RESUMO
This study investigates the influence of the main process parameters of injection molding(mold temperature, melt temperature, and injection rate) on the appearance of defects of flake-pigmented metallic polymer parts. To understand the influence of process parameters, an appearance defects index (ADI) is proposed to quantify the appearance defects. In this process, we propose a criterion for judging the appearance of defects based on the results of fiber orientation and tensor distribution analyses of the skin layer, which is then verified analytically by simulating experiments from the literature. Using the Taguchi experimental method, we designed an L25 orthogonal array to systematically evaluate the influence of process parameters. For each experimental condition, the signal-to-noise ratio (S/N ratio) was calculated to determine the optimal level of each factor and its influence on the appearance of defects. According to the results, mold temperature has the greatest influence on the appearance of defects, with an influence of 48.7%, followed by injection rate with an influence of 40.8%, and melt temperature with an influence of 10.5%. The optimal process parameters were found to be a mold temperature of 40 °C, a melt temperature of 250 °C, and an injection rate of 10 cm3/s, which resulted in a 12.6% improvement in the Appearance defects index (ADI) compared to the standard injection molding condition of ABS materials. This study confirmed that it is possible to improve the appearance of defects by adjusting the process parameters of injection molding.