Enabling High Throughput Kinetic Experimentation by Using Flow as a Differential Kinetic Technique.

Kinetic data is most commonly collected through the generation of time-series data under either batch or flow conditions. Existing methods to generate kinetic data in flow collect integral data (concentration over time) only. Here, we report a method for the rapid and direct collection of differential kinetic data (direct measurement of rate) in flow by performing a series of instantaneous rate measurements on sequential small-scale reactions. This technique decouples the time required to generate a full kinetic profile from the time required for a reaction to reach completion, enabling high throughput kinetic experimentation. In addition, comparison of kinetic profiles constructed at different residence times allows the robustness, or stability, of homogeneously catalysed reactions to be interrogated. This approach makes use of a segmented flow platform which was shown to quantitatively reproduce batch kinetic data. The proline mediated aldol reaction was chosen as a model reaction to perform a high throughput kinetic screen of 216 kinetic profiles in 90 hours, one every 25 minutes, which would have taken an estimated continuous 3500 hours in batch, an almost 40-fold increase in experimental throughput matched by a corresponding reduction in material consumption.

Atropselective synthesis of N-aryl pyridones via dynamic kinetic resolution enabled by non-covalent interactions.

The dynamic kinetic resolution of C-N atropisomeric pyridones was achieved via asymmetric phase-transfer catalysis, exploiting a rotational barrier-lowering hydrogen bond in the starting materials. X-ray and NMR experiments revealed the presence of a barrier-raising ground state CH⋯π interaction in the product, supported by DFT calculations. A co-crystal of the quinidine-derived phase-transfer catalyst and substrate reveals key substrate-catalyst non-covalent interactions.

Highly Sensitive and Selective Molecular Probes for Chromo-Fluorogenic Sensing of Carbon Monoxide in Air, Aqueous Solution and Cells.

Optical sensing offers a low-cost and effective means to sense carbon monoxide in air and in solution. This contribution reports the synthesis of a new series of vinyl complexes [Ru(CH=CHR)Cl(CO)(TBTD)(PPh3 )2 ] (R=aryl, TBTD=5-(3-thienyl)-2,1,3-benzothiadiazole) and shows them to be highly sensitive and selective probes for carbon monoxide in both solution and air. Depending on the vinyl substituent, chromogenic and fluorogenic responses signalled the presence of this invisible, odourless, tasteless and toxic gas. Adsorbing the complexes on silica produced colorimetric probes for the 'naked eye' detection of CO in the gas phase with a limit of detection as low as 8 ppm in some cases, while the release of the TBTD fluorophore allowed detection at much lower concentrations through the fluorescence response. Structural data were obtained by single-crystal X-ray diffraction techniques, while the photophysical behaviour was explored computationally using TD-DFT experiments. The systems were also shown to be selective for CO over all other gases tested, including water vapour and common organic solvents. By introducing a poly(ethylene)glycol chain to the vinyl functionality, water compatibility was achieved and these non-cytotoxic complexes were employed in the sensing of CO in HeLa cells, offering a simple and rapid system for sensing this gasotransmitter in this challenging medium.

Photochemical Homologation for the Preparation of Aliphatic Aldehydes in Flow.

Cheap and readily available aqueous formaldehyde was used as a formylating reagent in a homologation reaction with nonstabilized diazo compounds, enabled by UV photolysis of bench-stable oxadiazolines in a flow photoreactor. Various aliphatic aldehydes were synthesized along with the corresponding derivatized alcohols and benzimidazoles. No transition-metal catalyst or additive was required to affect the reaction, which proceeded at room temperature in 80 min.

Understanding a Hydroformylation Catalyst that Produces Branched Aldehydes from Alkyl Alkenes.

This paper reports experimental and computational studies on the mechanism of a rhodium-catalyzed hydroformylation that is selective for branched aldehyde products from unbiased alkene substrates. This highly unusual selectivity relies on a phospholane-phosphite ligand prosaically called BOBPHOS. Kinetic studies using in situ high pressure IR (HPIR) and the reaction progress kinetic analysis methodology suggested two steps in the catalytic cycle were involved as turnover determining. Negative order in CO and positive orders in alkene and H2 were found and the effect of hydrogen and carbon monoxide partial pressures on selectivity were measured. Labeling studies found rhodium hydride addition to the alkene to be largely irreversible. Detailed spectroscopic HPIR and NMR characterization of activated rhodium-hydrido dicarbonyl species were carried out. In the absence of H2, reaction of the rhodium-hydrido dicarbonyl with allylbenzene allowed further detailed spectroscopic characterization of four- and five-coordinate rhodium-acyl species. Under single-turnover conditions, the ratios of branched to linear acyl species were preserved in the final ratios of aldehyde products. Theoretical investigations uncovered unexpected stabilizing CH-π interactions between the ligand and substrate which influenced the high branched selectivity by causing potentially low energy pathways to become unproductive. Energy span and degree of TOF control analysis strongly support experimental observations and mechanistic rationale. A three-dimensional quadrant model was built to represent the structural origins of regio- and enantioselectivity.

Chemoselective Polymerizations from Mixtures of Epoxide, Lactone, Anhydride, and Carbon Dioxide.

