Formation and Fate of Formaldehyde in Methanol-to-Hydrocarbon Reaction: In Situ Synchrotron Radiation Photoionization Mass Spectrometry Study.

HCHO has been confirmed as an active intermediate in the methanol-to-hydrocarbon (MTH) reaction, and is critical for interpreting the mechanisms of coke formation. Here, HCHO was detected and quantified during the MTH process over HSAPO-34 and HZSM-5 by in situ synchrotron radiation photoionization mass spectrometry. Compared with conventional methods, excellent time-resolved profiles were obtained to study the formation and fate of HCHO, and other products during the induction, steady-state reaction, and deactivation periods. Similar formation trends of HCHO and methane, and their close correlation in yields suggest that they are derived from disproportionation of methanol at acidic sites. In the presence of Y2 O3 , the amount of HCHO changes, affecting the hydrogen-transfer processes of olefins into aromatics and aromatics into cokes. The yield of HCHO affects the aromatic-based cycle and the formation of ethylene, indicating that ethylene is mainly formed from the aromatic-based cycle.

An experimental study of indene pyrolysis with synchrotron vacuum ultraviolet photoionization mass spectrometry.

Pyrolytic kinetics of indene was studied in a flow reactor at 30 and 760 Torr. Indene and its decomposition products, as well as polycyclic aromatic hydrocarbons (PAHs), were measured with synchrotron vacuum ultraviolet photoionization mass spectrometry (SVUV-PIMS). Five literature models were selected to reproduce the experimental data and analyze the reaction kinetics of indene. The experimental and predicted results illustrate that an indenyl radical is the dominant decomposition intermediate and also the main contributor to the further growth of aromatic rings in the pyrolysis of indene. The indene consumption process needs further precise characterization, especially the subsequent dissociation reactions of indanyl and indenyl radicals. A self-recombination reaction of the indenyl radical and the combination reactions between indenyl and other radicals are found to be necessary for the efficient formation of large PAHs. The absence of these pathways leads to the underprediction of experimental measurements. In contrast, literature models adopting indenyl global reactions for PAH formation generally overestimate the system reactivity. Proper radical combination pathways proposed in a future model should consider not only the PAH formation efficiency but also its impact on system reactivity.

Experimental and Theoretical Investigation of the Pyrolysis of Furfural.

The thermal decomposition of furfural is investigated in a flow tube reactor at 30 Torr by synchrotron vacuum ultraviolet photoionization mass spectrometry (SVUV-PIMS) at temperatures from 1023 to 1273 K. Over 20 kinds of pyrolysis products, including short-lived radicals, stable oxygen-containing compounds, and hydrocarbons, are identified from the scanning photoionization efficiency (PIE) spectra. Vinylketene (CH2═CH-CH═C═O), which has been shown to be an important primary product, is also directly observed. The possible steps of hydrogen atom addition and hydrogen atom abstraction in the thermal decomposition of furfural are studied by theoretical calculations at the CBS-QB3 level. In addition to unimolecular decomposition, hydrogen atom addition followed by ring opening can lead to the production of vinylketene.

A vacuum ultraviolet photoionization study on high-temperature decomposition of JP-10 (exo-tetrahydrodicyclopentadiene).

Two sets of experiments were performed to unravel the high-temperature pyrolysis of tricyclo[5.2.1.02,6] decane (JP-10) exploiting high-temperature reactors over a temperature range of 1100 K to 1600 K, Advanced Light Source (ALS), and 927 K to 1083 K, National Synchrotron Radiation Laboratory (NSRL), with residence times of a few tens of microseconds (ALS) to typically 144 ms (NSRL). The products were identified in situ in supersonic molecular beams via single photon vacuum ultraviolet (VUV) photoionization coupled with mass spectroscopic detection in a reflectron time-of-flight mass spectrometer (ReTOF). These studies were designed to probe the initial (ALS) and also higher order reaction products (NSRL) formed in the decomposition of JP-10 - including radicals and thermally labile closed-shell species. Altogether 43 products were detected and quantified including C1-C4 alkenes, dienes, C3-C4 cumulenes, alkynes, eneynes, diynes, cycloalkenes, cyclo-dienes, aromatic molecules, and most importantly, radicals such as ethyl, allyl, and methyl produced at shorter residence times. At longer residence times, the predominant fragments were molecular hydrogen (H2), ethylene (C2H4), propene (C3H6), cyclopentadiene (C5H6), cyclopentene (C5H8), fulvene (C6H6), and benzene (C6H6). Accompanied by electronic structure calculations, the initial JP-10 decomposition via C-H bond cleavages resulting in the formation of the initial six C10H15 radicals was found to explain the formation of all products detected in both sets of experiments. These radicals are not stable under the experimental conditions and further decompose via C-C bond ß-scission processes. These pathways result in ring opening in the initial tricyclic carbon skeletons of JP-10. Intermediates accessed after the first ß-scission can further isomerize or dissociate. Complex PAH products in the NRLS experiment (naphthalene, acenaphthylene, biphenyl) are likely formed via molecular growth reactions at elevated residence times.