Dynamic vapor generator that simulates transient odor emissions of victims entrapped in the voids of collapsed buildings.

The design, development, and validation of a dynamic vapor generator are presented. The generator simulates human scent (odor) emissions from trapped victims in the voids of collapsed buildings. The validation of the device was carried out using a reference detector: a quadrupole mass spectrometer equipped with a pulsed sampling (PS-MS) system. A series of experiments were conducted for evaluating the simulator's performance, defining types and weights of different factors, and proposing further optimization of the device. The developed device enabled the production of stable and transient odor profiles in a controllable and reproducible way (relative standard deviation, RSD < 11%) at ppbv to low ppmv concentrations and allowed emission durations up to 30 min. Moreover, the factors affecting its optimum performance (i.e., evaporation chamber temperature, air flow rate through the mixing chamber, air flow rate through the evaporation chamber, and type of compound) were evaluated through an analysis of variance (ANOVA) tool revealing the next steps toward optimizing the generator. The developed simulator, potentially, can also serve the need for calibrating and evaluating the performance of analytical devices (e.g., gas chromatographers, ion mobility spectrometers, mass spectrometers, sensors, e-noses) in the field. Furthermore, it can contribute in better training of urban search and rescue (USaR) canines.

Environmental aspects of VOCs evolved in the early stages of human decomposition.

In the present study, the time profile, measured as "accumulation", of volatile organic compounds (VOCs) produced during the early stages of human decomposition was investigated. A human cadaver was placed in a sealed bag at approximately the 4th day after death. Evolved VOCs were monitored for 24 h by sampling at different time intervals. VOCs produced were analyzed by thermal desorption/gas chromatography/mass spectrometry (TD/GC/MS). Over 30 substances were identified in total. These included mainly aliphatic and aromatic hydrocarbons, oxygenated compounds (alcohols, aldehydes, ketones) and organic sulfides. The last were the most prominent class of compounds identified. Eleven compounds were present in all the sampling cycles and constitute a "common core": ethanol, 2-propanone, dimethyl disulfide, methyl benzene, octane, 2-butanone, methyl ethyl disulfide, dimethyl trisulfide and o-, m- and p-xylenes. The last sampling cycle yielded the most abundant compounds in number and quantities. Inorganic gases such as CO2, CO, NH3 and H2S were also determined. The fundamental physicochemical properties of the evolved VOCs were used for evaluating their environmental impacts. It appears that the decay process, which is a dynamic procedure, can provide chemical signals that might be detected and properly evaluated by experts in the fields of forensic sciences, search and rescue units and environmental scientists.

A scale-up field experiment for the monitoring of a burning process using chemical, audio, and video sensors.

Fires are becoming more violent and frequent resulting in major economic losses and long-lasting effects on communities and ecosystems; thus, efficient fire monitoring is becoming a necessity. A novel triple multi-sensor approach was developed for monitoring and studying the burning of dry forest fuel in an open field scheduled experiment; chemical, optical, and acoustical sensors were combined to record the fire spread. The results of this integrated field campaign for real-time monitoring of the fire event are presented and discussed. Chemical analysis, despite its limitations, corresponded to the burning process with a minor time delay. Nevertheless, the evolution profile of CO2, CO, NO, and O2 were detected and monitored. The chemical monitoring of smoke components enabled the observing of the different fire phases (flaming, smoldering) based on the emissions identified in each phase. The analysis of fire acoustical signals presented accurate and timely response to the fire event. In the same content, the use of a thermographic camera, for monitoring the biomass burning, was also considerable (both profiles of the intensities of average gray and red component greater than 230) and presented similar promising potentials to audio results. Further work is needed towards integrating sensors signals for automation purposes leading to potential applications in real situations.

Combined chemical and optical methods for monitoring the early decay stages of surrogate human models.

As the body decays shortly after death, a variety of gases and volatile organic compounds (VOCs) constantly emanate. Ethical and practical reasons limit the use of human corpses in controlled, time-dependent, intervening experiments for monitoring the chemistry of body decay. Therefore the utilization of pig carcasses serves as a potential surrogate to human models. The aim of this work was to study buried body decay in conditions of entrapment in collapsed buildings. Six domestic pigs were used to study carcass decay. They were enclosed in plastic body bags after being partially buried with rubbles, resembling entrapment in collapsed buildings. Three experimental cycles were performed, employing two pig carcasses in each cycle; VOCs and inorganic gases were measured daily, along with daily visible and thermal images. VOCs were collected in standard sorbent tubes and subsequently analyzed using a Thermal Desorption/Gas Chromatograph/high sensitivity bench-top Time-of-Flight Mass Spectrometer (TD/GC/TOF-MS). A comprehensive, stage by stage, detailed information on the decay process is being presented based on the experimental macroscopic observations, justifying thus the use of pig carcasses as surrogate material. A variety of VOCs were identified including almost all chemical classes: sulfur, nitrogen, oxygen compounds (aldehydes, alcohols, ketones, acids and esters), hydrocarbons, fluorides and chlorides. Carcasses obtained from a pig farm resulted in more sulfur and nitrogen cadaveric volatiles. Carbon dioxide was by far the most abundant inorganic gas identified along with carbon monoxide, hydrogen sulfide and sulfur dioxide. Visual monitoring was based on video captured images allowing for macroscopic observations, while thermal camera monitoring which is mostly temperature dependent, resulted in highlighting the local micro-changes on the carcasses, as a result of the intense microbial activity. The combination of chemical and optical methods proved very useful and informative, uncovering hidden aspects of the early stages of decay and also guiding in the development of combined chemical and imaging methods for the detection of dead bodies.