RESUMO
Full-waveform hyperspectral LiDAR (FWHSL) is able to obtain spectral and spatial information by utilizing a single instrument, and it has become more and more commonly used in vertical distribution studies of structural and biochemical characteristics of vegetation. However, the pulse-echo arrival times of multiple spectral channels of the FWHSL are not consistent and this causes range ambiguity in spectral channels. In this paper, the pulse signal decay effect on range measurements was studied by measuring the varying trends of pulse signal decay between spectral channels with different material properties. The experiments were repeated at different distances. All of the spectral channels were compared for different materials. The results suggest that the channels in the red edge spectral region of vegetation have good stability and accuracy for range measurements of varied distance and materials properties. Finally, based on the geometric invariability in a specific red edge channel, a practical calibration approach for the pulse signal decay effect is also presented. The validation tests showed it could improve the pulse signal decay effect of full-waveform hyperspectral LiDAR.
RESUMO
Quantifying canopy light interception provides insight into the effects of plant spacing, canopy structure, and leaf orientation on radiation distribution. This is essential for increasing crop yield and improving product quality. Canopy light interception can be quantified using 3-dimensional (3D) plant models and optical simulations. However, virtual 3D canopy models (VCMs) have often been used to quantify canopy light interception because realistic 3D canopy models (RCMs) are difficult to obtain in the field. This study aims to compare the differences in light interception between VCMs and RCM. A realistic 3D maize canopy model (RCM) was reconstructed over a large area of the field using an advanced unmanned aerial vehicle cross-circling oblique (CCO) route and the structure from motion-multi-view stereo method. Three types of VCMs (VCM-1, VCM-4, and VCM-8) were then created by replicating 1, 4, and 8 individual realistic plants constructed by CCO in the center of the corresponding RCM. The daily light interception per unit area (DLI), as computed for the 3 VCMs, exhibited marked deviation from the RCM, as evinced by the relative root mean square error (rRMSE) values of 20.22%, 17.38%, and 15.48%, respectively. Although this difference decreased as the number of plants used to replicate the virtual canopy increased, rRMSE of DLI for VCM-8 and RCM still reached 15.48%. It was also found that the difference in light interception between RCMs and VCMs was substantially smaller in the early stage (48 days after sowing [DAS]) than in the late stage (70 DAS). This study highlights the importance of using RCM when calculating light interception in the field, especially in the later growth stages of plants.