Suppressing Two-Plasmon Decay with Laser Frequency Detuning.

Three-dimensional laser-plasma interaction simulations show that laser frequency detuning by an amount achievable with current laser technology can be used to suppress the two-plasmon decay (TPD) instability and the corresponding hot-electron generation. For the plasma conditions and laser configuration in a direct-drive inertial confinement fusion implosion on the OMEGA laser, the simulations show that ∼0.7% laser frequency detuning is sufficient to eliminate TPD-driven hot-electron generation in current experiments. This allows for higher ablation pressures in future implosion designs by using higher laser intensities.

Origins and Scaling of Hot-Electron Preheat in Ignition-Scale Direct-Drive Inertial Confinement Fusion Experiments.

Planar laser-plasma interaction (LPI) experiments at the National Ignition Facility (NIF) have allowed access for the first time to regimes of electron density scale length (∼500 to 700 µm), electron temperature (∼3 to 5 keV), and laser intensity (6 to 16×10^{14} W/cm^{2}) that are relevant to direct-drive inertial confinement fusion ignition. Unlike in shorter-scale-length plasmas on OMEGA, scattered-light data on the NIF show that the near-quarter-critical LPI physics is dominated by stimulated Raman scattering (SRS) rather than by two-plasmon decay (TPD). This difference in regime is explained based on absolute SRS and TPD threshold considerations. SRS sidescatter tangential to density contours and other SRS mechanisms are observed. The fraction of laser energy converted to hot electrons is ∼0.7% to 2.9%, consistent with observed levels of SRS. The intensity threshold for hot-electron production is assessed, and the use of a Si ablator slightly increases this threshold from ∼4×10^{14} to ∼6×10^{14} W/cm^{2}. These results have significant implications for mitigation of LPI hot-electron preheat in direct-drive ignition designs.

Two-Plasmon Decay Mitigation in Direct-Drive Inertial-Confinement-Fusion Experiments Using Multilayer Targets.

Multilayer direct-drive inertial-confinement-fusion targets are shown to significantly reduce two-plasmon decay (TPD) driven hot-electron production while maintaining high hydrodynamic efficiency. Implosion experiments on the OMEGA laser used targets with silicon layered between an inner beryllium and outer silicon-doped plastic ablator. A factor-of-5 reduction in hot-electron generation (>50 keV) was observed in the multilayer targets relative to pure CH targets. Three-dimensional simulations of the TPD-driven hot-electron production using a laser-plasma interaction code (lpse) that includes nonlinear and kinetic effects show good agreement with the measurements. The simulations suggest that the reduction in hot-electron production observed in the multilayer targets is primarily caused by increased electron-ion collisional damping.

Demonstration of Fuel Hot-Spot Pressure in Excess of 50 Gbar for Direct-Drive, Layered Deuterium-Tritium Implosions on OMEGA.

A record fuel hot-spot pressure P_{hs}=56±7 Gbar was inferred from x-ray and nuclear diagnostics for direct-drive inertial confinement fusion cryogenic, layered deuterium-tritium implosions on the 60-beam, 30-kJ, 351-nm OMEGA Laser System. When hydrodynamically scaled to the energy of the National Ignition Facility, these implosions achieved a Lawson parameter ∼60% of the value required for ignition [A. Bose et al., Phys. Rev. E 93, 011201(R) (2016)], similar to indirect-drive implosions [R. Betti et al., Phys. Rev. Lett. 114, 255003 (2015)], and nearly half of the direct-drive ignition-threshold pressure. Relative to symmetric, one-dimensional simulations, the inferred hot-spot pressure is approximately 40% lower. Three-dimensional simulations suggest that low-mode distortion of the hot spot seeded by laser-drive nonuniformity and target-positioning error reduces target performance.

Scaling the yield of laser-driven electron-positron jets to laboratory astrophysical applications.

We report new experimental results obtained on three different laser facilities that show directed laser-driven relativistic electron-positron jets with up to 30 times larger yields than previously obtained and a quadratic (∼E_{L}^{2}) dependence of the positron yield on the laser energy. This favorable scaling stems from a combination of higher energy electrons due to increased laser intensity and the recirculation of MeV electrons in the mm-thick target. Based on this scaling, first principles simulations predict the possibility of using such electron-positron jets, produced at upcoming high-energy laser facilities, to probe the physics of relativistic collisionless shocks in the laboratory.

Multiple beam two-plasmon decay: linear threshold to nonlinear saturation in three dimensions.

The linear stability of multiple coherent laser beams with respect to two-plasmon-decay instability in an inhomogeneous plasma in three dimensions has been determined. Cooperation between beams leads to absolute instability of long-wavelength decays, while shorter-wavelength shared waves are shown to saturate convectively. The multibeam, in its absolutely unstable form, has the lowest threshold for most cases considered. Nonlinear calculations using a three-dimensional extended Zakharov model show that Langmuir turbulence created by the absolute instability modifies the convective saturation of the shorter-wavelength modes, which are seen to dominate at late times.

