Green Roots: Photosynthesis and Photoautotrophy in an Underground Plant Organ.

The potential for photosynthetic and photoautotrophic growth was studied in hairy root cultures of Asteraceae and Solanaceae species. Upon transfer to light, initially heterotrophic root cultures of Acmella oppositifolia and Datura innoxia greened rapidly, differentiated chloroplasts, and developed light-dependent CO2 fixation in the cortical cells. Photosynthetic potential was expressed in root cultures of all the Asteraceae genera examined (Acmella, Artemisia, Rudbeckia, Stevia, and Tagetes). Hairy roots of A. oppositifolia and D. innoxia were further adapted to photoautotrophy by growing in the presence of light and added CO2 (1-5%) and by direct or sequential transfers into media containing progressively lower sugar concentrations. The transition to photoautotrophy was accompanied by an increase in CO2 fixation and in the specific activity of 1,5-ribulose-bisphosphate carboxylase/ oxygenase (Rubisco). During the adaptation of A. oppositifolia roots to photoautotrophy, the ratio of Rubisco to phosphoenolpyruvate carboxylase increased significantly, approaching that found in the leaves. The levels and patterns of alkaloids and polyacetylenes produced by Solanaceae and Asteraceae hairy roots, respectively, were dramatically altered in photomixotrophic and photoautotrophic cultures. Photoautotrophic roots of A. oppositifolia have been mainitained in vitro for over 2 years.

Evaluation of two fiber optic-based solar collection and distribution systems for advanced space life support.

Growing plants in an enclosed controlled environment is crucial in developing bioregenerative life-support systems (BLSS) for space applications. The major challenge currently facing a BLSS is the extensive use of highly energy-intensive electric light sources, which leads to substantial energy wastes through heat dissipations by these lamps. An alternative lighting strategy is the use of a solar irradiance collection, transmission, and distribution system (SICTDS). Two types of fiber optic-based SICTDS, a Fresnel-lens Himawari and a parabolic-mirror optical waveguide (OW) lighting system, were evaluated. The overall efficiency for the OW SICTDS of 40.5% exceeded by 75% that for the Himawari of 23.2%. The spectral distributions of the light delivered by the Himawari and the OW SICTDS were almost identical and had practically no difference from that of terrestrial solar radiation. The ratios of photosynthetically active radiation (PAR) to total emitted radiation (k) of 0.39 +/- 0.02 for the Himawari and 0.41 +/- 0.04 for the OW SICTDS were statistically indistinguishable, were not significantly different from that of 0.042 +/- 0.01 for terrestrial solar radiation, and were comparable to that of 0.35 for a high-pressure sodium (HPS) lamp. The coefficients of variation (CV) of 0.34 and 0.39 for PPF distributions, both at 50 mm X 50 mm square grid arrays, corresponding to the Himawari and the OW SICTDS, respectively, were comparable with each other but were both significantly greater than the CV of 0.08 corresponding to the HPS lamp. The average fresh weight or dry weight of lettuce grown in the solar chamber with either the Himawari or the OW SICTDS showed no statistical difference from the average fresh weight or dry weight of lettuce grown in the reference chamber with the HPS lamp. The results of this study suggest that an SICTDS could help reduce the electric power demand in a BLSS.

Characterizations of high-intensity red and blue light-emitting diodes (LEDs) as a light source for plant growth.

Recently developed high-intensity red and blue light-emitting diodes (LEDs), which constitute a potentially improved light source for controlled-environment plant growth applications such as in vitro micropropagation and biologically based advanced life support (ALS) for space missions, were characterized in this study. Blue 2 LED and Red 1 LED consistently yielded the highest and lowest voltage drop readings, respectively, for all the electrical current settings tested (5-50 mA), with Blue 1 LED producing voltage drops falling nearly in the middle of the readings for the first two LEDs. At the standard current setting of 20 mA, Blue 2 LED and Blue 1 LED required 2.5 and 1.6 times more electrical power, respectively, than did Red 1 LED. At the standard current of 20 mA, the average photosynthetic photon flux (PPF) for Red 1 LED, Blue 1 LED, and Blue 2 LED were 180, 145, and 36 micromoles m-2 s-1, respectively. Red 1 LED peaked at 460 micromoles m-2 s-1 at 50 mA, Blue 1 LED at 200 micromoles m-2 s-1 at 40 mA, and Blue 2 LED at 40 micromoles m-2 s-1 at about 25 mA. For all current settings, the electrical conversion efficiency of Red 1 was approximately two times greater than that of Blue 1 LED. The electrical conversion efficiency of Blue 1 and of Red 1 LED peaked in between 10 and 20 mA, at about 13 mA for Blue 1 LED and at about 15 mA for Red 1 LED. The normalized PPF distributions for both Red 1 LED and Blue 1 LED were independent of the various magnitudes of electrical current (20, 30, 40, and 50 mA) that were applied to the LEDs.

Design parameters of flat-panel LED modules for plant lighting applications.

