Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 5 de 5
Filtrar
Mais filtros

Base de dados
Tipo de documento
País de afiliação
Intervalo de ano de publicação
1.
J Clin Periodontol ; 51(2): 158-166, 2024 02.
Artigo em Inglês | MEDLINE | ID: mdl-38058254

RESUMO

AIM: This study aimed at investigating the efficacy of a 0.05% cetylpyridinium chloride-0.05% chlorhexidine (CPC-CHX) mouthwash in reducing viral load in the saliva as compared with sterile water. MATERIALS AND METHODS: Forty SARS-CoV-2 positive patients were asked to dispense 4 mL of saliva. Half the patients rinsed for 60 s with 15 mL CPC-CHX, and the remaining patients rinsed with sterile water (control). Four millilitres of saliva were collected after 15, 30 and 60 min after rinsing. Quantitative reverse transcriptase polymerase chain reaction (RT-qPCR) and enzyme-linked immunosorbent assay (ELISA) specific for SARS-CoV-2 nucleocapsid protein were performed. For ELISA, the intact (representing the active virus) to total virus load (I/T) was calculated. RESULTS: SARS-CoV-2 copy numbers/mL from RT-qPCR tended to decrease in the control group, whereas in the CPC-CHX group, an increase was observed after T30. However, mixed linear model analysis revealed no statistical differences between groups (p = .124), time points (p = .616) and vaccinated or non-vaccinated patients (p = .953). Similarly, no impact of group (p = .880), time points (p = .306) and vaccination (p = .711) was observed for I/T ratio values. CONCLUSIONS: Within the limitation of this study, there was no evidence that the intervention reduced salivary SARS-CoV-2 viral load during the course of 60 min. Therefore, commonly used pre-procedural rinsing might not be clinically relevant.


Assuntos
Antivirais , COVID-19 , Antissépticos Bucais , Humanos , Antivirais/uso terapêutico , Cetilpiridínio/uso terapêutico , Clorexidina/uso terapêutico , COVID-19/prevenção & controle , Método Duplo-Cego , Antissépticos Bucais/uso terapêutico , Saliva , SARS-CoV-2 , Água
2.
Artigo em Inglês | MEDLINE | ID: mdl-37565539

RESUMO

OBJECTIVES: Surgical guides are frequently used for dental implant placement. The aim of this study was to evaluate the impact of the 3D printing process itself and subsequent steam autoclaving on the dimensional stability of five different resin/printer combinations (RPCs). MATERIALS AND METHODS: Fifty identical surgical guides (10 per group) were produced consisting of five RPCs. Half of the guides (5 per group) were steam autoclaved with cycle 1 (121°C, 1 bar, 20.5 min) and the other half with cycle 2 (134°C, 2 bar, 5.5 min). All guides were scanned with a structured-light (SL) 3D scanner before (T0) and after (T1) autoclaving. Linear measurements along the x-, y-, and z-axes were performed at landmarks on the original STL file and on SL scans at T0 and T1, respectively. Wilcoxon signed-rank test, Kruskal-Wallis test, and linear mixed-effects models were performed, depending on the analysis. RESULTS: Three-dimensional printing was associated with significant dimensional alterations for all RPCs. Steam autoclaving using cycle 1 was associated with significant shrinkage in x- (1 RPC), y- (2 RPCs), and z-direction (2 RPCs), while cycle 2 was also associated with shrinkage in x- (2 RPCs), y- (1 RPC), and z-direction (1 RPC). One resin did not present any dimensional changes independently of the cycle. CONCLUSIONS: The majority of the guides presented minor but significant shrinkage due to 3D printing itself and both steam autoclaving cycles, the extent varied between different RPCs. Whether these changes compromise implant placement accuracy remains to be investigated.

