Denim industry wastewater treatment by a heterogeneous solar-Fenton process catalyzed by Fe supported on recycled polyethylene terephthalate (PET) by ultrasonic modification.

The textile industry is an important economic sector; however, its wastewater generates a great impact on the environment. A heterogeneous solar Fenton (HSF) process was evaluated for denim wastewater treatment. The catalyst was obtained through ultrasonic modification of recycled polyethylene terephthalate (PET) with Fe nanoparticles (PET/NPs- Fe3O4). The SFH process was optimized using surface response methodology with a face-centered central composite design considering the effects of the hydraulic retention time (10, 25, and 40 min), hydrogen peroxide dosage (500, 1000, and 1500 mg/L), and mass of the packed catalyst (4, 6 and 8 g) on the color, COD, and turbidity removal efficiencies. The operating conditions for maximum COD removal were H2O2 541.7 mg/L, HRT 33.9 min, and PET/NPs- Fe3O4 dose 7.9 g with solar radiation. The removal of 91.2% COD, 86.2% color, 90.4% turbidity, and 81.9% TOC was obtained at 14.2 kJ/L QUva. PET modification yielded 1.6 mg Fe/g PET, and the modification method does not allow Fe leaching. The effluent obtained from the SFH process complies with the maximum permissible limits in Mexican legislation in terms of COD, TOC, turbidity, and color and allows the reuse of PET.

Acid mine drainage (AMD) treatment using galvanic electrochemical system Al-Cu.

Acid mine drainage was evaluated using a galvanic (GV) electrochemical system, Al-Cu (anode/cathode), based on a 32 factorial design. The factors analyzed were anodic area/volume ratios (A/V) of 0.037, 0.072, and 0.112 cm2/cm3, and treatment time from 0.25-8 h, and analyses were performed in duplicate with 11 degrees of freedom. The response variables were the total dissolved solids and concentrations of As, Cu, Co, Cr, Pb, Fe, Ni, and SO42-. The pH, electrical conductivity, and temperature were monitored during the process. Significant differences between treatments were determined by analysis of variance with Tukey's test (p < 0.05) using Statgraphics Centurion XVI.I software. The results showed that a greater electrode surface, A/V ratio, and treatment time improved pollutant removal. The spontaneous reactions generated by the galvanic cell, through the current that flows owing to the potential difference between the Al and Cu electrodes, allows the removal of heavy metals, arsenic, and SO42- by coagulation and precipitation mechanisms. The removal efficiencies achieved were Cu (99.1%), As (76.6%), Ni (80.2%), Pb (83.6%), Cr (100%), Fe (93.71%), and 92.9% for sulfates. The X-ray diffraction and Raman analyses of the solid fraction indicated that cuprite was formed with a purity of 96%, and the recovery of Cu by the GV system may be a viable option for mining companies.

Electro-galvanic alkalization and treatment of rainwater to obtain drinking water.

Rainwater Electro-Galvanic Alkalization (EGA) was performed using copper and magnesium (1:1) electrode. Efficiently removal of pollutants without external energy consumption was carried out, in addition essential ions were dosed for alkalization of rainwater. The optimal system conditions were obtained using response surface methodology (RSM) by considering the following operating variables: flow rate and concentration of the supporting electrolyte (NaCl and CaCl2). Furthermore, the maximum efficiency of nitrate, ammoniacal nitrogen, colour, and turbidity removal was evaluated. The results showed that the response variables were mainly sensitive to the type of supporting electrolyte used and the flow rate. Under experimental conditions of 0.009 M (NaCl) and 20 mL min-1, the removal rate was 74.19%, 72.49%, and 81.43% for nitrates, colour, and turbidity, respectively, and the lowest concentration of ammoniacal nitrogen (0.99mgL-1) was obtained. The kinetic models for nitrate and colour were fitted to zero-order models with k=0.33mgL-1min-1 and k=0.933Pt-Co, respectively. In addition, turbidity was fitted to a first-order model (k=0.1661min-1), and ammoniacal nitrogen was fitted to a second-order model (k=0.0217Lmg-1min-1). The concentration increases of minerals such as Ca and Mg, which rises the rainwater alkalinity after treatment (pH shift from 6.1 to 8.91), was determined by inductively coupled plasma (ICP) analysis.

As and [Formula: see text] cooccurrence in drinking water: critical review of the international scenario, physicochemical behavior, removal technologies, health effects, and future trends.

