Polymerization of Epoxides at a Static Oil-Alkaline Water Interface.

'On-water' catalysis entails the significant enhancement of a chemical reaction by water, even when those reactions are known to be water-sensitive. Here, the findings about the anionic ring opening polymerization of epoxides at the static interface between oil and alkaline water are shared. Unexpectedly, high molar mass fractions are observed with the interfacial system presented herein, albeit at very low conversions (< 5%). Styrene oxide, a notably unreactive epoxide, is chosen as the model compound to investigate the influence of several reaction parameters (i.e., pH, type of the initiator salt, polymerization time, interfacial area, solvent, shaking) on the polymerization. Poly(styrene oxide) (PSO) with an Mn of 5300 g mol-1 is observed via MALDI-ToF MS, with species of at least 8000 g mol-1. The feasibility of expanding the system to (cyclic) aliphatic and aromatic epoxides, and glycidyl ethers is also explored. The system appears to promote polymerization of epoxides that position at the interface, in such a way that initiation and propagation can occur. A mechanistic interpretation of the interfacial polymerization is suggested. The surprising results obtained in this work urge to revisit the role of water in ionic polymerizations.

Styrene lung cancer risk assessment: an alternative evaluation of human lung cancer risk assuming mouse lung tumors are potentially human relevant and operating by a threshold-based non-genotoxic mode of action.

Rodent inhalation studies indicate styrene is a mouse lung-specific carcinogen. Mode-of-action (MOA) analyses indicate that the lung tumors cannot be excluded as weakly quantitatively relevant to humans due to shared oxidative metabolites detected in rodents and humans. However, styrene also is not genotoxic following in vivo dosing. The objective of this review was to characterize occupational and general population cancer risks by conservatively assuming mouse lung tumors were relevant to humans but operating by a non-genotoxic MOA. Inhalation cancer values reference concentrations for respective occupational and general population exposures (RfCcar-occup and RfCcar-genpop) were derived from initial benchmark dose (BMD) modeling of mouse inhalation tumor dose-response data. An overall lowest BMDL10 of 4.7 ppm was modeled for lung tumors, which was further duration- and dose-adjusted by physiologically based pharmacokinetic (PBPK) modeling to derive RfCcar-occup/genpop values of 6.2 ppm and 0.8 ppm, respectively. With the exception of open-mold fiber reinforced composite workers not using personal protective equipment (PPE), the RfCcar-occup/genpop values are greater than typical occupational and general population human exposures, thus indicating styrene exposures represent a low potential for human lung cancer risk. Consistent with this conclusion, a review of styrene occupational epidemiology did not support a conclusion of an association between styrene exposure and lung cancer occurrence, and further supports a conclusion that the conservatively derived RfCcar-occup is lung cancer protective.