RESUMO
Cascade transitions of Ho3+:5I6â5I7 and 5I7â5I8 provide a platform for a dual-wavelength mid-infrared (MIR) laser. In this paper, a continuous wave cascade MIR Ho:YLF laser operating at 2.1 and 2.9â µm is realized at room temperature. The total output power of 929â mW with 778â mW at 2.9â µm and 151â mW at 2.1â µm is obtained under the absorbed pump power of 5 W. Compared to the non-cascade mode, 2.9-µm lasing threshold is reduced by 10.3% and the slope efficiency is increased by 76.1% with the supports of cascade lasing at 2.1â µm. However, 2.9-µm lasing is the key population accumulation of the 5I7 level, which thus efficiently reduces the threshold and improves the output power of the 2.1-µm laser. Our results put forward a way for generating cascade dual-wavelength MIR lasing in Ho3+-doped crystals.
RESUMO
A high-quality black phosphorus (BP) saturable-absorber mirror (SAM) was successfully fabricated with the multi-layered BP, prepared by liquid-phase exfoliation (LPE) method. The modulation depth and saturation power intensity of BP absorber were measured to be 10.7% and 0.96 MW/cm(2), respectively. Using the BP-SAM, we experimentally demonstrated the mid-infrared (mid-IR) pulse generation from a BP Q-switched Cr:ZnSe laser for the first time to our best knowledge. Stable Q-switched pulse as short as 189 ns with an average output power of 36 mW was realized at 2.4 µm, corresponding to a repetition rate of 176 kHz and a single pulse energy of 205 nJ. Our work sufficiently validated that multi-layer BP could be used as an optical modulator for mid-IR pulse laser sources.
RESUMO
This paper proposes the concept of low dimensional optical beam and operator. In low dimensional space, beam (or operator) is decomposed into a limited number of orthogonalized low dimensional beams (or operators) through the singular value decomposition. It is possible to generate an unconventional beam by these low dimensional beams. Low dimensional operator allows independent operation of orthogonal dimensions which may produce greater freedoms. Storage space and computation resource are saved dramatically by using this method. Experimental realization of this scheme is briefly discussed at the end.
RESUMO
This study presents a high efficiency Ho:YAG laser based on a narrow linewidth tunable 1.91 µm laser. A tunable Tm:YLF laser is the pump source and the wavelength continuous tunability ranges from 1906.04 to 1908.83 nm, corresponding to a linewidth of less than 0.41 nm. The tunable Tm:YLF laser is achieved by changing the operating temperature of the VBG. The output power of the Ho:YAG laser is between 21.04 and 23.53 W and the slope efficiency is between 64.08 and 68.26% at the pump power of 39.8 W. The output power and slope efficiency corresponding to the pump wavelength of 1907.36 nm are 23.53 W and 68.26%, respectively. This study illustrates that fine-tuning the pump wavelength is an effective way to improve the slope efficiency and output power of the Ho:YAG laser at room temperature.
RESUMO
The widely tunable and high resolution mid-infrared laser based on a BaGa4Se7 (BGSe) optical parametric oscillator (OPO) was demonstrated. A wavelength tuning range of 2.76-4.64 µm and a wavelength tuning resolution of about 0.3 nm were obtained by a BGSe (56.3°, 0°) OPO, which was pumped by a 1064 nm laser. It is the narrowest reported wavelength tuning resolution for BGSe OPO, and was obtained by simultaneously controlling the angle and temperature of BGSe.