RESUMO
In this article, a new and flexible approach to control the electric field enhancement of bow-tie nano-antennas by integrating them on the lateral of a tapered optical fiber is proposed. The device is driven by a Q-switched laser and the performance of a fabricated nano-antenna in a quartz slide is tested by a Surface Enhanced Raman Scattering (SERS) experiment. A refractive index sensing experiment is also performed and a sensitivity of (240 ± 30) nm/RIU is found in the 1.33-1.35 index range.
RESUMO
Nano-antennas are the optical equivalent of antennas that are used to transmit and receive information at radio frequencies. These antennas have been used in different applications in photonics such as optical imaging, particle manipulation, bio-sensing, and improvement of the performance of solar cells. In this article we study composite nano-antennas made of alternating layers of silica and gold. We show that a 50% filling factor leads to a 2.0 times increase in the electric-field enhancement factor when compared with a pure-gold antenna.
RESUMO
In recent years, graphene and its compounds (e.g., oxides) have been used as saturable absorbers in passive Q-switched and mode-locked lasers, leading to the fabrication of compact pulsed fiber lasers. In this article, we study the operation of a Q-switched ytterbium-doped fiber ring laser based on a composite saturable absorber made of graphene oxide and chromium. We show that the addition of a thin layer of chromium can lead to pulse durations ranging from 3.5 to 9.4 µs and subsequently increasing the laser peak power.
RESUMO
In this paper, a mathematical model of the extrusion process in 3D printing of high-energy composites is studied. These composites are formed from polymer binder and powder with bimodal particles obtained by electric explosion technique. The main difficulty of extrusion 3D printing method is primarily linked to the high viscosity of utilized material, especially one with high concentration of particles. In this case, the viscosity of the initial mixture depends on the pressure, temperature and concentration of the filler, as well as on the particle dispersion. Under certain conditions the ignition of high-energy material in the nozzle is possible, thus the search for optimal printing parameters based on the mathematical modeling and the following experimental verification are the main purposes of the current work.