Plasma-aminothiols status and inverse correlation of total homocysteine with B-vitamins in arsenic exposed population of West Bengal, India.

Chronic arsenic toxicity is a serious environmental health problem across the world. Bangladesh and India (particularly the state of West Bengal) are the worst affected countries with such problem. The present study reports plasma-aminothiols (p-aminothiols) like L-cysteine (L-Cys), cysteinyl glycine (Cys-gly), total homocysteine (t-Hcy) and glutathione (GSH) status, and the inverse relationship of t-Hcy with B-vitamins (B1, B6, B9 and B12) in arsenic exposed population of West Bengal, India. Reverse phase HPLC was used to measure p-aminothiols and serum B-vitamins in different arsenic exposed population. Arsenic in drinking water and urine were measured by flow injection analysis system - Atomic Absorption Spectrometry (FIAS-AAS) and Transversely heated graphite atomizer (THGA-AAS) techniques, respectively. Water arsenic exposure was >50 µg/L in 50% population, of which majority (33.58%) belong to the range of >50-500 µg/L and more than 8% were even >1000 µg/L. Urine arsenic (µg/g creatinine) levels increased with arsenic exposure. The variability among p-aminothiols was also observed with higher exposure to arsenic in drinking water. A significant difference between exposed and control population was noticed for plasma L-Cys. The difference of B-vitamins between the population exposed to <50 and >50 µg/L arsenic in drinking water was also found to be significant. B9 and B12 deficiency with increased consumption of arsenic in water corroborates the anemic conditions commonly observed among arsenic exposed population. The aminothiol status indicated oxidative stress in exposed population. This study demonstrated progressive increase in plasma t-Hcy as well as inverse relationships of serum B-vitamins with increased water arsenic concentration.

Work-exposure to PM10 and aromatic volatile organic compounds, excretion of urinary biomarkers and effect on the pulmonary function and heme-metabolism: A study of petrol pump workers and traffic police personnel in Kolkata City, India.

This study focused work-exposure to particulate matter ≤ 10 µm (PM10), volatile organic compounds (VOCs) and biological monitoring of major VOCs (BTEX) to observe the significant effects of traffic related pollutants on respiratory and hematological systems of workers engaged in two occupational settings, petrol pumps and traffic areas of Kolkata metropolitan city, India. PM10 was assessed by personal sampling and particle size distribution by 8-stage Cascade Impactor. VOCs were analysed by gas chromatography-flame ionization detector (GC-FID) and five urinary metabolites, trans trans- mercapturic acid (tt-MA), S-phenyl mercapturic acid (SPMA), hippuric acid (HA), mandelic acid (MA) and methyl hippuric acid (MHA) of VOCs, benzene, toluene, ethyl benzene and xylenes (BTEX) by reverse phase high performance liquid chromatography (HPLC). Pulmonary functions test (PFT) was measured Spirometrically. ∂-aminoleavulinic acid (ALA) and porphobilinogen (PBG) in lymphocytes were measured spectrophometrically following column chromatographic separation. High exposure to PM10, having 50% of particles, ≤ 5.0 µm in both the occupational settings. Exposure to toluene was highest in petrol pumps whereas benzene was highest (104.6 ± 99.0 µg m-3) for traffic police personnel. Workplace Benzene is found many fold higher than the National ambient standard. Air-benzene is correlated significantly with pre- and post-shift tt-MA (p < 0.001) and SPMA (p < 0.001) of exposed workers. Blood cell counts indicated benzene induced hematotoxicity. ALA and PBG accumulation in lymphocytes indicated alteration in heme-metabolism, especially among traffic police. Significant reduction of force exploratory volume in one second (FEV1) and forced vital capacity (FVC) of fuel fillers are observed with increased tt-MA and SPMA. Study revealed PFT impairments 11.11% (6.66% restrictive and 2.22% obstructive and combined restrictive and obstructive type, each) among petrol pumps and 8.3% obstructive type among traffic police.

Industrial hygiene survey in an aluminium reduction plant in India.

This study reports a work-environmental assessment and workers' exposure in a major prebake type aluminium smelter in India. Levels of known health hazards in and near the main smelting operations viz., the Potroom, the Carbon area, the Butt section, the Rodding shop, the Bath preparing area and the Casthouse were measured. Dustiness in general was high to excessively high. Mean levels of respirable dust (PM10) in air in the three dustiest areas were 24.07 mg/m3 in the Carbon areas, 27.57 mg/m3 in the Bath preparing and 4.44 mg/m3 in the Rodding shop. 40- 60% of the particles were less than 5 microm in size. 0.5- 2.82% particulate fluoride was obtained in the size fraction 0.4- 4.7 microm of the Potroom air. Naturally, exposures to total dusts were very high in these processes. The background levels of NOx and SO2 and fluorides (gaseous and particulate) were found to be within the prescribed Indian Standards. Higher exposures to gaseous and particulate fluoride, 3.85 and 6.53 mg/m3 respectively, were observed among the Rodding shop workers. The levels ofpolycyclic aromatic hydrocarbons (PAHs) were deemed to be excessive in the Carbon area. Measurements of heat stress were made in winter and were found to be lower than the prescribed limit.