Drinking water contaminated with As and [Formula: see text] is increasingly prevalent worldwide. Their coexistence can have negative effects due to antagonistic or synergistic mechanisms, ranging from cosmetic problems, such as skin lesions and teeth staining, to more severe abnormalities, such as cancer and neurotoxicity. Available technologies for concurrent removal include electrocoagulation ~ adsorption > membranes > chemical coagulation > , and among others, all of which have limitations despite their advantages. Nevertheless, the existence of competing ions such as silicon > phosphate > calcium ~ magnesium > sulfate > and nitrate affects the elimination efficiency. Mexico is one of the countries that is affected by As and [Formula: see text] contamination. Because only 10 of the 32 states have adequate removal technologies, more than 65% of the country is impacted by co-presence problems. Numerous reviews have been published concerning the elimination of As or [Formula: see text]. However, only a few studies have focused on the simultaneous removal. This critical review analyzes the new sources of contamination, simultaneous physicochemical behaviors, available technologies for the elimination of both species, and future trends. This highlights the need to implement technologies that work with actual contaminated water instead of aqueous solutions (55% of the works reviewed correspond to aqueous solutions). Similarly, it is necessary to migrate to the creation of pilot, pre-pilot, or prototype scale projects, because 77% of the existing studies correspond to lab-scale research.

SARS-CoV-2 pharmaceutical drugs: a critical review on the environmental impacts, chemical characteristics, and behavior of advanced oxidation processes in water.

This review summarizes research data on the pharmaceutical drugs used to treat the novel SARS-CoV-2 virus, their characteristics, environmental impacts, and the advanced oxidation processes (AOP) applied to remove them. A literature survey was conducted using the electronic databases Science Direct, Scopus, Taylor & Francis, Google Scholar, PubMed, and Springer. This complete research includes and discusses relevant studies that involve the introduction, pharmaceutical drugs used in the SARS-CoV-2 pandemic: chemical characteristics and environmental impact, advanced oxidation process (AOP), future trends and discussion, and conclusions. The results show a full approach in the versatility of AOPs as a promising solution to minimize the environmental impact associated with these compounds by the fact that they offer different ways for hydroxyl radical production. Moreover, this article focuses on introducing the fundamentals of each AOP, the main parameters involved, and the concomitance with other sources and modifications over the years. Photocatalysis, sonochemical technologies, electro-oxidation, photolysis, Fenton reaction, ozone, and sulfate radical AOP have been used to mineralize SARS-CoV-2 pharmaceutical compounds, and the efficiencies are greater than 65%. According to the results, photocatalysis is the main technology currently applied to remove these pharmaceuticals. This process has garnered attention because solar energy can be directly utilized; however, low photocatalytic efficiencies and high costs in large-scale practical applications limit its use. Furthermore, pharmaceuticals in the environment are diverse and complex. Finally, the review also provides ideas for further research needs and major concerns.

The impact of coronavirus SARS-CoV-2 (COVID-19) in water: potential risks.

This review summarizes research data on SARS-CoV-2 in water environments. A literature survey was conducted using the electronic databases Science Direct, Scopus, and Springer. This complete research included and discussed relevant studies that involve the (1) introduction, (2) definition and features of coronavirus, (2.1) structure and classification, (3) effects on public health, (4) transmission, (5) detection methods, (6) impact of COVID-19 on the water sector (drinking water, cycle water, surface water, wastewater), (6.5) wastewater treatment, and (7) future trends. The results show contamination of clean water sources, and community drinking water is vulnerable. Additionally, there is evidence that sputum, feces, and urine contain SARS-CoV-2, which can maintain its viability in sewage and the urban-rural water cycle to move towards seawater or freshwater; thus, the risk associated with contracting COVID-19 from contact with untreated water or inadequately treated wastewater is high. Moreover, viral loads have been detected in surface water, although the risk is lower for countries that efficiently treat their wastewater. Further investigation is immediately required to determine the persistence and mobility of SARS-CoV-2 in polluted water and sewage as well as the possible potential of disease transmission via drinking water. Conventional wastewater treatment systems have been shown to be effective in removing the virus, which plays an important role in pandemic control. Monitoring of this virus in water is extremely important as it can provide information on the prevalence and distribution of the COVID-19 pandemic in different communities as well as possible infection dynamics to prevent future outbreaks.