A Study on Enhanced Electrorheological Performance of Plate-like Materials via Percolation Gel-like Effect.

The use of plate-like materials to induce a percolation gel-like effect in electrorheological (ER) fluids is sparsely documented. Hence, we dispersed plate-like materials, namely natural mica, synthetic mica, and glass, as well as their pulverized particles, in various concentrations in silicone oil to form ER fluids. Subsequently, the rheological properties of the fluids were evaluated and compared to identify the threshold concentration for percolating a gel-like state. The shear stress and viscoelastic moduli under zero-field conditions confirmed that plate-like materials can be used to induce percolation gel-like effects in ER fluids. This is because of the high aspect ratio of the materials, which enhances their physical stability. In practical ER investigations, ER fluids based on synthetic mica (30.0 wt%) showed the highest yield stress of 516.2 Pa under an electric field strength of 3.0 kV mm-1. This was attributed to the formation of large-cluster networks and additional polarization induced by the ions. This study provides a practical approach for developing a new type of gel-like ER fluid.

Rheology of Gels and Yielding Liquids.

In this review, today's state of the art in the rheology of gels and transition through the yield stress of yielding liquids is discussed. Gels are understood as soft viscoelastic multicomponent solids that are in the incomplete phase separation state, which, under the action of external mechanical forces, do not transit into a fluid state but rupture like any solid material. Gels can "melt" (again, like any solids) due to a change in temperature or variation in the environment. In contrast to this type of rheology, yielding liquids (sometimes not rigorously referred to as "gels", especially in relation to colloids) can exist in a solid-like (gel-like) state and become fluid above some defined stress and time conditions (yield stress). At low stresses, their behavior is quite similar to that of permanent solid gels, including the frequency-independent storage modulus. The gel-to-sol transition considered in colloid chemistry is treated as a case of yielding. However, in many cases, the yield stress cannot be assumed to be a physical parameter since the solid-to-liquid transition happens in time and is associated with thixotropic effects. In this review, special attention is paid to various time effects. It is also stressed that plasticity is not equivalent to flow since (irreversible) plastic deformations are determined by stress but do not continue over time. We also discuss some typical errors, difficulties, and wrong interpretations of experimental data in studies of yielding liquids.

Correlation of Structure and Dynamics Behavior in Polyzwitterions: From Concentrated Solution to Gel-Like State.

The dynamic behaviors of polyzwitterions, poly(4-((3-methacrylamidopropyl) dimethylammonio) butane-1-sulfonate) (PSBP), are investigated using dynamic light scattering, small angle X-ray scattering, and rheology.  The findings reveal two relaxation modes, including a fast and a slow mode, which  are observed in both solution state and gel-like state, with varying polyzwitterion concentration (CP ) and NaCl concentration (CNaCl ). As CP and CNaCl increasing, a slower slow mode and a faster fast mode are observed. The fast mode corresponds to the diffusion of chains, while the slow mode arises from chain aggregations. In solutions, the slow mode is dominated by the diffusion of chain aggregations. However, in the gel-like state, the "cage network" traps aggregations more densely, leading to their dynamic behavior being dominated by enhanced topological entanglements and ionic interactions. This difference highlights the unique nature of the slow relaxation mode between concentrated solution and gel-like state, arising from changes in the average distance between chain aggregations resulting from increased CP and CNaCl concentrations.