RESUMO
The ferroelectric semiconductor α-SnTe has been regarded as a topological crystalline insulator, and the dispersion of its surface states has been intensively measured with angle-resolved photoemission spectroscopy (ARPES) over the past decade. However, much less attention has been given to the impact of the ferroelectric transition on its electronic structure, and in particular on its bulk states. Here, we investigate the low-energy electronic structure of α-SnTe with ARPES and follow the evolution of the bulk-state Rashba splitting as a function of temperature, across its ferroelectric critical temperature of about Tc ≈ 110 K. Unexpectedly, we observe a persistent band splitting up to room temperature, which is consistent with an order-disorder contribution of local dipoles to the phase transition that requires the presence of fluctuating dipoles above Tc. We conclude that no topological surface state can occur under these conditions at the (111) surface of SnTe, at odds with recent literature.
RESUMO
The HERMES beamline (High Efficiency and Resolution beamline dedicated to X-ray Microscopy and Electron Spectroscopy), built at Synchrotron SOLEIL (Saint-Auban, France), is dedicated to soft X-ray microscopy. The beamline combines two complementary microscopy methods: XPEEM (X-ray Photo Emitted Electron Microscopy) and STXM (Scanning Transmission X-ray Microscopy) with an aim to reach spatial resolution below 20â nm and to fully exploit the local spectroscopic capabilities of the two microscopes. The availability of the two methods within the same beamline enables the users to select the appropriate approach to study their specific case in terms of sample environment, spectroscopy methods, probing depth etc. In this paper a general description of the beamline and its design are presented. The performance and specifications of the beamline will be reviewed in detail. Moreover, the article is aiming to demonstrate how the beamline performances have been specifically optimized to fulfill the specific requirements of a soft X-ray microscopy beamline in terms of flux, resolution, beam size etc. Special attention has been dedicated to overcome some limiting and hindering problems that are usually encountered on soft X-ray beamlines such as carbon contamination, thermal stability and spectral purity.
RESUMO
Fast, reversible, and low-power manipulation of the spin texture is crucial for next generation spintronic devices like non-volatile bipolar memories, switchable spin current injectors or spin field effect transistors. Ferroelectric Rashba semiconductors (FERSC) are the ideal class of materials for the realization of such devices. Their ferroelectric character enables an electronic control of the Rashba-type spin texture by means of the reversible and switchable polarization. Yet, only very few materials are established to belong to this class of multifunctional materials. Here, Pb1- xGexTe is unraveled as a novel FERSC system down to nanoscale. The ferroelectric phase transition and concomitant lattice distortion are demonstrated by temperature dependent X-ray diffraction, and their effect on electronic properties are measured by angle-resolved photoemission spectroscopy. In few nanometer-thick epitaxial heterostructures, a large Rashba spin-splitting is exhibiting a wide tuning range as a function of temperature and Ge content. This work defines Pb1- xGexTe as a high-potential FERSC system for spintronic applications.
RESUMO
Altermagnetic (AM) materials exhibit non-relativistic, momentum-dependent spin-split states, ushering in new opportunities for spin electronic devices. While the characteristics of spin-splitting are documented within the framework of the non-relativistic spin group symmetry, there is limited exploration of the inclusion of relativistic symmetry and its impact on the emergence of a novel spin-splitting in the band structure. This study delves into the intricate relativistic electronic structure of an AM material, α-MnTe. Employing temperature-dependent angle-resolved photoelectron spectroscopy across the AM phase transition, the emergence of a relativistic valence band splitting concurrent with the establishment of magnetic order is elucidated. This discovery is validated through disordered local moment calculations, modeling the influence of magnetic order on the electronic structure and confirming the magnetic origin of the observed splitting. The temperature-dependent splitting is ascribed to the advent of relativistic spin-splitting resulting from the strengthening of AM order in α-MnTe as the temperature decreases. This sheds light on a previously unexplored facet of this intriguing material.
