Performance assessment of a triple-junction solar cell with 1.0 eV GaAsBi absorber.

Group III-V semiconductor multi-junction solar cells are widely used in concentrated-sun and space photovoltaic applications due to their unsurpassed power conversion efficiency and radiation hardness. To further increase the efficiency, new device architectures rely on better bandgap combinations over the mature GaInP/InGaAs/Ge technology, with Ge preferably replaced by a 1.0 eV subcell. Herein, we present a thin-film triple-junction solar cell AlGaAs/GaAs/GaAsBi with 1.0 eV dilute bismide. A compositionally step-graded InGaAs buffer layer is used to integrate high crystalline quality GaAsBi absorber. The solar cells, grown by molecular-beam epitaxy, achieve 19.1% efficiency at AM1.5G spectrum, 2.51 V open-circuit voltage, and 9.86 mA/cm2 short-circuit current density. Device analysis identifies several routes to significantly improve the performance of the GaAsBi subcell and of the overall solar cell. This study is the first to report on multi-junctions incorporating GaAsBi and is an addition to the research on the use of bismuth-containing III-V alloys in photonic device applications.

Seed Layer Optimisation for Ultra-Thin Sb2Se3 Solar Cells on TiO2 by Vapour Transport Deposition.

Antimony selenide (Sb2Se3) material has drawn considerable attention as an Earth-abundant and non-toxic photovoltaic absorber. The power conversion efficiency of Sb2Se3-based solar cells increased from less than 2% to over 10% in a decade. Different deposition methods were implemented to synthesize Sb2Se3 thin films, and various device structures were tested. In search of a more environmentally friendly device composition, the common CdS buffer layer is being replaced with oxides. It was identified that on oxide substrates such as TiO2 using vacuum-based close-space deposition methods, an intermediate deposition step was required to produce high-quality thin films. However, little or no investigation was carried out using another very successful vacuum deposition approach in Sb2Se3 technology called vapour transport deposition (VTD). In this work, we present optimized VTD process conditions to achieve compact, pinhole-free, ultra-thin (<400 nm) Sb2Se3 absorber layers. Three process steps were designed to first deposit the seed layer, then anneal it and, at the final stage, deposit a complete Sb2Se3 absorber. Fabricated solar cells using absorbers as thin as 400 nm generated a short-circuit current density over 30 mA/cm2, which demonstrates both the very high absorption capabilities of Sb2Se3 material and the prospects for ultra-thin solar cell application.

Photoreflectance and Photoluminescence Study of Antimony Selenide Crystals.

Among inorganic, Earth-abundant, and low-toxicity photovoltaic technologies, Sb2Se3 has emerged as a strong material contender reaching over 10% solar cell power conversion efficiency. Nevertheless, the bottleneck of this technology is the high deficit of open-circuit voltage (V OC) as seen in many other emerging chalcogenide technologies. Commonly, the loss of V OC is related to the nonradiative carrier recombination through defects, but other material characteristics can also limit the achievable V OC. It has been reported that in isostructural compound Sb2S3, self-trapped excitons are readily formed leading to 0.6 eV Stokes redshift in photoluminescence (PL) and therefore significantly reducing the obtainable V OC. However, whether Sb2Se3 has the same limitations has not yet been examined. In this work, we aim to identify main radiative carrier recombination mechanisms in Sb2Se3 single crystals and estimate if there is a fundamental limit for obtainable V OC. Optical transitions in Sb2Se3 were studied by means of photoreflectance and PL spectroscopy. Temperature, excitation intensity, and polarization-dependent optical characteristics were measured and analyzed. We found that at low temperature, three distinct radiative recombination mechanisms were present and were strongly influenced by the impurities. The most intensive PL emissions were located near the band edge. In conclusion, no evidence of emission from self-trapped excitons or band-tails was observed, suggesting that there is no fundamental limitation to achieve high V OC, which is very important for further development of Sb2Se3-based solar cells.

Synthesis and physical characteristics of narrow bandgap chalcogenide SnZrSe 3.

