Effect of carbonaceous fillers on adsorption behavior of multifunctional diatomite-based foams for wastewater treatment.

Nowadays the study of the potential applications of multifunctional materials for environmental remediation is one of the main goals of the materials engineering. Multifunctional porous materials, MPMs, incorporate, all in once, different and multiple functionalities that make them suitable for several uses and can satisfy many purposes at the same time. Multifunctional diatomite-based foams with a hierarchical porosity, already produced and characterized to be applied in building as well as aerospace sectors, are proposed as adsorbents for inorganic and organic pollutants removal from wastewaters. Then, the effect of the addition of different carbonaceous nanofillers (graphite, graphene and graphene oxide) on the water purification efficiency of the adsorbent was evaluated. Firstly, pristine MPM showed the best performance in adsorbing Indigo Carmine due to its intrinsic chemism and hierarchical porosity (at macro-, micro- and nano-level), but it is not the best with respect to the Cd2+ adsorption, if compared with the nanocomposites. Among the nanocomposite products, both graphene- and graphene oxide-MPM samples showed a significantly improved adsorption capacity towards Cd2+. This behavior is due to the synergistic effect of the finer morphology, higher available foam surface, and the highly exfoliated fillers, graphene and graphene oxide, which permit a better dispersion into the matrix.

Optimization of dye adsorption capacity and mechanical strength of chitosan aerogels through crosslinking strategy and graphene oxide addition.

Chitosan (CS) aerogels were prepared by freeze-drying as potential adsorbents for water purification, and the effect of the strategy of crosslinking was investigated by varying the amount of crosslinker (glutaraldehyde) and the sequence of steps for the preparation of the aerogel. Two procedures were compared, in which the crosslinking step was carried out before or after the freeze-drying of the starting CS solution. When crosslinking was postponed after the freeze-drying step, the adsorption capacity towards an anionic dye, such as indigo carmine, considerably increased (up to +45%), reaching values as high as 534.4 ± 30.5 mg g-1. The same crosslinking strategy ensured a comparable improvement also in nanocomposite aerogels containing graphene oxide (GO), which was added to enhance the mechanical strength and provide adsorption capacity towards cationic dyes. Besides possessing good mechanical strength (compressive modulus higher than 1 MPa), the CS/GO aerogels were able to bind also cationic pollutants such as methylene blue. The maximum uptake capacity increased from 4.3 ± 1.6 to 168.6 ± 9.6 mg of cationic dye adsorbed per gram of adsorbent with respect to pristine CS aerogels.

[Evaluation of the efficacy of L-acetylcarnitine and tiapride combination in elderly patients with behavioral disorders]. / Valutazione dell'efficacia dell'associazione L-acetilcarnitina, tiapride nel paziente anziano con disturbi comportamentali.

The study assessed the efficacy of the association of L-AC and tiapride in the treatment of behavioural and psychiatric symptoms due to cerebral decay. The study included 60 subjects, aged 65-80, who were subdivided into treated and control groups. Inclusion criteria included no previous psychiatric history and no general illness. Results demonstrate the usefulness of the association of the two drugs studied.