Nonuniformly driven two-plasmon-decay instability in direct-drive implosions.

Half-harmonic emission spectra and images taken during directly driven implosions show that the two-plasmon decay (TPD) instability is driven nonuniformly over the target surface and that multibeam effects dominate this instability. The images show a spatially limited extent of the TPD instability. A prominent spectral feature is used to determine the electron temperature in the corona. Near threshold the temperatures agree with one-dimensional hydrodynamic predictions but exceed them by ∼10% above the TPD threshold. Two-dimensional hydrodynamic simulations indicate that a significant part (∼20%) of the laser intensity must be locally absorbed by the TPD instability (i.e., by collisional damping of the electron plasma waves) to maintain these temperature islands.

k-space theory and convective gains of stimulated Raman side scattering.

We have developed a k-space theory for stimulated Raman scattering. The theory is used to calculate the convective gain of stimulated Raman side scattering (SRSS) in order to clarify the discrepancies found between previous gain formulas proposed in the literature. The gains are dramatically modified by the eigenvalue of SRSS, and the maximum gain occurs not at the perfect wave-number matching condition but instead at a wave number having a small deviation that is associated with the eigenvalue. Numerical solutions of the k-space theory equations are compared with, and used to verify, analytically derived gains. We demonstrate connections to the existing path integral theories, and we derive a similar path integral formula in k space.

Experimental validation of the two-plasmon-decay common-wave process.

The energy in hot electrons produced by the two plasmon decay instability, in planar targets, is measured to be the same when driven by one or two laser beams and significantly reduced with four for a constant overlapped intensity on the OMEGA EP. This is caused by multiple beams sharing the same common electron-plasma wave. A model, consistent with the experimental results, predicts that multiple laser beams can only drive a resonant common two plasmon decay electron-plasma wave in the region of wave numbers bisecting the beams. In this region, the gain is proportional to the overlapped laser beam intensity.

Saturation of the two-plasmon decay instability in long-scale-length plasmas relevant to direct-drive inertial confinement fusion.

Measurements of the hot-electron generation by the two-plasmon-decay instability are made in plasmas relevant to direct-drive inertial confinement fusion. Density-scale lengths of 400 µm at n(cr)/4 in planar CH targets allowed the two-plasmon-decay instability to be driven to saturation for vacuum intensities above ~3.5×10(14) W cm(-2). In the saturated regime, ~1% of the laser energy is converted to hot electrons. The hot-electron temperature is measured to increase rapidly from 25 to 90 keV as the laser beam intensity is increased from 2 to 7×10(14) W cm(-2). This increase in the hot-electron temperature is compared with predictions from nonlinear Zakharov models.

Time-resolved measurements of hot-electron equilibration dynamics in high-intensity laser interactions with thin-foil solid targets.

Time-resolved K(α) spectroscopy has been used to infer the hot-electron equilibration dynamics in high-intensity laser interactions with picosecond pulses and thin-foil solid targets. The measured K(α)-emission pulse width increases from ~3 to 6 ps for laser intensities from ~10(18) to 10(19) W/cm(2). Collisional energy-transfer model calculations suggest that hot electrons with mean energies from ~0.8 to 2 MeV are contained inside the target. The inferred mean hot-electron energies are broadly consistent with ponderomotive scaling over the relevant intensity range.

Hot-electron preheat and mitigation in polar-direct-drive experiments at the National Ignition Facility.

Target preheat by superthermal electrons from laser-plasma instabilities is a major obstacle to achieving thermonuclear ignition via direct-drive inertial confinement fusion at the National Ignition Facility (NIF). Polar-direct-drive surrogate plastic implosion experiments were performed on the NIF to quantify preheat levels at an ignition-relevant scale and develop mitigation strategies. The experiments were used to infer the hot-electron temperature, energy fraction, and divergence, and to directly measure the spatial hot-electron energy deposition profile inside the imploding shell. Silicon layers buried in the ablator are shown to mitigate the growth of laser-plasma instabilities and reduce preheat, providing a promising path forward for ignition designs at an on-target intensity of about 10^{15}W/cm^{2}.

Postural strategies employed by orangutans (Pongo abelii) during feeding in the terminal branch niche.

