In vitro assessment of polychlorinated biphenyl bioaccessibility in meat: Influence of fat content, cooking level and consumer age on consumer uptake.

In a risk assessment perspective, this work aims to assess the bioaccessibility of PCBs in meat. A standardised in vitro static digestion protocol was set up and coupled with extraction, clean-up and GC × GC-ToF/MS multianalyte method to monitor the fate of PCBs in meat during digestion. Starting with spiked meat, PCB bioaccessibility in 11% fat medium-cooked meat varied in adults from 20.6% to 30.5% according to congeners. PCB bioaccessibility increased to 44.2-50.1% in 5% fat meat and decreased to 6.2-9.1% and to 14.6-19.4% in digestion conditions mimicking infants and elderly, respectively. Intense cooking also decreased PCB bioaccessibility to 18.0-26.7%. Bioaccessibility data obtained with spiked meat were validated with measurements carried out in incurred meat samples. Finally, mean uptake distributions are obtained from a modular Bayesian approach. These distributions feature a lower mode when the fat content is higher, the meat is well-done cooked, and the consumers are older.

Identification by volatolomics of hydrocarbon, oxygenated, sulfur and aromatic markers of livestock exposure to α-hexabromocyclododecane.

Volatile organic compounds (VOC)-based metabolomics, or volatolomics, was investigated for revealing livestock exposure to chemical contamination. Three farm animals, namely laying hens, broilers, and pigs, were experimentally exposed to 5 or 50 ng α-HBCDD g-1 feed. Liver and egg yolk for hens were analysed by headspace-SPME-GC-MS to reveal candidate markers of the livestock exposure to α-HBCDD. For hens, 2-butanol was found as marker in egg. In liver, twelve VOCs were highlighted as markers, with three aromatic VOCs - styrene, o-xylene, α-methylstyrene - highlighted for the two α-HBCDD doses. For broilers, six markers were revealed, with interestingly, styrene and phenol which were also found as markers in hen liver. For pigs, ten markers were revealed and the seven tentatively identified markers were oxygenated and sulfur VOCs. The candidate markers tentatively identified were discussed in light of previous volatolomics data, in particular from a γ-HBCDD exposure of laying hens.

Mitigation of heterocyclic aromatic amines in cooked meat. Part I: Informed selection of antioxidants based on molecular modeling.

This work aimed to develop a method permitting an informed choice of antioxidants to reduce carcinogenic heterocyclic aromatic amine (HAA) formation during proteinaceous food cooking. Therefore, a three-step approach was developed. First, the most promising antioxidants were selected using molecular modeling approaches. For this, analog design was used to highlight the most suitable antioxidants based on their diversification potential using bioisosteric replacement. Then, structure activity relationship studies allowed drawing the relevant properties for inhibiting HAA formation and explained partly the inhibitory activity. Secondly, the approved antioxidants were tested in ground beef patties to assess their inhibitory properties against HAA formation. Resveratrol was found to be the most efficient as it totally inhibited MeIQ and reduced MeIQx and PhIP formation by 40 and 70%, respectively. Finally, natural ingredients rich in these antioxidants were evaluated. Oregano was found to totally inhibit MeIQ formation and to reduce by half MeIQx and PhIP formation.

Liver volatolomics to reveal poultry exposure to γ-hexabromocyclododecane (HBCD).

Hexabromocyclododecane (HBCD) is a critical emerging brominated flame retardant to which consumers can be exposed at high doses through a single food intake. Based on an animal experiment involving 3 groups of laying hens fed during 70 days with a control diet or γ-HBCD-contaminated diets at 0.1 or 10 µg γ-HBCD g-1 feed, this study aims to use the volatolome of biological samples for revealing markers of livestock exposure to HBCD. Liquid chromatography-tandem mass spectrometry was used to monitor the time-course of HBCD levels in bodily samples. Each liver was analyzed by solid-phase microextraction-gas chromatography-mass spectrometry for volatolome profiling. After 70 days, γ-HBCD concentrations in egg yolk, fat, liver and serum reached 54 ± 4, 85 ± 6, 31 ± 6, and 32 ± 4 ng g-1 lw, respectively, for the low exposure level and 4.6+/5.7, 7.8+/6.5, 3.9+/3.0 and 3.9+/6.1 µg g-1 lw, respectively, for the high exposure level. Isomerization of γ-HBCD into α- and ß-HBCD was observed in all tissues, at least for the high exposure level. Volatolome data allowed a significant discrimination between control and exposed animals whatever the feed contamination load, demonstrating a liver metabolic response to γ-HBCD exposure. The relevance of the twenty nine volatile exposure markers tentatively identified was discussed in light of literature data.

