Integrated optical frequency division for microwave and mmWave generation.

The generation of ultra-low-noise microwave and mmWave in miniaturized, chip-based platforms can transform communication, radar and sensing systems1-3. Optical frequency division that leverages optical references and optical frequency combs has emerged as a powerful technique to generate microwaves with superior spectral purity than any other approaches4-7. Here we demonstrate a miniaturized optical frequency division system that can potentially transfer the approach to a complementary metal-oxide-semiconductor-compatible integrated photonic platform. Phase stability is provided by a large mode volume, planar-waveguide-based optical reference coil cavity8,9 and is divided down from optical to mmWave frequency by using soliton microcombs generated in a waveguide-coupled microresonator10-12. Besides achieving record-low phase noise for integrated photonic mmWave oscillators, these devices can be heterogeneously integrated with semiconductor lasers, amplifiers and photodiodes, holding the potential of large-volume, low-cost manufacturing for fundamental and mass-market applications13.

32-channel wide-bandwidth massive RF photonic combiner based on distributed groups of arrayed photodetectors.

We propose and experimentally demonstrate a low-loss, radio frequency (RF) photonic signal combiner with flat response from 1 GHz to 15 GHz and low group delay variation of 9 ps. The distributed group array photodetector combiner (GAPC) is implemented in a scalable Si photonics platform and has applications in RF photonic systems that rely on combining massive numbers of photonic signals.

Photonic generation of pulsed microwave signals in the X-, Ku- and K-band.

Photonic microwave generation of high-power pulsed signals in the X-, Ku- and K-band using charge-compensated MUTC photodiodes is demonstrated. The impulse photoresponse without modulation showed a maximum peak voltage of 38.3 V and full-width at half-maximum of 30 ps. High power pulsed microwave signals at 10, 17 and 22 GHz with peak power up to 44.2 dBm (26.3 W), 41.6 dBm (14.5 W) and 40.6 dBm (11.5 W) were achieved, respectively.

Photon-number-resolving segmented detectors based on single-photon avalanche-photodiodes.

We investigate the feasibility and performance of photon-number-resolved photodetection employing single-photon avalanche photodiodes (SPADs) with low dark counts. While the main idea, to split n photons into m detection modes with a vanishing probability of more than one photon per mode, is not new, we investigate here a important variant of this situation where SPADs are side-coupled to the same waveguide rather than terminally coupled to a propagation tree. This prevents the nonideal SPAD quantum efficiency from contributing to photon loss. We propose a concrete SPAD segmented waveguide detector based on a vertical directional coupler design, and characterize its performance by evaluating the purities of Positive-Operator-Valued Measures (POVMs) in terms of number of SPADs, photon loss, dark counts, and electrical cross-talk.

Heterogeneous photodiodes on silicon nitride waveguides.

Heterogeneous integration through low-temperature die bonding is a promising technique to enable high-performance III-V photodetectors on the silicon nitride (Si3N4) photonic platform. Here we demonstrate InGaAs/InP modified uni-traveling carrier photodiodes on Si3N4 waveguides with 20 nA dark current, 20 GHz bandwidth, and record-high external (internal) responsivities of 0.8 A/W (0.94 A/W) and 0.33 A/W (0.83 A/W) at 1550 nm and 1064 nm, respectively. Open eye diagrams at 40 Gbit/s are demonstrated. Balanced photodiodes of this type reach 10 GHz bandwidth with over 40 dB common mode rejection ratio.

40 Gbit/s waveguide photodiode using III-V on silicon heteroepitaxy.

Low-dark-current waveguide modified uni-traveling carrier photodiodes (PDs) are demonstrated by direct heteroepitaxy of InGaAs/InAlGaAs on silicon templates. The PDs have a dark current of 0.1 µA at -3V bias and an internal (external) responsivity of 0.78 A/W (0.27 A/W). The 3 dB bandwidth is 28 GHz, and open eye diagrams are detected at 40 Gbit/s.

Segmented waveguide photodetector with 90% quantum efficiency.

We demonstrate a novel InGaAsP/InP segmented waveguide photodetector based on directional couplers. By matching the imaginary parts of the propagation constants of the even and odd modes, we designed a photodetector with 6 elements, each with an absorber volume of only 19 µm3 and a bandwidth of 15 GHz, that has an internal quantum efficiency (QE) of 90% at 1550 nm wavelength corresponding to 1.13 A/W.