Obtaining food in an arboreal habitat is complex due to the irregular and flexible nature of the supports available. As the largest predominantly arboreal primate, orangutans are expected to have developed particular postural strategies to enable them to feed successfully. In particular, they need to be able to cope within the terminal branch niche (TBN) as this is where the smallest, most compliant supports are, and also where the majority of the fruit and leaves are situated. We recorded feeding posture, along with a number of ecological and behavioral variables from different age-sex classes to enable analysis of the interactions between these and the compliance of the supports (as estimated from stiffness score). Suspensory postures with a pronograde orientation were used on the most compliant supports for all age-sex classes and appeared to play a particular role in facilitating safe use of the TBN by distributing body weight and using limbs for balance across multiple supports. This contradicts the idea that orthograde suspension evolved in response to the demands of feeding in the TBN. Adult males appear to use the same postures and feeding zones as the other age-sex classes, but appear to use stiffer supports where possible due to their larger body mass. Feeding method differed between the age-sex classes in relation to support stiffness, with larger adult males taking fewer risks due to their larger size, compared to infants and juveniles.

A new method for recording complex positional behaviours and habitat interactions in primates.

In an arboreal habitat, primates have to cope with a complex meshwork of flexible supports in order to obtain food, find mates and avoid predators. To understand how animals interact with such complex environments we can study their positional behaviour. However, due to the intricate variation in locomotion and posture it can be difficult to capture details such as limb use (i.e. weight and balance), limb flexion and substrate use. This paper presents a suitable method replicable for any primate species, based on the movement notation technique, Sutton Movement Writing (SMW), aiming to record the spatial arrangement of limbs during positional behaviours on multiple, compliant supports. This method was piloted during a year-long field study of wild orangutans (Pongo abelii) and validated and tested for inter- and intraobserver reliability using videos from the field. Overall, SMW shows considerable promise for increasing the resolution with which positional behaviours can be recorded under field conditions and provides a way to extract numerical data for use in statistical analyses. This will facilitate our understanding of how behaviours vary in response to the environment, and the capabilities of primates to perform key tasks in their distinct niches.

Absolute stimulated Brillouin side scattering in an inhomogeneous flowing plasma.

Theory of absolute stimulated Brillouin side scattering in an inhomogeneous flowing plasma is presented and verified numerically. The linearized coupling equations are transformed into a Schrödinger equation in k space and solved as an eigenvalue problem. Analytic threshold, growth rate, and scattering geometry are obtained for the pump laser with arbitrary incidence angle. Numerical solutions of the coupling equations show good agreements between the theoretical and numerical absolute thresholds when ion-acoustic wave damping is not too large, and thus an old but famous threshold in [Phys. Fluids 17, 1211 (1974)PFLDAS0031-917110.1063/1.1694867] is corrected. It also indicates that the theoretical analysis is not accurate for strong dampings, since it will overestimate the absolute threshold. Possibility of finding such instability in the current experiments is also discussed.

The mammographic appearance of the BioMonitor implantable loop recorder.

The imaging appearance of implantable loop recorders (ILR's) have been described in literature (Steinberger and Margolies, 2017; Mayo and Leung, 2017; Tsau and Berger, 2004)1-3; however, the mammographic appearance of the BioMonitor ILR produced by BIOTRONIK has not been described. It is important for radiologists interpreting breast imaging to become familiar with the appearance of different implantable cardiac devices on mammograms in order to create accurate reports and adjust imaging protocols to improve imaging quality and lessen patient discomfort as needed.

Scaling hot-electron generation to high-power, kilojoule-class laser-solid interactions.

Thin-foil targets were irradiated with high-power (1 ≤ P(L) ≤ 210 TW), 10-ps pulses focused to intensities of I>10(18) W/cm(2) and studied with K-photon spectroscopy. Comparing the energy emitted in K photons to target-heating calculations shows a laser-energy-coupling efficiency to hot electrons of η(L-e) = 20 ± 10%. Time-resolved x-ray emission measurements suggest that laser energy is coupled to hot electrons over the entire duration of the incident laser drive. Comparison of the K-photon emission data to previous data at similar laser intensities shows that η(L-e) is independent of laser-pulse duration from 1 ≤ τ(p) ≤ 10 ps.

Relativistic quasimonoenergetic positron jets from intense laser-solid interactions.

Detailed angle and energy resolved measurements of positrons ejected from the back of a gold target that was irradiated with an intense picosecond duration laser pulse reveal that the positrons are ejected in a collimated relativistic jet. The laser-positron energy conversion efficiency is ∼2×10{-4}. The jets have ∼20 degree angular divergence and the energy distributions are quasimonoenergetic with energy of 4 to 20 MeV and a beam temperature of ∼1 MeV. The sheath electric field on the surface of the target is shown to determine the positron energy. The positron angular and energy distribution is controlled by varying the sheath field, through the laser conditions and target geometry.

Down to the wire: tricuspid stenosis in the setting of multiple pacing leads.

Tricuspid stenosis in the setting of endocardial pacing leads is a rare entity, attributed to infection or lead malposition. We report the case of a 37-year-old man without these risk factors, who presented with new onset severe tricuspid stenosis in the setting of multiple chronic pacing leads.