A Superconducting Binary Encoder with Multigate Nanowire Cryotrons.

Many classic and quantum devices need to operate at cryogenic temperatures, demanding advanced cryogenic digital electronics for processing the input and output signals on a chip to extend their scalability and performance. Here, we report a superconducting binary encoder with ultralow power dissipation and ultracompact size. We introduce a multigate superconducting nanowire cryotron (nTron) that functions as an 8-input OR gate within a footprint of approximately 0.5 µm2. Four cryotrons compose a 4-bit encoder that has a bias margin of 18.9%, an operation speed greater than 250 MHz, an average switching jitter of 75 ps, and a power dissipation of less than 1 µW. We apply this encoder to read out a superconducting-nanowire single-photon detector array whose pixel location is digitized into a 4-bit binary address. The small size of the nanowire combined with the low power dissipation makes nTrons promising for future monolithic integration.

Characterize the switching performance of a superconducting nanowire cryotron for reading superconducting nanowire single photon detectors.

Scalable superconducting nanowire single photon detector (SNSPDs) arrays require cryogenic digital circuits for multiplexing the output detection pulses. Among existing superconducting digital devices, superconducting nanowire cryotron (nTron) is a three-terminal device with an ultra-compact size, which is promising for large scale monolithic integration. In this report, in order to evaluate the potential and possibility of using nTrons for reading and digitizing SNSPD signals, we characterized the grey zone, speed, timing jitter and power dissipation of a proper designed nTron. With a DC bias on the gate, the nTron can be triggered by a few µA high and nanoseconds wide input signal, showing the nTron was capable of reading an SNSPD pulse at the same signal level. The timing jitter depended on the input signal level. For a 20 µA high and 5 ns wide input pulse, the timing jitter was 33.3 ps, while a typical SNSPD's jitter was around 50 ps. With removing the serial inductors and operating it in an AC bias mode. The nTron was demonstrated to be operated at a clock frequency of 615.4 MHz, which was faster than the maximum counting rate of a typical SNSPD. In additional, with a 50 Ω bias resistor and biased at 17.6 µA, the nTron had a total power dissipation of 19.7 nW. Although RSFQ circuits are faster than nTrons, for reading SNSPD or other detector arrays that demands less operation speed, our results suggest a digital circuit made from nTrons could be another promising alternative.