Low dark current III-V on silicon photodiodes by heteroepitaxy.

Top-illuminated PIN and modified uni-traveling carrier (MUTC) photodiodes based on InGaAs/InAlAs/InP were epitaxially grown on Si templates. Photodiodes with 30-µm diameter have dark currents as low as 10 nA at 3 V corresponding to a dark current density of only 0.8 mA/cm2. The responsivity, 3-dB bandwidth, output power and third-order output intercept point (OIP3) were 0.79 A/W, 9 GHz, 2.6 dBm and 15 dBm, respectively.

High-power flip-chip mounted photodiode array.

Four-element modified uni-traveling-carrier (MUTC) photodiode arrays (PDA) flip-chip bonded onto transmission lines on AlN substrates are demonstrated. High RF output powers of 26.2 dBm and 21.0 dBm are achieved at 35 GHz and 48 GHz, respectively, using a PDA with 28-µm diameter photodiodes. A systematic comparison between a PDA with four 20 µm-diameter elements and a discrete detector with the same active area (40-µm diameter) is presented. The PDA achieved higher output power and thermal dissipation compared to its discrete counterpart.

InP-based waveguide photodiodes heterogeneously integrated on silicon-on-insulator for photonic microwave generation.

High-linearity modified uni-traveling carrier photodiodes on silicon-on-insulator with low AM-to-PM conversion factor are demonstrated. The devices deliver more than 2.5 dBm RF output power up to 40 GHz and have an output third order intercept point of 30 dBm at 20 GHz. Photodiode arrays exceed a saturation current-bandwidth-product of 630 mA · GHz and reach unsaturated RF output power levels of 10 dBm at 20 GHz.

High-power high-linearity flip-chip bonded modified uni-traveling carrier photodiode.

We demonstrate a flip-chip bonded modified uni-traveling carrier (MUTC) photodiode with an RF output power of 0.75 W (28.8 dBm) at 15 GHz and OIP3 as high as 59 dBm. The photodiode has a responsivity of 0.7 A/W, 3-dB bandwidth > 15 GHz, and saturation photocurrent > 180 mA at 11 V reverse bias.

Dual-quadrature coherent receiver for 100G Ethernet applications based on polymer planar lightwave circuit.

A dual-quadrature coherent receiver based on a polymer planar lightwave circuit (PLC) is presented. This receiver comprises two separate optical 90°-hybrid chips made of polymer waveguides and hybridly integrated with InGaAs/InP photodiode (PD) arrays. The packaged receiver was successfully operated in 112 Gbit/s dual-polarization quadrature phase-shift keying (QPSK) transmission experiments. In back-to-back configuration the OSNR requirement for a BER value of 10(-3) was 15.1 dB which has to be compared to a theoretical limit of 13.8 dB.

Towards high-power, high-coherence, integrated photonic mmWave platform with microcavity solitons.

Millimetre-wave (mmWave) technology continues to draw great interest due to its broad applications in wireless communications, radar, and spectroscopy. Compared to pure electronic solutions, photonic-based mmWave generation provides wide bandwidth, low power dissipation, and remoting through low-loss fibres. However, at high frequencies, two major challenges exist for the photonic system: the power roll-off of the photodiode, and the large signal linewidth derived directly from the lasers. Here, we demonstrate a new photonic mmWave platform combining integrated microresonator solitons and high-speed photodiodes to address the challenges in both power and coherence. The solitons, being inherently mode-locked, are measured to provide 5.8 dB additional gain through constructive interference among mmWave beatnotes, and the absolute mmWave power approaches the theoretical limit of conventional heterodyne detection at 100 GHz. In our free-running system, the soliton is capable of reducing the mmWave linewidth by two orders of magnitude from that of the pump laser. Our work leverages microresonator solitons and high-speed modified uni-traveling carrier photodiodes to provide a viable path to chip-scale, high-power, low-noise, high-frequency sources for mmWave applications.

Measurement and modeling of high-linearity modified uni-traveling carrier photodiode with highly-doped absorber.

The third-order intermodulation distortions of InGaAs/InP modified uni-traveling carrier photodiodes with a highly-doped p-type absorber are characterized. The third-order local intercept point is 55 dBm at low frequency (< 3 GHz) and remains as high as 47.5 dBm up to 20 GHz. The frequency characteristics of the OIP3 are well explained by an equivalent circuit model.