Unraveling Ammonia and Trimethylamine Uptake on Conductive Doped Polyaniline.

ABSTRACT

Polyaniline (PAni)-based sensors are a promising solution for ammonia (NH3) detection at the ppb level. However, the nature of the NH3-PAni interaction and underlying drivers remain unclear. This paper proposes to characterize the interaction between doped PAni (dPAni) sensing material and NH3 by using a Knudsen cell. First, to characterize the dPAni interface, the probe-gas method, i.e., titration of surface sites with a gas of specific properties, is deployed. The dPAni interface is found to be homogeneous with more than 96% of surface sites of acid nature or with hydroxyl functional groups. This result highlights that basic gases such as amines might act as interfering gases for NH3 detection by polyaniline-based sensors. Second, the adsorption isotherms of NH3 and trimethylamine (TMA) on dPAni are reported at ambient temperature conditions, 293 K. The uptake of NH3 and TMA on dPAni follows a Langmuir-type behavior. This approach allows for the first time to quantify the uptake of NH3 and TMA on gas-sensor materials and determine typical Langmuir adsorption parameters, i.e., the partitioning coefficient, KLang, and the maximum surface coverage, Nmax. The corresponding values obtained for NH3 and TMA are Klang (NH3) = 19.7 × 10-15 cm3 molecules-1 Nmax (NH3) = 11.6 × 1014 molecules cm-2, KLang (TMA) = 7.0 × 10-15 cm3 molecules-1 Nmax (TMA) = 5.0 × 1014 molecules cm-2. KLang and Nmax values of NH3 are higher than those of TMA, suggesting that NH3 is more efficiently taken up than TMA on dPAni. The results of this work suggest that strong hydrogen bonding drives the performance of a polyaniline-based gas sensor for NH3 and amines. In conclusion, the Knudsen cell approach allows reconsidering the fundamentals of NH3 interactions with dPAni and provides new insights on drivers to enhance sensing properties.