On the use of electrokinetic phenomena of the second kind for probing electrode kinetic properties of modified electron-conducting surfaces.

The electrokinetic features of electron-conducting substrates, as measured in a conventional thin-layer electrokinetic cell, strongly depend on the extent of bipolar faradaic depolarisation of the interface formed with the adjacent electrolytic solution. Streaming potential versus applied pressure data obtained for metallic substrates must generally be interpreted on the basis of a modified Helmholtz-Smoluchowski equation corrected by an electronic conduction term-non linear with respect to the lateral potential and applied pressure gradient-that stems from the bipolar electrodic behavior of the metallic surface. In the current study, streaming potential measurements have been performed in KNO(3) solutions on porous plugs made of electron-conducting grains of pyrite (FeS(2)) covered by humic acids. For zero coverage, the extensive bipolar electronic conduction taking place in the plug-depolarized by concomitant and spatially distributed oxidation and reduction reactions of Fe(2+) and Fe(3+) species-leads to the complete extinction of the streaming potential over the entire range of applied pressure examined. For low to intermediate coverage, the local electron-transfer kinetics on the covered regions of the plug becomes more sluggish. The overall bipolar electronic conduction is then diminished which leads to an increase in the streaming potential with a non-linear dependence on the pressure. For significant coverage, a linear response is observed which basically reflects the interfacial double layer properties of the humics surface layer. A tractable, semi-analytical model is presented that reproduces the electrokinetic peculiarities of the complex and composite system FeS(2)/humics investigated. The study demonstrates that the streaming potential technique is a fast and valuable tool for establishing how well the electron transfer kinetics at a partially or completely depolarised bare electron-conducting substrate/electrolyte solution interface is either promoted (catalysis) or blocked (passivation) by the presence of a discontinuous surface layer.

A 'dry' condensation origin for circumstellar carbonates.

The signature of carbonate minerals has long been suspected in the mid-infrared spectra of various astrophysical environments such as protostars. Abiogenic carbonates are considered as indicators of aqueous mineral alteration in the presence of CO2-rich liquid water. The recent claimed detection of calcite associated with amorphous silicates in two planetary nebulae and protostars devoid of planetary bodies questions the relevance of this indicator; but in the absence of an alternative mode of formation under circumstellar conditions, this detection remains controversial. The main dust component observed in circumstellar envelopes is amorphous silicates, which are thought to have formed by non-equilibrium condensation. Here we report experiments demonstrating that carbonates can be formed with amorphous silicates during the non-equilibrium condensation of a silicate gas in a H2O-CO2-rich vapour. We propose that the observed astrophysical carbonates have condensed in H2O(g)-CO2(g)-rich, high-temperature and high-density regions such as evolved stellar winds, or those induced by grain sputtering upon shocks in protostellar outflows.

Characterization of activated sludge exopolymers from various origins: a combined size-exclusion chromatography and infrared microscopy study.

High-pressure size-exclusion liquid chromatography and infrared microscopy were coupled to investigate the molecular weight and nature of extracellular polymeric substances (EPS) from various activated sludges. Six main families of compounds (proteins, polysaccharides, organic acids, lipids, mineral phases) were found either as a single molecule or as associations. The molecular weight of proteins varied from small (10 kDa) to large (600 kDa) sizes, while all polysaccharides were smaller than 1 kDa. Association of different molecules implied the presence of species large in size. The EPS chromatographic fingerprints of sludge from various origins remained stable in normal operating conditions, but were drastically modified during settling crises. In poor settling conditions, the EPS with smaller molecular sizes always prevailed and large polymers were underrepresented. The EPS identified in activated sludge were collected in a chemical database which provides the basis for comparison of municipal and industrial wastewater treatment plants (WWTP).

Kinetics of salicylic acid adsorption on activated carbon.

The adsorption and desorption of salicylic acid from water solutions was investigated in HPLC microcolumns packed with activated carbon. The adsorption isotherm was obtained by the step-up frontal analysis method in a concentration range of 0-400 mg/L and was well fitted with the Langmuir equation. The investigation of rate aspects of salicylic acid adsorption was based on adsorption/desorption column experiments where different inlet concentrations of salicylic acid were applied in the adsorption phase and desorption was conducted with pure water. The concentration profiles of individual adsorption/desorption cycles data were fitted using several single-parameter models of the fixed-bed adsorption to assess the influence of different phenomena on the column behavior. It was found that the effects of axial dispersion and extraparticle mass transfer were negligible. A rate-determining factor of fixed-bed column dynamics was the kinetics of pore surface adsorption. A bimodal kinetic model reflecting the heterogeneous character of adsorbent pores was verified by a simultaneous fit of the column outlet concentration in four adsorption/desorption cycles. The fitted parameters were the fraction of mesopores and the adsorption rate constants in micropores and mesopores, respectively. It was shown that the former rate constant was an intrinsic one whereas the latter one was an apparent value due to the effects of pore blocking and diffusional hindrances in the micropores.

