RESUMO
This paper describes the development of new "leak/no-leak" emission factors that are suitable for estimating facilities' fugitive emissions when using an alternative work practice (AWP) that is based on optical gas imaging technology for detecting leaking piping system components. These emission factors were derived for valves, pumps, and connectors/flanges for instrument leak detection thresholds ranging from 3 to 60 g/hr using a combination of field data and Monte Carlo statistical simulation techniques. These newly derived leak/no-leak emission factors are designed to replace the U.S. Environment Protection Agency (EPA) 1995 Protocol factors, which were based on Method 21 monitoring of leaks at "uncontrolled" facilities. The emission factors published in the 1995 Protocol have not been updated since the 1970s. This derivation is based on results where the authors document the use of a Monte Carlo simulation technique to quantify the required leak detection thresholds that provide equal--or better--environmental benefits for an AWP. The use of these newly derived emission factors is demonstrated for different methods of computing fugitive emissions from a hypothetical model refinery. The resulting facility emissions calculated by using these new emission factors is compared with the existing emission estimation methods provided in the EPA 1995 Protocol. The results demonstrate that the new emission factors provide an emission estimate that is the closest to that obtained from the direct determination of total emissions by Monte Carlo simulations.
Assuntos
Monitoramento Ambiental/métodos , Poluentes Ambientais/análise , Indústrias Extrativas e de Processamento , Petróleo , Simulação por Computador , Gases/análise , Modelos Teóricos , Método de Monte CarloRESUMO
Controlling fugitive emissions from leaks in petrochemical industry process equipment now requires periodic monitoring of valves, flanges, pumps etc., typically on a quarterly basis. Previous studies have shown that over 90% of the reducible emissions come from approximately 0.1% of the components, i.e. the large leakers. A new, and more cost-effective approach for controlling these large leakers would entail more frequent monitoring of process equipment, allowing for the detection and repair of the highly leaking components that contribute the most to emissions. This approach has been called "Smart LDAR." New optical imaging instruments, which significantly reduce monitoring costs, are now available to implement such an alternative work practice. This work describes the determination of the leak detection sensitivity (equivalency threshold) that an optical imaging instrument must achieve to ensure that it will provide at least the equivalent emission control of the current leak detection and repair practice. Equivalency thresholds were developed for various monitoring intervals. The U.S. Environment Protection Agency's Monte Carlo simulation approach was used to perform the analysis and to demonstrate that optical imaging, which is capable of identifying all of the largest leakers, can provide better control of fugitive emissions.