Effect of calcanean bone-tunnel orientation for teno-osseous repair in a canine common calcanean tendon avulsion model.

OBJECTIVE: To determine the influence of bone-tunnel anchoring technique on teno-osseous repair of the common calcanean tendon (CCT) in dogs. STUDY DESIGN: Randomized, ex vivo, biomechanical. POPULATION: Forty-two skeletally mature canine hindlimbs. METHODS: Canine hindlimbs were dissected to produce a model simulating avulsion of the CCT and accessory tendons from the calcaneus. Hindlimbs were randomized to 1 of 3 anchoring techniques (n = 14/group): a single transverse tunnel (TT), vertical tunnels (VT), or modified bone tunnels (MT) for teno-osseous repair in a 3-loop-pulley (3LP) pattern using 0 USP polypropylene. Yield, peak and failure loads, construct stiffness, loads to produce a 3 mm teno-osseous gap, and failure modes were compared between groups. RESULTS: The only difference detected consisted of TT constructs yielding at loads 25% higher than MT constructs (P = .027). CONCLUSION: Although yield loads were lower in MT constructs than other groups, the bone-tunnel anchoring techniques tested here did not appear to influence the biomechanical properties or gapping characteristics of teno-osseous repairs in this canine CCT avulsion model. CLINICAL SIGNIFICANCE: All drilling techniques and bone-tunnel orientations tested in the study reported here offer viable options to reattach the CCT to the calcaneus. Surgeons should evaluate how bone-tunnel orientation may affect placement of adjunctive fixation methods to stabilize the talocrural joint after primary CCT repair in dogs.

Loop modification of the traditional three-loop pulley pattern improves the biomechanical properties and resistance to 3-mm gap formation in a canine common calcanean teno-osseous avulsion model.

OBJECTIVE: To compare the biomechanical properties and gapping characteristics following loop modification of a 3-loop-pulley (3LP) pattern in an ex vivo canine common calcaneal tendon (CCT) avulsion repair model. SAMPLE: 56 skeletally mature hindlimbs from 28 canine cadavers. PROCEDURES: The CCTs were randomized to 1 of 4 experimental groups (n = 14/group) then sharply transected at the teno-osseous junction. Groups consisted of a 3LP, 4-loop-pulley (4LP), 5-loop-pulley (5LP), or 6-loop-pulley (6LP) pattern with loops placed 60° apart using size-0 polypropylene. Yield, peak, and failure loads, construct stiffness, loads to produce a 3-mm teno-osseous gap, and failure mode were evaluated and compared between groups. RESULTS: Yield (P = 0.001), peak (P < 0.001), and failure loads (P < 0.001), construct stiffness (P < 0.001), and loads to 3-mm gap formation (P = 0.005) were all significantly greater for 6LP compared to all other groups. Mode of failure did not differ among groups (P = 0.733) with 75% (42/56) of repairs failing by mechanism of core sutures pulling through the tendinous tissue. Pattern modification by increasing the number of loops increased the repair site strength by 1.4, 1.6, and 1.8 times for 4LP, 5LP, and 6LP compared to 3LP, respectively. CLINICAL RELEVANCE: Increasing the number of suture loops compared to a traditional 3LP repair is a relatively simple technique modification that significantly increases teno-osseous repair site strength and loads required to cause 3-mm gap formation. The results of this study justify further focused investigation of increasing the number of suture loops in vivo for teno-osseous CCT repair in dogs.