The dynamics of SARS-CoV-2 infectivity with changes in aerosol microenvironment.

Understanding the factors that influence the airborne survival of viruses such as severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) in aerosols is important for identifying routes of transmission and the value of various mitigation strategies for preventing transmission. We present measurements of the stability of SARS-CoV-2 in aerosol droplets (∼5 to 10 µm equilibrated radius) over timescales spanning 5 s to 20 min using an instrument to probe survival in a small population of droplets (typically 5 to 10) containing ∼1 virus/droplet. Measurements of airborne infectivity change are coupled with a detailed physicochemical analysis of the airborne droplets containing the virus. A decrease in infectivity to ∼10% of the starting value was observable for SARS-CoV-2 over 20 min, with a large proportion of the loss occurring within the first 5 min after aerosolization. The initial rate of infectivity loss was found to correlate with physical transformation of the equilibrating droplet; salts within the droplets crystallize at relative humidities (RHs) below 50%, leading to a near-instant loss of infectivity in 50 to 60% of the virus. However, at 90% RH, the droplet remains homogenous and aqueous, and the viral stability is sustained for the first 2 min, beyond which it decays to only 10% remaining infectious after 10 min. The loss of infectivity at high RH is consistent with an elevation in the pH of the droplets, caused by volatilization of CO2 from bicarbonate buffer within the droplet. Four different variants of SARS-CoV-2 were compared and found to have a similar degree of airborne stability at both high and low RH.

Drying Kinetics and Particle Formation from Dilute Colloidal Suspensions in Aerosol Droplets.

Industrial processes such as spray drying of pharmaceutical and food products often involve the drying of aerosol droplets containing colloidal suspensions into powdered microparticles of desired properties. The morphology and surface properties of the final dry products/microparticles obtained after the drying process are strongly influenced by the parameters of the initial aerosol droplet composition and the drying conditions. In particular, the final dry microparticle morphology can be dependent on the dimensionless Péclet number (Pe), which expresses the relative competition between the diffusion of the dispersed particles within the droplet and the rate of solvent loss via evaporation. In this work, we examine how control over the gas phase drying conditions and initial aerosol droplet composition can be used to influence the aerosol droplet drying kinetics in the gas phase for a range of Péclet numbers. We used a single-particle levitation instrument, the electrodynamic balance, to measure the drying kinetics of colloidal silica droplets (0.10-0.60% v/v) under controlled gas phase drying conditions of temperature (263-326 K) and relative humidity (0-90%) and obtained Péclet numbers ranging from 4.05 to 184.5. We demonstrate that, for aerosol droplets with initially dilute feed colloid concentrations and within the constant evaporation regime, the starting composition does not strongly influence the solvent evaporation rate with the included nanoparticles (NPs) acting as spectators. However, the gas phase drying conditions, temperature, and relative humidity, directly influence the droplet temperature via evaporative cooling as well as the droplet drying kinetics and the final dry microparticle properties. With a priori knowledge of the droplet drying kinetics from the single droplet measurements, we further demonstrate the possibility of tailoring the morphology of the dried microparticles. Dried silica microparticles collected at Pe = 23.8 had dense spherical morphologies, while those at the highest Pe = 180.0 had crumpled surface morphologies with a transition in morphology between these limiting Pe values. Our results extend the fundamental understanding of the mechanisms controlling the drying of aerosol droplets in colloidal suspensions across a wide range of application areas extending from spray drying to the drying of respiratory fluid droplets containing bacteria and viruses and the drying of atmospheric aerosol droplets.

Accurate Measurements and Simulations of the Evaporation and Trajectories of Individual Solution Droplets.

A refined numerical model for the evaporation and transport of droplets of binary solutions is introduced. Benchmarking is performed against other models found in the literature and experimental measurements of both electrodynamically trapped and freefalling droplets. The model presented represents the microphysical behavior of solutions droplets in the continuum and transition regimes, accounting for the unique hygroscopic behavior of different solutions, including the Fuchs-Sutugin and Cunningham slip correction factors, and accounting for the Kelvin effect. Simulations of pure water evaporation are experimentally validated for temperatures between 290 K and 298 K and between relative humidity values of approximately 0% and 85%. Measurements and simulations of the spatial trajectories and evaporative behavior of aqueous sodium chloride droplets are compared for relative humidity values between 0 and 40%. Simulations are shown to represent experimental data within experimental uncertainty in initial conditions. Calculations of a time-dependent Péclet number, including the temperature dependence of solute diffusion, are related to morphologies of sodium chloride particles dried at different rates. For sodium chloride solutions, dried particles are composed of collections of reproducibly shaped crystals, with higher evaporation rates resulting in higher numbers of crystals, which are smaller.

Mucin Transiently Sustains Coronavirus Infectivity through Heterogenous Changes in Phase Morphology of Evaporating Aerosol.

Respiratory pathogens can be spread though the transmission of aerosolised expiratory secretions in the form of droplets or particulates. Understanding the fundamental aerosol parameters that govern how such pathogens survive whilst airborne is essential to understanding and developing methods of restricting their dissemination. Pathogen viability measurements made using Controlled Electrodynamic Levitation and Extraction of Bioaerosol onto Substrate (CELEBS) in tandem with a comparative kinetics electrodynamic balance (CKEDB) measurements allow for a direct comparison between viral viability and evaporation kinetics of the aerosol with a time resolution of seconds. Here, we report the airborne survival of mouse hepatitis virus (MHV) and determine a comparable loss of infectivity in the aerosol phase to our previous observations of severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2). Through the addition of clinically relevant concentrations of mucin to the bioaerosol, there is a transient mitigation of the loss of viral infectivity at 40% RH. Increased concentrations of mucin promoted heterogenous phase change during aerosol evaporation, characterised as the formation of inclusions within the host droplet. This research demonstrates the role of mucus in the aerosol phase and its influence on short-term airborne viral stability.