RESUMO
Quantum well (QW) heterostructures have been extensively used for the realization of a wide range of optical and electronic devices. Exploiting their potential for further improvement and development requires a fundamental understanding of their electronic structure. So far, the most commonly used experimental techniques for this purpose have been all-optical spectroscopy methods that, however, are generally averaging in momentum space. Additional information can be gained by angle-resolved photoelectron spectroscopy (ARPES), which measures the electronic structure with momentum resolution. Here we report on the use of extremely low-energy ARPES (photon energy ~ 7 eV) to increase depth sensitivity and access buried QW states, located at 3 nm and 6 nm below the surface of cubic-GaN/AlN and GaAs/AlGaAs heterostructures, respectively. We find that the QW states in cubic-GaN/AlN can indeed be observed, but not their energy dispersion, because of the high surface roughness. The GaAs/AlGaAs QW states, on the other hand, are buried too deep to be detected by extremely low-energy ARPES. Since the sample surface is much flatter, the ARPES spectra of the GaAs/AlGaAs show distinct features in momentum space, which can be reconducted to the band structure of the topmost surface layer of the QW structure. Our results provide important information about the samples' properties required to perform extremely low-energy ARPES experiments on electronic states buried in semiconductor heterostructures.
RESUMO
The van de Waals heterostructure formed by an epitaxial trilayer graphene is of particular interest due to its unique tunable electronic band structure and stacking sequence. However, to date, there has been a lack in the fundamental understanding of the electronic properties of epitaxial trilayer graphene. Here, we investigate the electronic properties of large-area epitaxial trilayer graphene on a 4° off-axis SiC(0001) substrate. Micro-Raman mappings and atomic force microscopy (AFM) confirmed predominantly trilayer on the sample obtained under optimized conditions. We used angle-resolved photoemission spectroscopy (ARPES) and Density Functional Theory (DFT) calculations to study in detail the structure of valence electronic states, in particular the dispersion of π bands in reciprocal space and the exact determination of the number of graphene layers. Using far-infrared magneto-transmission (FIR-MT), we demonstrate, that the electron cyclotron resonance (CR) occurs between Landau levels with a (B)(1/2) dependence. The CR line-width is consistent with a high Dirac fermions mobility of ~3000 cm(2)·V(-1)·s(-1) at 4 K.
RESUMO
The stacking order of multilayer graphene has a profound influence on its electronic properties. In particular, it has been predicted that a rhombohedral stacking sequence displays a very flat conducting surface state: the longer the sequence, the flatter the band. In such a flat band, the role of electron-electron correlation is enhanced, possibly resulting in high Tc superconductivity, magnetic order, or charge density wave order. Here we demonstrate that rhombohedral multilayers are easily obtained by epitaxial growth on 3C-SiC(111) on a 2° off-axis 6H-SiC(0001). The resulting samples contain rhombohedral sequences of five layers on 70% of the surface. We confirm the presence of the flat band at the Fermi level by scanning tunneling spectroscopy and angle-resolved photoemission spectroscopy, in close agreement with the predictions of density functional theory calculations.
RESUMO
Stacking various two-dimensional atomic crystals is a feasible approach to creating unique multilayered van der Waals heterostructures with tailored properties. Herein for the first time, we present a controlled preparation of large-area h-BN/graphene heterostructures via a simple chemical deposition of h-BN layers on epitaxial graphene/SiC(0001). Van der Waals forces, which are responsible for the cohesion of the multilayer system, give rise to an abrupt interface without interdiffusion between graphene and h-BN, as shown by X-ray Photoemission Spectroscopy (XPS) and direct observation using scanning and High-Resolution Transmission Electron Microscopy (STEM/HRTEM). The electronic properties of graphene, such as the Dirac cone, remain intact and no significant charge transfer i.e. doping, is observed. These results are supported by Density Functional Theory (DFT) calculations. We demonstrate that the h-BN capped graphene allows the fabrication of vdW heterostructures without altering the electronic properties of graphene.