3.
Clin Oral Investig ; 27(6): 3009-3019, 2023 Jun.
Artigo em Inglês | MEDLINE | ID: mdl-36800025

RESUMO

OBJECTIVES: To investigate the extension of experimentally induced peri-implantitis lesions under various antiresorptive and antiangiogenic medications. MATERIAL AND METHODS: Fourty-eight albino rats had randomly received the following medications (dual application, n = 8 each): (1) amino-bisphosphonate (zoledronate) (Zo), (2) RANKL inhibitor (denosumab) (De), (3) antiangiogenic (bevacizumab) (Be), (4) Zo+Be, (5) De+Be, or (6) no medication (Co). Ligature- and lipopolysaccharide-induced peri-implantitis lesions were established at 2 maxillary implants over a period of 16 weeks. Histological (e.g., apical extension and surface area of the inflammatory cell infiltrate-aICT, ICT; defect length; defect width; CD68 positive cells) and bone micromorphometric (µCT) outcomes were assessed. The animal was defined as a statistical unit. RESULTS: A total of n = 38 animals (Zo = 6, De = 6, Be = 8, Zo + Be = 6, De + Be = 5, Co = 7) were analyzed. ICT's were commonly marked by a positive CD68 antigen reactivity. Comparable median aICT (lowest-Zo: 0.53 mm; highest-Be: 1.22 mm), ICT (lowest-De + Be: 0.00 mm2; highest-Co: 0.49 mm2), defect length (lowest-Zo: 0.90 mm; highest-Co: 1.93 mm) and defect width (lowest-De+Be: 1.27 mm; highest-Be: 1.80 mm) values were noted in all test and control groups. Within an inner (diameter: 0.8 mm) cylindric volume of interest, the bone microstructure did not significantly differ between groups. CONCLUSIONS: The present analysis did not reveal any marked effects of various antiresorptive/ antiangiogenic medications on the extension of experimentally induced peri-implantitis lesions. CLINICAL RELEVANCE: The extension of peri-implantitis lesions may not be facilitated by the antiresorptive and antiangiogenic medications investigated.


Assuntos
Implantes Dentários , Peri-Implantite , Estimulação Elétrica Nervosa Transcutânea , Animais , Osso e Ossos/patologia , Ligadura , Peri-Implantite/tratamento farmacológico , Ratos
4.
Clin Oral Investig ; 26(8): 5359-5368, 2022 Aug.
Artigo em Inglês | MEDLINE | ID: mdl-35449246

RESUMO

OBJECTIVES: The objective of this study was to volumetrically assess changes in the periodontal microstructure under antiresorptive therapy. MATERIALS AND METHODS: Microtomographic scans from a total of 9 Dutch Belted rabbits having been randomly allocated to either the intravenous administration of amino-bisphosphonate (zoledronic acid) (Za) (n = 5) or a negative control group (nZa) (n = 4) were obtained at 10 months following a repeated drug administration. A quantification of the periodontal space thickness (P.Th) of both maxillary and mandibular most posterior premolars, as well as of the 2nd molars was performed. Bone micromorphometry was assessed by means of bone volume per total volume (BV/TV), the bone mineral density (BMD), trabecular thickness (Tb.Th), trabecular number (Tb.N), bone surface (BS), and the specific bone surface (BS/BV). RESULTS: Za was associated with significantly higher P.Th (P = 0.010), which was most pronounced in the upper jaw. Bone micromorphometry revealed no significant differences among the two groups, i.e., Za and nZa, for all the investigated parameters. CONCLUSIONS: Volumetric analysis revealed that antiresorptive therapy was associated with periodontal space widening, whereas major effects on the bone micro-morphology could not be observed. CLINICAL RELEVANCE: A deep understanding of specific periodontal and alveolar bone alterations in patients under antiresorptive therapy might help to prevent the onset of medication-related osteonecrosis of the jaw.


Assuntos
Difosfonatos , Osteonecrose , Animais , Coelhos , Densidade Óssea , Difosfonatos/farmacologia , Maxila , Dente Molar , Microtomografia por Raio-X
5.
Bone ; 177: 116912, 2023 Dec.
Artigo em Inglês | MEDLINE | ID: mdl-37739299

RESUMO

Implant migration has been described as a minor displacement of orthodontic mini-implants (OMIs) when subjected to constant forces. Aim of this study was to evaluate the impact of local stresses on implant migration and bone remodelling around constantly loaded OMIs. Two mini-implants were placed in one caudal vertebra of 61 rats, connected by a nickel­titanium contraction spring, and loaded with different forces (0.0, 0.5, 1.0, 1.5 N). In vivo micro-CT scans were taken immediately and 1, 2 (n = 61), 4, 6 and 8 (n = 31) weeks post-op. Nine volumes of interest (VOIs) around each implant were defined. To analyse stress values, micro-finite element models were created. Bone remodelling was analysed by calculating the bone volume change between scans performed at consecutive time points. Statistical analysis was performed using a linear mixed model and likelihood-ratio-tests, followed by Tuckey post hoc tests when indicated. The highest stresses were observed in the proximal top VOI. In all VOIs, stress values tended to reach their maximum after two weeks and decreased thereafter. Bone remodelling analysis revealed initial bone loss within the first two weeks and bone gain up to week eight, which was noted especially in the highest loading group. The magnitude of local stresses influenced bone remodelling and it can be speculated that the stress related bone resorption favoured implant migration. After a first healing phase with a high degree of bone resorption, net bone gain representing consolidation was observed.

SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA