Conductometric investigation of nano MnSO4 association parameters and complex formation with glycylglycine in aqueous and methanol-water mixtures: Thermodynamic parameters and potential applications.

This study aimed to investigate the ion pair association values and association parameters of nano MnSO4 in water and methanol-water mixtures (20 % and 40 % methanol by mass percentage) at varying temperatures (298.15, 303.15, 308.15, and 313.15 K) using the conductometric technique. Additionally, the parameters for complex formation between nano MnSO4 and glycylglycine as a ligand were determined. The focus was on elucidating the thermodynamic formation parameters for the nano Mn2+-glycylglycine interaction, with particular emphasis on comparing the 1: 1 and 1: 2 (M: L) complexes to understand the complexation behavior more comprehensively. The results indicated that the complexation process was spontaneous, as evidenced by negative ΔGf (formation free energy change) values, which increased with temperature, highlighting the enhanced spontaneity of the process. The findings provide valuable insights into designing new materials and procedures by enhancing our understanding of the complexation behavior of nano MnSO4 with ligands like glycylglycine, thus contributing to advancements in various applications such as chemical synthesis, medicines, and environmental remediation. By elucidating the thermodynamic aspects of these interactions, the study aimed to provide valuable information that could be utilized in practical applications and further research endeavors.

Effect of indomethacin on the electrical conductance and electrochemical voltammetry of copper chloride in methanol, ethanol, and their binary mixture with water.

This study investigated the physicochemical properties of the interaction of indomethacin and copper chloride using the electrical conductance measurement in methanol, ethanol, and their binary mixture with water at room temperature (298.15 K), to determine the solvation behavior, redox behavior, and kinetics. The association parameters were computed using the Fuoss-Hsia-Fernández-Prini and Fuoss-Shedlovsky models. The standard Gibbs energy for association (ΔGoA), Walden product (Λoηo), and hydrodynamic radii (RH) were calculated to study the interaction of indomethacin and copper chloride. On the other hand, cyclic voltammetry examines the electrochemical redox behavior of copper chloride using a gold electrode and its interactions with indomethacin. Results showed changes in peak potentials and currents density in the presence of indomethacin, indicating alterations in redox behavior and reaction rates. Overall, this research can be valuable in understanding the electrochemical properties and potential applications of indomethacin and copper chloride, as well as in developing new drugs or therapeutic agents, which could have has implications in various fields, including drug development, electrochemistry, and materials science.

An Eco-Friendly, Interference, and Solvent Free Surfactant-Assisted Dual-Wavelength ß-CorrectionSpectrometric Method for Total Determination and Speciation of Cu2+ Ions in Water.

Spectral interference through the presence of uninformative variables, excess reagents, and complications in the refinement of the analyte signal is common in the quest to identify complex species in real samples. Therefore, an economical green, facile, and sensitive strategy has been developed for Cu2+ detection using the anionic surfactant sodium dodecylsulphate- (SDS-) assisted dual-wavelength ß-correction spectrophotometric strategy combined with the chromogenic reagent zincon (ZI). The low limits of detection (LOD) and quantification (LOQ) of Cu2+ using ordinary (single wavelength) spectrophotometry were 0.19 (3.02) and 0.63 (10.0) µgmL-1, and these values were improved to 0.08 (1.27) and 0.26 µgmL-1 (4.12 µM)) using ß-correction (dual wavelength) spectrophotometry, respectively. The LOD and LOQ were improved from 0.08 (1.27) and 0.26 (4.12) µgmL-1 to 0.02 (0.32) and 0.08 µgmL-1 (1.27 µM) using SDS-assisted dual-ß-correction spectrometry, respectively. Ringbom, s, and the corrected absorbance (Ac) versus Cu2+ concentration plots were linear over the concentration range 1.10-2.4 (17.4-38.1) and 0.50-2.40 µgmL-1 (7.94-38.1 µM), respectively. Sandell's sensitivity index of 3.0 × 10-3 µg/cm2 was achieved. The selectivity was further confirmed via monitoring the impact of common diverse ions and surfactants on the corrected absorbance. Total determination and Cu2+ speciation in water were favorably implemented and validated by ICP-OES at 95% (P=0.05). Satisfactory Cu2+ recoveries in tap (92.2-98.0%) and mineral (105-111.0%) water samples were achieved. The sensing system is simple, reliable, sensitive, and selective for Cu2+ detection.

Melting temperature of surface-tethered DNA.

A method for the accurate determination of the melting temperature (T(m)) of surface-immobilized DNA duplexes that exploits the fluorescence-quenching properties of gold is reported. A thiolated single-stranded DNA probe is chemisorbed onto a gold surface and then hybridized to a fluorophore-labeled complementary sequence. On formation of the duplex, the fluorescence of the label is effectively quenched by the gold surface. As the temperature is increased and the duplex denatures, the fluorophore label moves away from the gold surface and the fluorescence signal is again observed. The increase in fluorescence is measured as the temperature is ramped, and using first-derivative plots, the T(m) is determined. To demonstrate the approach, the T(m) of the cystic fibrosis DF508 mutation was determined in three different phases: in solution, in suspension immobilized on gold nanoparticles, and immobilized on gold film-coated substrate. The technique was further applied to optimize conditions for differentiation between a surface-immobilized DF508 mutant probe and a mutant/wild-type target exploiting increasing stringency in varying salt and formamide concentrations. The approach has application in optimization of assay conditions for biosensors that use gold substrates as well as in melting curve analysis.

Methylene blue as an electrochemical indicator for DF508 cystic fibrosis mutation detection.

Cystic fibrosis is one of the most common life-shortening, childhood-onset inherited diseases. Among the 1,000 known cystic fibrosis-related mutations, DF508 is the most common, with a frequency varying between 50% and 70% according to geographical areas and population typology. In this work, we report the use of methylene blue as an electrochemical reporting agent in the discrimination of synthetic PCR analogue of the DF508 cystic fibrosis mutation (Mut) from the wild type (Wt). At optimum experimental condition, a discrimination factor between mutant and wild type of approximately 1.5-fold was found. The proposed assay was quantitative and linear in the range of 10-100 nM, exhibiting a limit of detection of 2.64 nM. Electrochemical studies at variable ionic strength conditions allowed further elucidation of the mechanism of the methylene blue (MB)-DNA interaction. To the best of our knowledge, this is the first report of detection of hybridisation solely via guanine-specific MB-DNA interaction simultaneously in MB solution, independent of electrostatic interaction as demonstrated in the ionic strength study. The introduction of formamide in the hybridization buffer, to improve discrimination, was also investigated. Finally, mutant wild type discrimination was demonstrated, at 10 nM concentration, with the use of a multi-sensor setup.

Cystic fibrosis: a label-free detection approach based on thermally modulated electrochemical impedance spectroscopy.

Cystic fibrosis is one of the most common genetically inherited diseases in northern Europe, with the DF508 mutation being the most common, and among the Caucasian population being responsible for almost 70% of cases. In this work, we report on the use of thermally modulated electrochemical impedance spectroscopy for the discrimination of the DF508 mutation from the wild-type sequence. DNA probes (15 and 21 bases long) were immobilised on the surface of gold electrodes and the variation of the charge-transfer resistance was monitored as a function of hybridisation. Two sets of targets were used in this work: synthetic 15-mer sequences and two single-stranded synthetic analogues of PCR products 82 (mutant) and 85 (wild type) bases long. Hybridisation with short targets resulted in very sequence specific charge-transfer-resistance variation with a discrimination factor at room temperature between fully complementary and mismatched sequences of approximately fivefold. However, in the case of the single-stranded synthetic PCR product analogues, a lower discrimination factor was recorded (1.5-fold). The effect of temperature was investigated to improve discrimination and the use of a posthybridisation wash at elevated temperature resulted in a fivefold improvement in the discrimination factor. Using an electrode array with probes immobilised against each of the mutant and wild-type sequences, we achieved an unequivocal detection of the DF508 mutation.