Assessment of respirable dust and its free silica contents in different Indian coalmines.

Assessment of respirable dust, personal exposures of miners and free silica contents in dust were undertaken to find out the associated risk of coal workers' pneumoconiosis in 9 coal mines of Eastern India during 1988-91. Mine Research Establishment (MRE), 113A Gravimetric Dust Sampler (GDS) and personal samplers (AFC 123), Cassella, London, approved by Director General of Mines Safety (DGMS) were used respectively for monitoring of mine air dust and personal exposures of miners. Fourier Transform Infra-red (FTIR) Spectroscopy determined free silica in respirable dusts. Thermal Conditions like Wet Bulb Globe Temperature (WBGT) index, humidity and wind velocity were also recorded during monitoring. The dust levels in the face return air of both, Board & Pillar (B&P) and Long Wall (LW) mining were found above the permissible level recommended by DGMS, Govt. of India. The drilling, blasting and loading are the major dusty operations in B&P method. Exposures of driller and loader were varied between, 0.81-9.48 mg/m3 and 0.05-9.84 mg/m3 respectively in B&P mining, whereas exposures of DOSCO loader, Shearer operator and Power Support Face Worker were varied between 2.65-9.11 mg/m3, 0.22-10.00 mg/m3 and 0.12-9.32 mg/m3 respectively in LW mining. In open cast mining, compressor and driller operators are the major exposed groups. The percentage silica in respirable dusts found below 5% in all most all the workers except among query loaders and drillers of open cast mines.

Byssinosis among jute mill workers.

Although byssinosis in jute mill workers remains controversial, studies in a few jute mills in West-Bengal, India, revealed typical byssinotic syndrome associated with acute changes in FEV1 on the first working day after rest. The present study on 148 jute mill workers is reported to confirm the occurrence of byssinosis in jute mill workers. Work related respiratory symptoms; acute and chronic pulmonary function changes among exposed workers were studied on the basis of standard questionnaire and spirometric method along with dust level, particle mass size distributions and gram-negative bacterial endotoxins. The pulmonary function test (PFT) changes were defined as per the recommendation of World Health Organization and of Bouhys et al. Total dust in jute mill air were monitored by high volume sampling, technique (Staplex, USA), Andersen cascade impactor was used for particle size distribution and personal exposure level was determined by personal sampler (Casella, London). Endotoxin in airborne jute dust was analysed by Lymulus Amebocyte Lysate (LAL) "Gel Clot" technique. Batching is the dustiest process in the mill. Size distribution showed that about 70-80% dust in diameter of < 10 microm, 40-50%, < 5 microm and 10-20%, < 2 microm. Mean endotoxin levels found in hatching, spinning and weaving, and beaming were 2.319 microg/m3, 0.956 microg/ m3, 0.041 microg/m3 respectively and are comparable to the values obtained up to date in Indian cotton mills. Respiratory morbidity study reported typical byssinotic symptoms along with acute post shift FEV1 changes (31.8%) and chronic changes in FEV1 (43.2%) among exposed workers. The group with higher exposure showed significantly lower FVC, FEV1, PEFR and FEF25-75% values. The study confirmed the findings of the earlier studies and clearly indicated that the Indian jute mill workers are also suffering from byssinosis as observed in cotton, flask and hemp workers.

Airborne endotoxin and its relationship to pulmonary function among workers in an Indian jute mill.

Air samples from various processing areas of an Indian jute mill were examined for endotoxin. The authors assessed work-related respiratory symptoms and pulmonary function changes in the dust-exposed workers from the different processing areas using a standard questionnaire and spirometry. Endotoxin was estimated in water extract of jute dust from 3 milling areas, and in outside air, by the Limulus amebocyte lysate gel clot technique. The batching, spinning, and weaving areas of the jute mill showed endotoxin levels of 0.22-4.42 microg/m3, 0.04-1.47 microg/m3, and 0.01-0.07 microg/m3, respectively, values similar to those found in Indian cotton mills. Respiratory morbidities among the workers included typical byssinotic symptoms, along with acute changes in postshift forced expiratory volume in 1 s (FEV1.0) (31.8%). Results of this study demonstrated that increased exposure to bacterial endotoxin in airborne dust is related to byssinotic symptoms among Indian jute mill workers. Findings were similar to those reported previously for workers in the cotton, flax, and hemp industries.