups, the expansion was accomplished with a helicoid 0.020" stainless steel orthodontic spring. A diode laser (λ780 nm, 70 mW, spot of 0.04 cm(2), t = 257 s, spatial average energy fluence (SAEF) of 18 J/cm(2)) or a LED (λ850 nm, 150 mW ± 10 mW, spot of 0.5 cm(2), t = 120 s, SAEF of 18 J/cm(2)) were used. The samples were analyzed by Raman spectroscopy carried out at midpalatal suture and at the cortical area close to the suture. Two Raman shifts were analyzed: ∼ 960 (phosphate hydroxyapatite) and ∼ 1,450 cm(-1) (lipids and protein). Data was submitted to statistical analysis. Significant statistical difference (p ≤ 0.05) was found in the hydroxyapatite (CHA) peaks among the expansion group and the expansion and laser or LED groups. The LED group presented higher mean peak values of CHA. No statistical differences were found between the treated groups as for collagen deposition, although LED also presented higher mean peak values. The results of this study using Raman spectral analysis indicate that laser and LED light irradiation improves deposition of CHA in the midpalatal suture after orthopedic expansion.

Effects of chin advancement surgery in hyoid bone and tongue positions and in the dimension of the oropharynx.

INTRODUCTION: Advancement genioplasty has been increasingly indicated for the correction of anterior mandibular deficiency as it balances the patient's profile and generates functional changes. OBJECTIVE: Thus, the aim of this study was to assess the effects of advancement genioplasty in the oropharyngeal size and in the position of the hyoid bone and tongue. METHODS: The sample comprised 22 lateral cephalometric radiographs of 11 individuals who had undergone advancement genioplasty alone. Eleven of these radiographs depicted the immediate preoperative period (T0) and the other 11 the postoperative period after at least four months (T1). The radiographs were scanned and exported to the Radiocef Studio 2.0® software (Radio Memory Ltda., Belo Horizonte, MG, Brazil). The landmarks were then identified and automatically measured by the program. RESULTS: The results showed statistically significant differences between the horizontal position of the hyoid bone and tongue and in the oropharyngeal size. The hyoid bone and tongue were repositioned anteriorly after surgery (p = 0.01), thereby increasing the dimension of the oropharyngeal airspace (p = 0.01). CONCLUSIONS: The oropharyngeal dimension increased as the tongue base and hyoid bone were repositioned more anteriorly.

Evaluation of buccal bone coverage in the anterior region by cone-beam computed tomography.

INTRODUCTION: The purpose of this study was to compare the sensitivity of diagnoses of buccal bone coverage in anterior teeth between axial and sagittal reconstructions using cone-beam computed tomography. METHODS: Five dry skulls were clinically evaluated to detect bone defects in the anterior maxilla and mandible to establish a gold standard. The skulls were prepared and placed on a Kodak 9000 3-dimensional scanner (Trophy, Marne La Vallée, France) for image acquisition. The images were processed and reconstructed using Kodak Dental Imaging software 3-dimensional module (version 2.4; Kodak Dental Systems, Atlanta, Ga). All bone defects were identified and recorded. RESULTS: In the sagittal and axial reconstructions, regions without bone coverage were diagnosed in 91.03% of cases as "cortex not seen" or "minimum thickness, fine, without marrow bone." CONCLUSIONS: Cone-beam computed tomography can help in the diagnosis of lack of bone coverage on the buccal surfaces of anterior teeth. There was no difference in the performance of the axial and sagittal reconstructions.

Brachycephalic, dolichocephalic and mesocephalic: Is it appropriate to describe the face using skull patterns?

The use of a standardized terminology in the medical sciences is essential for both clinical practice and scientific research. In addition to facilitating communication between professionals, it enhances the reliability of comparisons made between studies from different areas, thereby contributing to a higher level of scientific evidence. Examples of attempts made to standardize the terminology in other areas dedicated to the study of craniofacial morphology can be found in the literature. On the other hand, one can find in the orthodontic literature a variety of terms that render the consensus and communication between orthodontists and other researchers even more problematic. As an example, one could cite the use of the terms brachyfacial, mesofacial and dolichofacial, which form part of a cranial index terminology used to describe facial types. Thus, a reflection on the origin and differences of the terms used to describe the human facial phenotype may pave the way toward a consensus regarding the meaning that best represents the craniofacial patterns.

Effect of dental bleaching after bracket bonding and debonding using three different adhesive systems.

OBJECTIVE: To evaluate the influence of bonding and debonding of orthodontic brackets on dental in-home bleaching, taking into account three different adhesive systems. METHODS: Forty-four bovine incisors were divided into four groups according to the primer system used for orthodontic bracket bonding. Following the debonding of orthodontic brackets, the teeth were stored in staining solution for 96 hours. Then, teeth were whitened using 10% carbamide peroxide for two weeks at a 6-hour-a-day regime. Standardized digital photographs were taken at the following intervals: T0 (initial); T1 (after debonding); T2 (after pigmentation); T3, T4 and T5 representing 1, 7, and 14 days of bleaching. Repeatability and stability tests were carried out to check the method accuracy. Images were analyzed using Adobe Photoshop 7.0 software considering (L*a*b*) color coordinate values and a modified color difference total (ΔE'). RESULTS: The results of this study (ANOVA and Tukey; p < 0.01) demonstrated that after 7 days of bleaching, experimental groups showed significantly less teeth whitening compared to the control group. However, there were no significant color differences between the groups after 14 days, according to values of lightness (L*). CONCLUSIONS: Regardless of the adhesive primer system applied, bonding and debonding of orthodontic brackets alters the outcome of tooth whitening in the first 7 days of bleaching, however it has no influence on the whitening of the dental structure after 14 days of in-home dental bleaching with 10% carbamide peroxide.

Benefits of the use of the CO2 laser in orthodontics.

Esthetics is an important factor for patients seeking orthodontic treatment, and not always is the orthodontist able to make adjustments on the gingival contour, and this aspect is neglected. Many orthodontists are familiar with the name laser. However, there is a lack of information regarding their application on the orthodontic practice. There are several options for the use of CO(2) lasers on surgical procedures of interest to orthodontists, especially on soft tissues. There is no evidence that the use of the CO(2) laser has any side effect or contraindication on surgical procedures. This paper reports a series of surgical procedures carried out on orthodontic patients. It is concluded that the carbon dioxide laser not only allows surgeons to enhance current surgical options for treatment but also have contributed to the evolution of a variety of new procedures that are now commonplace in oral surgery, and its use shows several benefits for the orthodontic patient.

Use of the CO(2) laser on orthodontic patients suffering from gingival hyperplasia.

OBJECTIVE: The present study aimed to assess the effect of the use of the CO(2) laser on the treatment of gingival hyperplasia in orthodontic patients wearing fixed appliances. BACKGROUND DATA: Gingival hyperplasia is a condition very frequent in patients undergoing fixed orthodontic treatment. Amongst the treatments available for this is the use of surgical lasers. METHODS: Ten patients entered this study and signed an informed consent. Seventy-five anterior teeth with gingival hyperplasia were selected for laser surgery. Prior to surgery, the length of the crowns were measured using a digital caliper, and depth of the pocket was probed. The hyperplasic gingival was removed with a CO(2) laser under local anesthesia. Immediately after surgery, measurement of the length of the crowns and probing were carried out and were repeated. RESULTS: The results were statistically analyzed and significant differences were detected regarding the length of the crown (p = 0.000) and depth of the gingival sulcus (p = 0.000). CONCLUSION: It is concluded that the use of the CO(2) laser was effective in the treatment of gingival hyperplasia.