Iron(I) in Negishi cross-coupling reactions.

Herein we demonstrate both the importance of Fe(I) in Negishi cross-coupling reactions with arylzinc reagents and the isolation of catalytically competent Fe(I) intermediates. These complexes, [FeX(dpbz)(2)] [X = 4-tolyl (7), Cl (8a), Br (8b); dpbz = 1,2-bis(diphenylphosphino)benzene], were characterized by crystallography and tested for activity in representative reactions. The complexes are low-spin with no significant spin density on the ligands. While complex 8b shows performance consistent with an on-cycle intermediate, it seems that 7 is an off-cycle species.

Studies on the atropisomerism of Fe(II) 2,6-bis(N-arylimino)pyridine complexes.

NMR spectra of free 2,6-bis(N-arylimino)pyridine (PDI) ligands displaying different substituents at the ortho and ortho' positions of the two N-aryl rings indicate that they can exist in syn (meso) and anti (chiral) configurations. These interconvert in solution at room temperature, via rotation of the aryl group. The corresponding paramagnetic FeX(2)(PDI) complexes exhibit the same kind of isomerism, a property that is thought to be important for their activity as alpha-olefin polymerization catalysts. For the first time, this has been detected by (1)H NMR and studied in solution. Although the conformational stability of the diastereoisomeric complexes varies widely (depending on the size of the substituents at the imine and the aromatic rings), a moderate degree of steric hindrance suffices to allow their chemical separation. A simple procedure is developed for the preparation of these complexes in diastereoisomerically pure form. In addition, introduction of a prochiral substituent in the pyridine ring enables positive assignment of the stereoisomers. Isomerization rate measurements of the Fe(II) complexes in solution suggest that isomerization very likely involves the dissociation of the corresponding Fe-N(imino) bond prior to the rotation of N-aryl groups. DFT calculations provide additional support to the conformational assignment as well as the dissociative isomerization mechanism.

Palladium(II) carboxylates and palladium(I) carbonyl carboxylate complexes as catalysts for olefin cyclopropanation with ethyl diazoacetate.

Palladium(I) carbonyl carboxylate complexes [Pd(mu-CO)(mu-RCO2)](n) (R = Me, n = 4; R = CMe(3), n = 6) and the corresponding palladium(II) carboxylates (acetate and pivalate) catalyze the cyclopropanation of olefins with ethyl diazoacetate. The performance of these catalysts is similar in terms of selectivity and cyclopropane yields, regardless of the oxidation state of the metal center. However the rates of the cyclopropanation reactions are significantly higher for the acetate based catalysts than for the pivalate derivatives, which suggests that the main catalytic species are carboxylate containing palladium complexes. Kinetic measurements show that reaction rates are independent of the olefin concentration when these are 1-hexene or styrene, but norbornene exerts an inhibitory effect. In spite of this, competition experiments indicate that the cyclopropanation of styrene is 2.2 times as favorable as that of 1-hexene for any of the four catalysts. These observations indicate that while the rate-determining formation of the intermediate palladium carbenoid species is controlled by the catalyst structure, this is followed by a rapid and less specific cyclopropanation step that is not affected by the nature of the carboxylate groups present in the catalyst. An independent test using a 1:1 benzene/cyclohexane mixture of solvents showed that the transfer of ethoxycarbonylcarbene (:C(CO2Et)H) to these molecules is unselective (relative rate of benzene/cyclohexane functionalization approximately 1.8, independent of the catalyst). This result can be interpreted as an indication of the involvement of free ethoxycarbonylcarbene in the carbene transfer step.