Printable organometallic perovskite enables large-area, low-dose X-ray imaging.

Medical X-ray imaging procedures require digital flat detectors operating at low doses to reduce radiation health risks. Solution-processed organic-inorganic hybrid perovskites have characteristics that make them good candidates for the photoconductive layer of such sensitive detectors. However, such detectors have not yet been built on thin-film transistor arrays because it has been difficult to prepare thick perovskite films (more than a few hundred micrometres) over large areas (a detector is typically 50 centimetres by 50 centimetres). We report here an all-solution-based (in contrast to conventional vacuum processing) synthetic route to producing printable polycrystalline perovskites with sharply faceted large grains having morphologies and optoelectronic properties comparable to those of single crystals. High sensitivities of up to 11 microcoulombs per air KERMA of milligray per square centimetre (µC mGyair-1 cm-2) are achieved under irradiation with a 100-kilovolt bremsstrahlung source, which are at least one order of magnitude higher than the sensitivities achieved with currently used amorphous selenium or thallium-doped cesium iodide detectors. We demonstrate X-ray imaging in a conventional thin-film transistor substrate by embedding an 830-micrometre-thick perovskite film and an additional two interlayers of polymer/perovskite composites to provide conformal interfaces between perovskite films and electrodes that control dark currents and temporal charge carrier transportation. Such an all-solution-based perovskite detector could enable low-dose X-ray imaging, and could also be used in photoconductive devices for radiation imaging, sensing and energy harvesting.

Roadmap on halide perovskite and related devices.

Since the first report on solid-state perovskite solar cells (PSCs) with ∼10% power conversion efficiency (PCE) and 500 h-stability in 2012, tremendous effort has been being devoted to develop PSCs with higher PCE, longer stability and recycling hazardous lead waste. As a result, PCE over 23% was recorded in 2018 and stability over 10 000 h was reported. Beyond photovoltaics, lead halide perovskite materials demonstrated superb properties when they were applied to flat-panel x-ray detectors and non-volatile resistive switching memory. In this review, the progress of the lead halide perovskite in photovoltaics, x-ray imaging and memristors is investigated. Pb-based PSCs and non-Pb-based PSCs are compared, where technologies of non-Pb-based PSCs are not matured for commercialization. Pb-based PSCs were found to be highly suitable for both terrestrial and space photovoltaics. Higher sensitivity under low dose rate observed from the lead halide perovskite suggests a bright future for perovskite x-ray imaging systems. Moreover, high on/off ratio and low energy consumption observed in resistive switching enables perovskite to be a promising candidate for high density memristors.