Controlling polymer composition starting from mixtures of monomers is an important, but rarely achieved, target. Here a single switchable catalyst for both ring-opening polymerization (ROP) of lactones and ring-opening copolymerization (ROCOP) of epoxides, anhydrides, and CO2 is investigated, using both experimental and theoretical methods. Different combinations of four model monomers-ε-caprolactone, cyclohexene oxide, phthalic anhydride, and carbon dioxide-are investigated using a single dizinc catalyst. The catalyst switches between the distinct polymerization cycles and shows high monomer selectivity, resulting in block sequence control and predictable compositions (esters and carbonates) in the polymer chain. The understanding gained of the orthogonal reactivity of monomers, specifically controlled by the nature of the metal-chain end group, opens the way to engineer polymer block sequences.

Ruthenium(II) and osmium(II) vinyl complexes as highly sensitive and selective chromogenic and fluorogenic probes for the sensing of carbon monoxide in air.

The detection of carbon monoxide in solution and air has been achieved using simple, inexpensive systems based on the vinyl complexes [M(CHCHR)Cl(CO)(BTD)(PPh3 )2 ] (R=aryl, BTD=2,1,3-benzothiadiazole). Depending on the nature of the vinyl group, chromogenic and fluorogenic responses signalled the presence of this odourless, tasteless, invisible, and toxic gas. Solutions of the complexes in CHCl3 underwent rapid change between easily differentiated colours when exposed to air samples containing CO. More significantly, the adsorption of the complexes on silica produced colorimetric probes for the naked-eye detection of CO in the gas phase. Structural data for key species before and after the addition of CO were obtained by means of single X-ray diffraction studies. In all cases, the ruthenium and osmium vinyl complexes studied showed a highly selective response to CO with exceptionally low detection limits. Naked-eye detection of CO at concentrations as low as 5 ppb in air was achieved with the onset of toxic levels (i.e., 100 ppm), thus resulting in a remarkably clear colour change. Moreover, complexes bearing pyrenyl, naphthyl, and phenanthrenyl moieties were fluorescent, and greater sensitivities were achieved (through turn-on emission fluorescence) in the presence of CO both in solution and air. This behaviour was explored computationally using time-dependent density functional theory (TDDFT) experiments. In addition, the systems were shown to be selective for CO over all other gases tested, including water vapour and common organic solvents. Supporting the metal complexes on cellulose strips for use in an existing optoelectronic device allows numerical readings for the CO concentration to be obtained and provision of an alarm system.

Rationalization of an unusual solvent-induced inversion of enantiomeric excess in organocatalytic selenylation of aldehydes.

An unusual solvent-induced inversion of the sense of enantioselectivity observed in the α-selenylation of aldehydes catalyzed by a diphenylprolinol silyl ether catalyst is correlated to the presence of intermediates formed subsequent to the highly selective C-Se bond-forming step in the catalytic cycle. This work provides support for a mechanistic concept for enamine catalysis and includes a general role for "downstream intermediates" in selectivity outcomes in organocatalysis.

Continuous Flow Epoxidation of Alkenes Using a Homogeneous Manganese Catalyst with Peracetic Acid.

Epoxidation of alkenes is a valuable transformation in the synthesis of fine chemicals. Described herein are the design and development of a continuous flow process for carrying out the epoxidation of alkenes with a homogeneous manganese catalyst at metal loadings as low as 0.05 mol%. In this process, peracetic acid is generated in situ and telescoped directly into the epoxidation reaction, thus reducing the risks associated with its handling and storage, which often limit its use at scale. This flow process lessens the safety hazards associated with both the exothermicity of this epoxidation reaction and the use of the highly reactive peracetic acid. Controlling the speciation of manganese/2-picolinic acid mixtures by varying the ligand:manganese ratio was key to the success of the reaction. This continuous flow process offers an inexpensive, sustainable, and scalable route to epoxides.

Chiral, sequence-definable foldamer-derived macrocycles.

Nature's oligomeric macromolecules have been a long-standing source of inspiration for chemists producing foldamers. Natural systems are frequently conformationally stabilised by macrocyclisation, yet this approach has been rarely adopted in the field of foldamer chemistry. Here we present a new class of chiral cyclic trimers and tetramers formed by macrocyclisation of open-chain foldamer precursors. Symmetrical products are obtained via a [2 + 2] self-assembly approach, while full sequence control is demonstrated through linear synthesis and cyclisation of an unsymmetrical trimer. Structural characterisation is achieved through a combined X-ray and DFT approach, which indicates the tetramers adopt a near-planar conformation, while the trimers adopt a shallow bowl-like shape. Finally, a proof-of-concept experiment is conducted to demonstrate the macrocycles' capacity for cation binding.

C-H functionalisation of aldehydes using light generated, non-stabilised diazo compounds in flow.

The difficulty in accessing and safely utilising non-stabilised diazo species has in the past limited the application of this class of compounds. Here we explore further the use of oxadiazolines, non-stabilised diazo precursors which are bench stable, in direct, non-catalytic, aldehyde C-H functionalisation reactions under UV photolysis in flow and free from additives. Commercially available aldehydes are coupled to afford unsymmetrical aryl-alkyl and alkyl-alkyl ketones while mild conditions and lack of transition metal catalysts allow for exceptional functional group tolerance. Examples are given on small scale and in a larger scale continuous production.