Background: The development of organic/inorganic metal halide perovskites has seen unprecedent growth since their first recognition for applications in optoelectronic devices. However, their thermodynamic stability and toxicity remains a challenge considering wide-scale deployment in the future. This spurred an interest in search of perovskite-inspired materials which are expected to retain the advantageous material characteristics of halide perovskites, but with high thermodynamic stability and composed of earth-abundant and low toxicity elements. ABX 3 chalcogenides (A, B=metals, X=Se, S) have been identified as potential class of materials meeting the aforementioned criteria. Methods: In this work, we focus on studying tin zirconium selenide (SnZrSe 3) relevant physical properties with an aim to evaluate its prospects for application in optoelectronics. SnZrSe 3 powder and monocrystals were synthesized via solid state reaction in 600 - 800 °C temperature range. Crystalline structure was determined using single crystal and powder X-ray diffraction methods. The bandgap was estimated from diffused reflectance measurements on powder samples and electrical properties of crystals were analysed from temperature dependent I-V measurements. Results: We found that SnZrSe 3 crystals have a needle-like structure (space group - Pnma) with following unit cell parameters: a=9.5862(4) Å, b=3.84427(10) Å, c=14.3959(5) Å. The origin of the low symmetry crystalline structure was associated with stereochemical active electron lone pair of Sn cation. Estimated bandgap was around 1.15 eV which was higher than measured previously and predicted theoretically. Additionally, it was found that resistivity and conductivity type depended on the compound chemical composition. Conclusions: Absorption edge in the infrared region and bipolar dopability makes SnZrSe 3 an interesting material candidate for application in earth-abundant and non-toxic single/multi-junction solar cells or other infrared based optoelectronic devices.

Rapid thermal evaporation for cadmium selenide thin-film solar cells.

Cadmium selenide (CdSe) belongs to the binary II-VI group semiconductor with a direct bandgap of ∼1.7 eV. The suitable bandgap, high stability, and low manufacturing cost make CdSe an extraordinary candidate as the top cell material in silicon-based tandem solar cells. However, only a few studies have focused on CdSe thin-film solar cells in the past decades. With the advantages of a high deposition rate (∼2 °m/min) and high uniformity, rapid thermal evaporation (RTE) was used to maximize the use efficiency of CdSe source material. A stable and pure hexagonal phase CdSe thin film with a large grain size was achieved. The CdSe film demonstrated a 1.72 eV bandgap, narrow photoluminescence peak, and fast photoresponse. With the optimal device structure and film thickness, we finally achieved a preliminary efficiency of 1.88% for CdSe thin-film solar cells, suggesting the applicability of CdSe thin-film solar cells.

Vapor transport deposition of antimony selenide thin film solar cells with 7.6% efficiency.

Antimony selenide is an emerging promising thin film photovoltaic material thanks to its binary composition, suitable bandgap, high absorption coefficient, inert grain boundaries and earth-abundant constituents. However, current devices produced from rapid thermal evaporation strategy suffer from low-quality film and unsatisfactory performance. Herein, we develop a vapor transport deposition technique to fabricate antimony selenide films, a technique that enables continuous and low-cost manufacturing of cadmium telluride solar cells. We improve the crystallinity of antimony selenide films and then successfully produce superstrate cadmium sulfide/antimony selenide solar cells with a certified power conversion efficiency of 7.6%, a net 2% improvement over previous 5.6% record of the same device configuration. We analyze the deep defects in antimony selenide solar cells, and find that the density of the dominant deep defects is reduced by one order of magnitude using vapor transport deposition process.

Biosynthesis of silver nanoparticles using lingonberry and cranberry juices and their antimicrobial activity.

In this study lingonberry and cranberry juices were used for silver nanoparticle synthesis. The berry juices were characterized by total phenolics, total anthocyanins and benzoic acid content, respectively 1.9-2.7mg/ml, 55.2-83.4mg/l and 590.8-889.2mg/l. The synthesis of silver nanoparticles was performed at room temperature assisting in solutions irradiated by ultraviolet for 30min. Ultraviolet-visible (UV-vis) spectroscopy and microscopy confirmed the formation of nanoparticles as well as the dark red color of colloid of silver samples showed the formation of stable nanoparticles. Broad localized surface plasmon resonance (LSPR) peaks in UV-vis spectra indicated the formation of polydispersive silver nanoparticles and LSPR was observed at 485nm and 520nm for the silver nanoparticles synthesis using lingonberry and cranberry juices, respectively. The antimicrobial activity of silver nanoparticles was determined against the reference strains of microorganisms that could be found in food products: Staphylococcus aureus ATCC 25923, Salmonella typhimurium ATCC 13076, Listeria monocytogenes ATCC 19111, Bacillus cereus ATCC 11778, Escherichia coli ATCC 25922, Bacillus subtilis ATCC 6633, Candida albicans ATCC 10231 and foodborne B. cereus producing and non-producing enterotoxins. Silver nanoparticles showed a broad spectrum of antimicrobial activity and were most active against S. aureus ATCC 25923, B. subtilis ATCC 6633 and B. cereus ATCC 11778 reference cultures, and less active against C. albicans ATCC 10231 and foodborne B. cereus. It can be concluded that lingonberry and cranberry juices could be used as bioreductants for silver ions.