Infrared spectroscopy of OD vibrators in minerals at natural dilution: hydroxyl groups in talc and kaolinite, and structural water in beryl and emerald.

An infrared (IR) study of natural deuteration is conducted on minerals containing hydroxyl groups (talc and kaolinite) and channel-water-bearing minerals (beryl and emerald). In talc, the OD valence vibration is located at 2710 cm(-1), corresponding to OD groups surrounded by 3 Mg atoms. In kaolinite, the OD valence vibrations are located at 2671 cm(-1) (inner OD group), 2712, 2706, and 2700 cm(-1) (three inner-surface OD groups). In beryl and emerald, natural deuteration of channel water is observed for the first time by infrared microspectroscopy. In beryl from Minas Gerais (Brazil), the OD profiles are characterized by four bands at 2735, 2686, 2672, and 2641 cm(-1). In emeralds from Colombia and Brazil, the OD profiles are characterized by five or four bands, respectively, at 2816, 2737, 2685, 2673, and 2641 cm(-1) (Colombia) and 2730, 2684, 2672, and 2640 cm(-1) (Brazil). The band at 2816 cm(-1) can be assigned to -OD or OD(-), and bands at 2686-2684, 2673-2672, and 2641-2640 cm(-1) can be assigned to type-I and type-II HOD molecules. The band at 2737-2730 cm(-1) is partially disturbed by combination bands of the mineral. Such OD profiles are different from those obtained by artificial deuteration at higher OD dilution.

Study of tropaeolin degradation by iron--proposition of a reaction mechanism.

The degradation of tropaeolin by iron was studied under oxidizing and inert atmospheres. The products were identified by various chromatographic and spectroscopic methods. Under inert atmosphere, the proposed model of mechanism is based on the adsorption of tropaeolin by the sulfonate function on the solid iron, followed by a reduction of the [bond]Nz[double bond]N[bond] bond with formation of 1-amino-2-naphthol and sulfanilic acid. These two intermediaries were reduced to 1,2-dihydroxynaphthalene and benzene with NH(4)(+) and HSO(3)(-) liberation. Under oxidizing atmosphere, besides the reductions of tropaeolin, water and ferric ions, the existence of a homogeneous degradation was found. This process was explained (on the basis of surface iron potential monitoring) by a stepwise reduction of oxygen giving hydrogen peroxide. The initial stages of the mechanism were similar to those under inert atmosphere, but the degradation of the 1,2-dihydroxynaphthalene continued giving 1,2-naphthalenedione, then various polar monocyclic compounds leading to three unidentified volatile final products.

Activated sludge exopolymers: separation and identification using size exclusion chromatography and infrared micro-spectroscopy.

Extracellular polymeric substances were extracted from activated sludge using a resin exchange method and analyzed. The separation and identification of EPS were carried out by size exclusion chromatography and Fourier transform infrared micro-spectroscopy. Chromatograms of extracted EPS exhibited seven peaks. Proteins varying in molecular weights from 670 to 45 kDa were present in all the peaks. Polysaccharides corresponding to molecular weights of approximately 1 and approximately 0.5 kDa were present in only three peaks. Strong association of polysaccharides and proteins was observed. Infrared results revealed the presence of one type of polysaccharide and two types of proteins (A and B). Proteins differed mainly in the length of their associated alkyl chains and in the ratio of ester/acidic functionalities.

Use of treated bark for the removal of lipids from water.

Raw, biologically treated bark and bark impregnated with transition metal ions were used to retain the lipids from synthetic emulsions. Several experimental parameters affecting the lipid removal efficiency (RE) were studied (initial concentration of lipids, temperature, time, pH, carboxylic acid chain length, etc.). Saturated bark was characterized using Fourier transform infrared (FTIR) spectroscopy and light microscopy, and the treated bark wetting index was determined. Results show that lipid removal can exceed 95% of the initial concentration at a pH lower than 7. The uptake of lipids by these sorbents varied from 0.2 to 2.5 g/g of dry bark. Trials for regenerating the sorbent saturated by lipids allowed the recovery of approximately 95% of lipids. The calorific value of the saturated bark was approximately 79% that of domestic fuel and can be considered as an energy source, thus avoiding its waste disposal. These results may upgrade the treatment of wastewater generated by several industrial sectors, such as the food industry, surface treatment, and so on.