Multiscale Study of the Charge Transport Properties of Silicone Rubber Oligomers.

Polymer dielectrics are widely used as insulation in electronic and electrical equipment. The charge transport process in polymer dielectrics under a high electric field, which is considered to result in electrical aging and even breakdown of equipment insulation, has attracted considerable attention. Based on a localized charge transfer model, the charge transport mechanism for typical silicone rubber (SR) insulating materials was studied by multiscale methods. A model of silicone rubber oligomers under standard conditions was generated by classical molecular dynamics. The frontier molecular orbitals and projected density of states for the SR oligomer were obtained via quantum chemistry methods. The electronic coupling, reorganization energy, and free energy difference for both electron and hole transfer processes between adjacent SR molecules in the molecular dynamics model were calculated. Both hole transfer and electron transfer in SR conform to an intermolecular hopping mechanism due to their high intramolecular reorganization energy and low intermolecular electronic coupling. The results of normal mode analysis for reorganization energy indicate that the high-temperature approximation holds for charge transport in SR around or above room temperature. The charge transfer trajectory and charge mobility in SR were simulated based on kinetic Monte Carlo simulations. The hole and electron mobilities at room temperature were calculated to be 7.24 × 10-11 and 2.76 × 10-9 cm2/Vs, respectively, which agrees with the experimental data. Both electron transport and hole transport in SR show thermal activation characteristics, with corresponding activation energies of 358 and 314 meV, respectively. This work suggests a physical model to describe the charge transport process in SR polymer dielectrics.

Simplified Near-Degenerate Four-Wave-Mixing Microscopy.

Four-wave-mixing microscopy is widely researched in both biology and medicine. In this paper, we present a simplified near-degenerate four-wave-mixing microscopy (SNDFWM). An ultra-steep long-pass filter is utilized to produce an ultra-steep edge on the spectrum of a femtosecond pulse, and a super-sensitive four-wave-mixing (FWM) signal can be generated via an ultra-steep short-pass filter. Compared with the current state-of-the-art FWM microscopy, this SNDFWM microscopy has the advantages of simpler experimental apparatus, lower cost, and easier operation. We demonstrate that this SNDFWM microscopy has high sensitivity and high spatial resolution in both nanowires and biological tissues. We also show that the SNDFWM microscopy can achieve an ultra-sensitive detection based on the electron-resonance effect. This method might find an important application in tracking of nano drugs in vivo.

First-principles investigation of band offset and charge transfer characteristics at the PE/fluorinated layer interface.

Polymers, especially polyethylene (PE), are widely employed as insulating materials in electrical power transmission systems. However, the insulation still faces the problem of space charge, which distorts the electric field distribution and accelerates electrical aging. Experimental results show that after the fluorination process, less charge injection occurs compared with pure PE. To clarify the mechanism, classical molecular dynamics was employed to build a PE/fluorinated layer interfacial model and first principles calculation was utilized to get the band offset at the interface. The results calculated by both the bulk plus band lineup method and the layer-decomposed density of states method show that the energy band of the fluorinated PE layer is overall lower than that of the PE side, and the band offsets are around 2 eV. Charge transport results based on Marcus theory and kinetic Monte Carlo simulations also show that charge can easily accumulate at the interfacial area under an electric field and the band offset can suppress charge injection. The conduction band offset acts as an energy barrier for the excess electrons at the fluorinated layer side to cross the interface, while the valence band offset has the same effect on hole transport because of the energy barrier caused by the inverted region. Our findings provide a fundamental and theoretical basis for material modification and space charge inhibition.

Melatonin Attenuates the Urea-Induced Yields Improvement Through Remodeling Transcriptome and Rhizosphere Microbial Community Structure in Soybean.

Foliar application of nitrogen to enhance crop productivity has been widely used. Melatonin is an effective regulator in promoting plant growth. However, the effects of melatonin and the combination of melatonin and nitrogen on soybeans yields production remain largely unknown. In this study, a field experiment was conducted to evaluate the effects and mechanisms of spraying leaves with melatonin and urea on soybeans. Foliar application of urea significantly increased soybean yields and melatonin did not affect the yields, while combination of melatonin and urea significantly reduced the yields compared to the application of urea alone. A leaf transcriptional profile was then carried out to reveal the underlying mechanism and found that foliar spraying of urea specifically induced the expression of genes related to amino acid transport and nitrogen metabolism. However, foliar application of melatonin significantly changed the transcriptional pattern established by urea application and increased the expression of genes related to abiotic stress signaling pathways. The effects of melatonin and urea treatment on soil microbiome were also investigated. Neither melatonin nor urea application altered the soil microbial alpha diversity, but melatonin application changed rhizosphere microbial community structure, whereas the combination of melatonin and urea did not. Melatonin or urea application altered the abundance of certain taxa. The number of taxa changed by melatonin treatment was higher than urea treatment. Collectively, our results provide new and valuable insights into the effects of foliar application of melatonin to urea and further show that melatonin exerts strong antagonistic effects on urea-induced soybean yields, gene expression and certain soil microorganisms.

Biological Control of Tomato Gray Mold Caused by Botrytis Cinerea with the Entomopathogenic Fungus Metarhizium Anisopliae.

Gray mold disease caused by Botrytis cinerea is a devastating disease that leads to serious financial loss. In this study, the entomopathogenic fungus Metarhizium anisopliae that acts against the gray mold pathogen B. cinerea was evaluated. M. anisopliae produced a significant inhibition zone in front of the B. cinerea colony in the dual culture test. In addition, volatile organic compounds generated by M. anisopliae were shown to have an inhibitory effect on B. cinerea mycelia growth and reduced 41% of gray mold severity of postharvest tomatoes. The 10% concentration of the culture filtrate of M. anisopliae inhibited 88.62% of colony radial growth as well as 63.85% of sclerotia germination and all conidia germination of B. cinerea. Furthermore, the culture filtrate of M. anisopliae retained its inhibitory effect against the radial growth of B. cinerea even after heating for 15 min at 100 °C. Feasible mechanisms of M. anisopliae involved in the control of B. cinerea were explored, and it was demonstrated that the plasma membrane of B. cinerea conidia was damaged by the product of metabolism of M. anisopliae. In addition, after treating with culture filtrate of M. anisopliae, the B. cinerea phenotype was shown to be abnormal, and cell organelles of B. cinerea mycelia were damaged significantly. A significant control efficacy of M. anisopliae against tomato gray mold was detected on both the detached leaf assay (84.24%) as well as the whole plant (72.38%). In addition, a 78% reduction in tomato fruit mold was detected at a 10% treated concentration of M. anisopliae. These findings suggest that M. anisopliae possesses potential as a biocontrol agent against tomato gray mold in the greenhouse and during the postharvest stage.

Study of cross-shaped ultrasonic array sensor applied to partial discharge location in transformer oil.

A conformal combined sensor is designed and it is used in Partial Discharge (PD) location experiments in transformer oil. The sensor includes a cross-shaped ultrasonic phased array of 13 elements and an ultra-high-frequency (UHF) electromagnetic rectangle array of 2 × 2 elements. Virtual expansion with high order cumulants, the ultrasonic array can achieve the effect of array with 61 elements. This greatly improves the aperture and direction sharpness of original array and reduces the cost of follow-up hardware. With the cross-shaped ultrasonic array, the results of PD location experiments are precise and the maximum error of the direction of arrival (DOA) is less than 5°.