Greater early postprandial suppression of endogenous glucose production and higher initial glucose disappearance is achieved with fast-acting insulin aspart compared with insulin aspart.

AIM: To investigate the mechanisms behind the lower postprandial glucose (PPG) concentrations achieved with fast-acting insulin aspart (faster aspart) than with insulin aspart (IAsp). MATERIALS AND METHODS: In a randomized, double-blind, crossover trial, 41 people with type 1 diabetes received identical subcutaneous single faster aspart and IAsp doses (individualized for each participant), together with a standardized mixed meal (including 75 g carbohydrate labelled with [1-13 C] glucose). PPG turnover was determined by the triple-tracer meal method using continuous, variable [6-3 H] glucose and [6,6-2 H2 ] glucose infusion. RESULTS: Insulin exposure within the first hour was 32% greater with faster aspart than with IAsp (treatment ratio faster aspart/IAsp 1.32 [95% confidence interval {CI} 1.18;1.48]; P < .001), leading to a 0.59-mmol/L non-significantly smaller PPG increment at 1 hour (ΔPG1h ; treatment difference faster aspart-IAsp -0.59 mmol/L [95% CI -1.19; 0.01]; P = .055). The trend towards reduced ΔPG1h with faster aspart was attributable to 12% greater suppression of endogenous glucose production (EGP; treatment ratio 1.12 [95% CI 1.01; 1.25]; P = .040) and 23% higher glucose disappearance (1.23 [95% CI 1.05; 1.45]; P = .012) with faster aspart than with IAsp during the first hour. Suppression of free fatty acid levels during the first hour was 36% greater for faster aspart than for IAsp (1.36 [95% CI 1.01;1.88]; P = .042). CONCLUSIONS: The trend towards improved PPG control with faster aspart vs IAsp in this study was attributable to both greater early suppression of EGP and stimulation of glucose disappearance.

Investigation of the Physico-Chemical Properties that Enable Co-Formulation of Basal Insulin Degludec with Fast-Acting Insulin Aspart.

PURPOSE: To study the self-association states of insulin degludec and insulin aspart alone and combined in pharmaceutical formulation and under conditions simulating the subcutaneous depot. METHODS: Formulations were made of 0.6 mM degludec at 3 and 5 Zn/6 insulin monomers, and 0.6 mM aspart (2 Zn/6 insulin monomers). Self-association was assessed using size-exclusion chromatography (SEC) monitored by UV and orthogonal reverse-phase chromatography. RESULTS: Simulating pharmaceutical formulation, degludec eluted as dihexamers, whereas aspart eluted as hexamers and monomers. Combining degludec at low zinc with aspart increased dihexamer content, indicating hybrid hexamer formation. At high zinc concentration, however, there was no evidence of this. Simulating the subcutaneous depot by removing preservative, degludec eluted as multihexamers and aspart as monomers. Aspart was incorporated into the multihexamer structures when combined with degludec at low zinc, but there was no such interaction with high-zinc degludec. SEC using progressively diluted concentrations of phenol and m-cresol showed that dissociation of aspart into monomers occurs before the formation of degludec multihexamers. CONCLUSION: Insulins degludec and aspart can be combined without forming hybrid hexamers, but this combinability is dependent on zinc and preservative concentration, and requires that degludec is fully dihexameric before addition of aspart.

Faster in and faster out: accelerating insulin absorption and action by insulin infusion site warming.

OBJECTIVE: This study was undertaken to investigate the effect of an insulin infusion site warming device, the InsuPatch(40)(™) (IP(40)) (InsuLine Medical Ltd., Petach-Tikvah, Israel), on insulin aspart pharmacodynamics (PD) and pharmacokinetics (PK) in adolescents with type 1 diabetes. SUBJECTS AND METHODS: Seventeen subjects with type 1 diabetes (age, 15±1 years; hemoglobin A1c, 7.5±0.2% [58±2.2 mmol/mol]) underwent two euglycemic clamps performed on separate mornings with and without IP(40) activation with warming temperature at 40°C. On both days, the basal infusion was suspended, and glucose levels were maintained between 90 and 100 mg/dL by a variable rate dextrose infusion for up to 5 h after a 0.2 U/kg bolus of insulin aspart. RESULTS: Time to peak insulin action and time to half-maximal action occurred earlier with a greater early glucodynamic effect (area under the curve [AUC] for glucose infusion rate from 0 to 30 min) with IP(40) than without the IP(40), whereas the AUC for the time-action profile and the peak action did not differ with and without infusion site warming. PK parameters were in agreement with PD parameters, namely, a significantly earlier time to reach the maximum increment in insulin concentrations and greater early bioavailability (AUC for the change in insulin concentration from 0 to 30 min) with the IP(40). The tail of the plasma insulin response curve was also shortened with infusion site warming, with the time to reach baseline insulin concentration occurring significantly earlier (P=0.04). CONCLUSIONS: Our data demonstrate that skin warming around the infusion site to 40°C with the IP(40) is an effective means to accelerate absorption and action of rapid-acting insulin. These improvements in time-action responses have the potential to enhance the performance of open- and closed-loop insulin delivery systems.

A T3R3 hexamer of the human insulin variant B28Asp.

Insulin shows a complex equilibrium between monomers and hexamers, involving varying conformers and association states. We sought to perform a structural characterization of the fast-acting human insulin variant B28Asp ("aspart"). Small-angle X-ray scattering measurements reveal similar globular behavior in both the aspart and regular human insulin, with a Rg of 19Å and a Dmax of approximately 50Å, indicating similar mean quaternary assembly distribution. Crystallographic assays revealed a T3R3 assembly of the aspart insulin formed by the TR dimer in the asymmetric unit, with all the first 8 residues of the B chain in the R-state monomer in helical conformation and the participation of its B3Asn in the stabilization of the hexamer. Our data provide access to novel structural information on aspart insulin such as an aspart insulin dimer in solution, the aspart insulin in T conformation and a pure R-state conformer establishing a T3R3 assembly, providing further insight on the stepwise conformational transition and assembly of this fast-insulin.