Integrated pollution evaluation of the Tagus River in Central Spain.

The aim of this study was to integrate hydrochemical and sediment data in order to obtain a picture of the pollution state of the Tagus River along central Spain. This area is of special interest because tributaries from the Madrid region are discharged and no previous data were available. Waters and sediments were sampled between 2002 and 2004 from selected sites before and after Jarama River confluence (Madrid city input). The samples were analysed for more than 50 parameters, including those of physico-chemical nature and those reporting the pollution caused by both metals and organic compounds. The quality of waters for different uses has been tested and statistical quality indexes of both global and partial type has also been established. Sediments pollution state was evaluated by comparison with general quality standards. A high degree of pollution and general degradation was observed in the Tagus River downstream the Jarama River input. The pollution of waters is mainly related to parameters indicators of organic pollution from urban sewage. In sediments, a dramatic increase in the concentration of trace metals was found in different points, exceeding toxicological threshold. Further studies would be necessary for organic pollutants and also to evaluate the remobilization potential.

Bar adsorptive microextraction coated with multi-walled carbon nanotube phases - Application for trace analysis of pharmaceuticals in environmental waters.

Bar adsorptive microextraction devices were modified with multi-walled carbon nanotubes for the first time. A bar adsorptive microextraction method followed by microliquid desorption and high-performance liquid chromatography with diode array detection was developed for the determination of trace levels of ketoprofen, diclofenac, gemfibrozil and mefenamic acid in water samples. The mean parameters affecting the bar adsorptive microextraction and microliquid desorption efficiency were studied and optimized using a univariate optimization strategy. The methodology was validated in terms of linearity, limits of detection and quantification, recovery, intra- and inter-day precision, accuracy, and matrix effect. The developed method showed lower limits of quantification of 0.35 µg L-1, calibration curves from 0.35 up to 1000.0 µg L-1 and determination coefficients higher than 0.9917. Recoveries in tap, surface, sea and waste water samples at three spiking levels were between 70.2 and 117.3% for all the pharmaceuticals. The coefficients of variation values for intra- (n = 6) and inter-day precisions (n = 18) were below 9.7%. The proposed analytical methodology allowed preconcentration factors up to 250 and proved to be cost-effective, easy to operate and environmentally friendly.

Determination of sulfametoxazole, sulfadiazine and associated compounds in pharmaceutical preparations by capillary zone electrophoresis.

A capillary zone electrophoresis method is presented to separate sulfadiazine, sulfamethoxazole, trimethoprim, bromhexine and guaiacol by using a fused-silica capillary (60.2 cm x 75 microm I.D.). The separation was carried out at 30 kV and 25 degrees C in a 15 mM phosphate buffer adjusted to pH 6.2 as electrolyte. Under these conditions, the run time was 6 min and the limits of quantification were about 1 mg/l for every component. The method was applied to pharmaceutical preparations and the results provided recoveries close to 100%.

Simultaneous determination of sulfaquinoxaline, sulfamethazine and pyrimethamine by liquid chromatography.

A liquid chromatography method is described to determine sulfaquinoxaline (SQX), sulfamethazine (SMT), and pyrimethamine (PMT), by using a Kromasil C18 column and a 40 mM NaH2PO4 buffer solution, containing 10 mM NaClO4 (pH 3.0)-acetonitrile (65:35) as mobile phase. The mobile phase flow-rate and sample volume injected were 1.5 ml/min and 20 microl, respectively and the samples were dissolved in the mobile phase. The limits of quantification were found to be about 180 microg/l (3.6 ng) for each compound. The method was applied in veterinary commercial formulations. Analyses were made by means of the standard addition method, whose results were compared with those obtained by preparing "tests" (from the stock solutions) and with those obtained by a capillary electrophoresis method. Both methods showed similar results, and then it was proved that some commercial claimed levels were not in agreement with the obtained results by using our analytical method, as they were in other cases.

Comparative study of mercury speciation in commercial fishes of the Brazilian Amazon.