Effects of pan cooking on micropollutants in meat.

This work presents the effects of pan cooking on PCBs, PCDD/Fs, pesticides and trace elements in meat from a risk assessment perspective. Three different realistic cooking intensities were studied. A GC×GC-TOF/MS method was set up for the multiresidue analysis of 189 PCBs, 17 PCDD/Fs and 16 pesticides whereas Cd, As, Pb and Hg were assayed by ICP-MS. In terms of quantity, average PCB losses after cooking were 18±5% for rare, 30±3% for medium, and 48±2% for well-done meat. In contrast, average PCDD/F losses were not significant. For pesticides, no loss occurred for aldrin, lindane, DDE or DDD, whereas losses exceeding 80% were found for dieldrin, sulfotep or phorate. Losses close to the margin of error were observed for trace elements. These results are discussed in light of the physicochemical properties of the micropollutants as well as of water and fat losses into cooking juice.

Assessment of comprehensive two-dimensional gas chromatography-time-of-flight mass spectrometry based methods for investigating 206 dioxin-like micropollutants in animal-derived food matrices.

This paper evaluates different multiresidue methods based on comprehensive two-dimensional gas chromatography coupled to time-of-flight mass spectrometry (GC×GC-TOF/MS) to analyze dioxin-related micropollutants in complex food matrices. In a first step, the column sets Rtx-PCB/BPX-50 and Rtx-Dioxin2/BPX-50 were compared in terms of peak shape (width and symmetry) and resolution for the separation of polychlorinated biphenyls (PCBs) and polychlorinated dibenzo-p-dioxins/dibenzofurans (PCDD/Fs) in solvent. A satisfactory separation of 206 dioxin-related micropollutants including the 17 toxic PCDD/Fs was achieved in 75 min with the column set Rtx-Dioxin2/BPX-50. In a second time, the GC×GC-TOF/MS method was spread to the analysis of dioxin-related micropollutants in complex food matrices. An extraction procedure including accelerated solvent extraction (ASE), centrifugal evaporation and gel permeation chromatography (GPC) was optimized. Starting with meat as a model matrix, a micropollutant spiking method was then set up by comparing seven methods in terms of recoveries and reproducibility. The method combining immersion of the meat in a large volume of solvent containing micropollutants followed by homogenization by blender induced recoveries in the acceptable range of 70-130% and satisfactory standard deviations (≤10%) for most of the compounds studied. Limits of detection of the GC×GC-TOF/MS method ranged between 50 and 100 pg/g of spiked fresh meat for PCBs and between 65 and 227 pg/g for PCDD/Fs. Potential applications of this method are discussed.

Benchmarking of candidate detectors for multiresidue analysis of pesticides by comprehensive two-dimensional gas chromatography.

The present study discusses the relevance, performance and complementarities of flame photometric detector in phosphorus (FPD/P) and sulfur (FPD/S) modes, micro electron capture detector (µECD), nitrogen phosphorus detector (NPD), flame ionization detector (FID) and time-of-flight mass spectrometer (TOF/MS) for the comprehensive two-dimensional gas chromatography (GC×GC) analysis of pesticides. A mix of 41 pesticides including organophosphorus pesticides, synthetic pyrethroids and fungicides was investigated in order to benchmark GC×GC systems in terms of linearity (R(2)), limits of detection (LOD), and peak shape measures (widths and asymmetries). A mixture of pesticides which contained the heteroatoms phosphorus, sulfur, nitrogen and one or several halogens, was used to acquire a comparative data set to monitor relative detector performances. GC×GC datasets were systematically compared to their GC counterpart acquired with an optimized one-dimensional GC configuration. Compared with FID, considered the most appropriate detector in terms of suitability for GC×GC, the element-selective detector FPD/P and µECD best met the peak widths (0.13-0.27s for FPD/P; 0.22-0.26s for µECD) and tailing factors (0.99-1.66 for FPD/P; 1.32-1.52 for µECD); NPD exhibited similar peak widths (0.23-0.30s), but exceeded those of the above detectors for tailing factors (1.97-2.13). These three detectors had improved detection limits of 3-7 times and 4-20 times lower LODs in GC×GC mode compared with FID and TOF-MS, respectively. In contrast FPD/S had poor peak shape (tailing factor 3.36-5.12) and much lower sensitivity (10-20 fold lower compared to FPD/P). In general, element-selective detectors with favorable detection metrics can be considered viable alternatives for pesticide determination using GC×GC in complex matrices. The controversial issue of sensitivity enhancement in GC×GC was considered for optimized GC and GC×GC operation. For all detectors, we found no significant LOD enhancement in GC×GC.