Semispherical high-intensity light-emitting diodes (LEDS) mounted on a circuit board have been developed and examined for plant growth applications. This type of LED configuration, however, has problems such as relatively poor heat dissipation, difficulty of effecting high light uniformity, and high cost of assembly. Such problems may now be obviated through use of the recently developed flat-panel LED modules. In this study, the photosynthetic photon flux (PPF) levels and PPF distribution of 172 x 27 mm red flat-panel LED modules were determined. Results showed that: 1) the red flat-panel LED modules tested produced a mean PPF level of about 111 micromoles m-2 s-1 at a distance of 10 cm, which would be adequate for most micropropagated species grown photomixotrophically and reasonable for some micropropagated species grown photoautotrophically, both in terms of red wavelength; 2) the mean surface PPF of 419 micromoles m-2 s-1 for a single LED in a flat-panel module was about 47% greater than that for a single semispherical LED at about equal operational currents, owing primarily to the significantly larger reflectance area present in a flat-panel LED than that in a semispherical LED; 3) two flat-panel LED modules tested had about 80% of their illuminated areas having PPF values equal to or greater than half their maximum PPF levels, whereas the third module had a corresponding figure of about 67%; and 4) flat-panel LED modules exhibited very similar PPF distributions, underscoring the advantage of the LED flat-panel design over the manually assembled LED array in the ease of replicating light distributions.

Azolla-Anabaena symbionts and microbial mat as nitrogen-fixing biocatalysts for bioregenerative space life support.

This study was conducted to characterize the responses of selected nitrogen-fixing biocatalysts to various environmental parameters that are likely to be encountered in a scaled-up nitrogen-fixing bioregenerative unit for use in a biologically based life support system (BLSS). The results showed that while both Azolla filiculoides and Azolla nilotica thrived on standard nitrogen-free liquid media, only Azolla filiculoides maintained its growth rate in the presence of 50% by volume of aerobic-bioreactor potato effluent (ABPE) in its liquid medium. The growth rate and Anabaena cavity population of Azolla filiculoides also remained undiminished in the presence of as much as 10 mM of NO3- in its liquid medium. The tolerance of Azolla filiculoides for NO3- however, lay somewhere between 10 and 20 mM of NO3-. Azolla filiculoides failed to grow at 5 mM or greater concentrations of NH4+. The growth rate of the Oscillatoria-dominated microbial mat was significantly elevated by increased silage loading density (16 g/L) as well as by adding 5 mM of NO3- into its liquid medium. Neither the growth rate of Azolla filiculoides nor that of the microbial mat was affected by three levels of photosynthetic photon flux (PPF) (520, 265, and 125 micromoles m-2 s-1) under high-pressure sodium or cool fluorescent lamps.

Evaluation of light transmission and distribution materials for Lunar and Martian bioregenerative life support.

The materials that were selected and evaluated in this study in the context of bioregenerative advanced life support included polymer optical cables, for transmission of photosynthetic photon flux (PPF), and light pipe, woven optical pad and light-emitting fiber (LEF) for PPF distribution. All materials exhibited significant fidelity in transmitting the spectral characteristics of the artificial lluminator's Xenon-Metal Halide lamp. The PPF attenuation values for the polymer cables EL-200, EL-300, EL-400, and EL-500 were not significantly distinguishable from one another nor from that of the fused-silica cable of 0.34 dB/m. With the exception of EL-100 and EL-700, which had significantly lower PPF transmission efficiencies of 54.9%/m and 66.6%/m, respectively, all the other polymer cables had PPF transmission efficiencies of over 85%/m which, except for EL-300, were not significantly different from one another nor from that of the fused-silica cable of 93.2%/m. The highest PPF output efficiency achieved for the 7.1-cm light pipe 14.7%, for its maximum pipe length of 100 cm. At a constant pipe length of 50 cm, the PPF output efficiency of the 10-cm light pipe of 0.71% was significantly lower than that of the 7.1-cm light pipe of 10.54%. The PPF output for the woven optical pad was determined to be 36.3%. The PPF output efficiency for the LEF without the optic fastener was determined to be 27.1%, whereas that for the LEF with the optic fastener was 50.3%, that is, the maximum value of PPF output efficiency in the study. The polymer optical cables, light pipe, woven optical pad, and LEF exhibited significant regularity and symmetry in their PPF output spatial distributions.

La infiltración de macrófagos en las lesiones coronarias primarias está asociada con reestenosis luego de la intervención coronaria percutánea / Macrophage infiltration in primary coronary plaque tissue is associated with restenosis after percutaneous coronary intervention

Se le realizó aterectomía direccional coronaria de la lesión culposa a 50 pacientes sintomáticos por angina inestable. Se tiñeron las muestras obtenidas con hematoxilina-eosina, tinción tricrómica y con anticuerpos monoclonales antimacrófagos humanos (Kp-1). El seguimiento angiográfico fue de 16 ñ 2 semanas. Treinta pacientes evolucionaron a reestenosis y 20 pacientes sin reestenosis (grupo control). El porcentaje de áreas ricas en macrófagos fue significativamente mayor en las placas de pacientes con reestenosis (19 ñ 3 por ciento) que en las placas sin reestenosis (10,3 ñ 3 por ciento) (p= 0,005). Este incremento del contenido de macrófagos sugiere que células inflamatorias estarían involucradas en el complejo mecanismo de la reestenosis luego de la intervención coronaria percutánea