Mercury is responsible for serious episodes of environmental pollution throughout the world, especially in the Amazon. This toxicity has led regulatory agencies to focus on fish as the target organism for protecting the health of humans and other sensitive organisms. Unfortunately, in the Amazon area, different sampling strategies and the wide variety of sampling areas and fish species make it extremely difficult to determine relationships across geographic regions or over time to ascertain historical trends. Thus, the aim of this work was to achieve three main objectives: a comparative study of mercury contamination in fish of Itaituba (Tapajós, located downstream of the largest gold-mining region in Amazon) and Belém (an area non-exposed to mercury pollution of anthropogenic origin), perform an analysis of inorganic mercury (IHg) versus monomethylmercury (MeHg) contents, and, finally, compare mercury contamination in Tapajós over time. Five piscivorous species were obtained in Itaituba and Belém. Also, four non-piscivorous species were collected in Itaituba. For the first time, mercury speciation showed that (1) current MeHg levels in piscivorous species in Tapajós are higher than those of the non-exposed area, (2) piscivorous species from Itaituba (dourada, filhote, and sarda) contained mercury levels above the World Health Organization safety limit (~17%) and/or above the US Environmental Protection Agency tissue residue criterion (40%), (3) increased MeHg is usually accompanied by increased IHg, and (4) the mean total mercury concentrations for piscivorous species in Itaituba were within the same range and, associated uncertainties as those previously reported, although a remarkable decreasing trend over time was observed for mean total Hg concentrations in non-piscivorous species from Itaituba. The present study supports the importance of continuous monitoring of both populations in the Amazon Rivers. Our results will better assist the development of preventive strategies and governmental actions to confront the problem of mercury contamination in the Amazon.

Mercury speciation analysis in terrestrial animal tissues.

No previous analytical procedures are available and validated for mercury speciation analysis in terrestrial animal tissues. This analysis is a difficult task both because the expected concentrations are low, since important accumulation process are not likely to occur, and also because there are not commercially available certified reference material. Thus, an analytical methodology has been developed and validated for mercury speciation for the specific case of terrestrial animal tissues. The proposed method is based on the quantitative extraction of the species by closed-vessel microwave assisted heating with an alkaline reagent, followed by ethylation. The ethylated derivatives were then submitted to head-space solid phase microextraction with a 100 µm polidimethylsiloxane-coated fiber, and desorbed onto a gas chromatograph coupled to atomic fluorescence detection via pyrolysis unit (HS-SPME-GC-pyro-AFS). Procedural detection limits were 31.8 ng g(-1) and 52.5 ng g(-1) for CH(3)Hg(+) and Hg(2+), respectively, for liver and 35.3 ng g(-1) and 58.1 ng g(-1) for CH(3)Hg(+) and Hg(2+), respectively, for kidney. These limits of detection are 5.5 and 6 times better than the obtained without solid phase microextraction for CH(3)Hg(+) and Hg(2+), respectively. The methodology was found linear up to 120 µg L(-1) and reproducible from one day to the following. It was validated with certified reference materials NCS ZC 71001 (beef liver) and BCR No 186 (pig kidney) for total mercury, calculated as the sum of species, and with spiked red deer liver and kidney for speciation. Finally, it was applied to the analysis of samples of red deer liver, red deer kidney and wild boar kidney coming from the Almadén's mercury mining area (Ciudad Real, Spain), the longest and largest producer of mercury in the world until its closure in 2002.

Mercury in the Tapajós River basin, Brazilian Amazon: a review.

This paper presents a review about mercury contamination and human exposure in the Tapajós River basin (Brazil), one of the major tributaries of the Amazon impacted by traditional gold mining from the mid 1980s. The most recent review in this region was published more than ten years ago and since then many articles about environment and especially human populations have revealed new aspects of mercury toxicology. Additionally, new biomarkers of mercury exposure and toxicity have been studied in these populations. However, there are still many open, about both mercury's biogeochemical cycle and mercury health risks. Further environmental and human risk research directions are proposed.

Determination of monomethylmercury in low- and high-polluted sediments by microwave extraction and gas chromatography with atomic fluorescence detection.

The analysis of monomethylmercury (MMHg) in sediments is a difficult task because both very low concentrations and interconversion between species especially in highly polluted samples are frequent. This work features a general strategy for real sediment analysis with preconcentration and/or clean-up steps for both low- and high-polluted sediments to control these specific problems. The extraction conditions have been optimized using closed-vessel microwave-assisted heating with acidic extractants. The analysis has been carried out by the injection of ethylated derivatives of the analytes into a capillary gas chromatographic system coupled to fluorescence spectrometry. When using 6M HNO3, the most labile inorganic mercury fraction as well as MMHg were extracted from the sediment but there was still some inorganic mercury that remained un-extracted. MMHg was stable and quantitatively recovered by applying this procedure. The role of the labile inorganic fraction on artifact MMHg generation has been evaluated and it has been found to be highly variable depending on the sediments' geochemical characteristics. Therefore, for high-polluted sediments (inorganic mercury concentration above 500 ngg(-1)) a clean-up step with dichloromethane has been used before ethylation, whereas for low content samples, preconcentration under nitrogen stream at room temperature has been optimized. Both steps can be combined if necessary. MMHg content has been found in good agreement with the certified value for the reference materials (IAEA-405 and ERM-CC580).