Biomechanical comparison of screw and suture fixation for temporary transarticular tarsocrural immobilization in canine cadavers.

OBJECTIVE: To biomechanically evaluate an ultrahigh-molecular-weight polyethylene (UWMWPE) suture for temporary tarsocrural immobilization as a potential alternative to the existing surgical method, which uses a 4.5 AO/ASIF calcaneotibial cortical screw. STUDY DESIGN: Randomized in vitro biomechanical study. ANIMALS: Pelvic limbs (n = 20) from 10 euthanized adult dogs (average bodyweight of 29.9 kg ± 1.9 kg). METHODS: Tarsocrural joints were immobilized either with a 4.5 AO/ASIF screw or a 1 mm diameter UHMWPE suture. Limbs were loaded with 60 N, 120 N, and 180 N, each for 100 cycles. After cyclic loading, immobilizations were loaded until failure. Load at failure and mode of failure were recorded. RESULTS: Both immobilization methods remained intact during loading with 60 N, 120 N, and 180 N. Mean and standard deviation (± SD) failure loads were higher for the cortical screw (524.9 N ± 148.7 N) than for the UHMWPE suture (387.8 N ± 105.6 N), P = .0084. The stiffness of both systems was equivalent. CONCLUSION: Both techniques were suitable for transarticular tarsocrural immobilization in large-breed canine cadavers. While load at failure was higher for the screw compared to the suture construct, stiffness of both methods was comparable based on the laboratory settings in this in vitro study. CLINICAL SIGNIFICANCE: Based on the results of this study, both the cortical screw and the UHMWPE suture stabilized the tibiotarsal joint at clinically relevant loads. However, when exposed to high loads, the cortical screw provides increased tibiotarsal stability. Comparative data need to be collected prior to widespread use of UHMWPE sutures in clinical cases.

Fracture Repair in Cats Using a Conical Coupling Mini 1.9 to 2.5 mm Locking Plate System.

OBJECTIVE: The aim of this study was to retrospectively evaluate the clinical application of the Fixin mini 1.9 to 2.5 system for the treatment of long bone fractures in cats. We proposed that the Fixin mini system would successfully stabilize long bone fractures in cats with a healing time and complication rate similar to those previously reported for feline fractures using other locking bone plate systems. MATERIALS AND METHODS: Medical records and radiographs of cats with long bone fractures stabilized with the Fixin mini 1.9 to 2.5 system were retrospectively reviewed. Signalment, body weight, bone(s) fractured, region of bone fractured, fracture classification, concurrent orthopaedic injuries, complications, time to functional union, if minimally invasive plate osteosynthesis techniques were used, plate size, number of plates, bone graft use and ancillary methods of fixation were recorded. RESULTS: Fifty-six fractures in 54 cats were included. Mean time to radiographic union was 8.8 weeks. Complications were recorded in 8 out of 56 fractures. Major complications occurred in 4 of 56 fractures and minor complications occurred in 4 of 56 fractures. CONCLUSION: The Fixin mini 1.9 to 2.5 system had an overall complication rate and time to functional union similar to that of other implant systems used to treat feline long bone fractures and it appears suitable for repair of a wide variety of long bone fracture configurations in cats.

In vitro comparison of tibial plateau leveling osteotomy with and without use of a tibial plateau leveling jig.

OBJECTIVE: To evaluate the influence of a tibial plateau leveling jig on osteotomy orientation, fragment reduction, and postoperative tibial plateau angle (TPA) during tibial plateau leveling osteotomy (TPLO). STUDY DESIGN: In vitro experimental study. ANIMALS: Large-breed canine cadavers (n=20). METHODS: TPLO was performed on 40 hindlimbs using 4 methods. Group 1: Jig; dogs in dorsal recumbency with the osteotomy parallel to the distal jig pin. Groups 2-4: No jig; dogs in lateral recumbency with the osteotomy in a vertical orientation (group 2: tibia parallel to the table top; group 3: controlled superimposition of the femoral condyles; group 4: internal rotation of the tibia). Postoperative TPA, fragment reduction, and osteotomy orientation relative to the tibial plateau were compared. Positive or negative values denoted deviation from parallel relative to the tibial plateau. RESULTS: Postoperative TPA, fragment reduction, and proximodistal osteotomy orientation were not significantly different between groups. Craniocaudal osteotomy orientation was significantly different (P<.005) from the tibial plateau. Median deviations were -4.0 degrees (group 1), 11.8 degrees (group 2), 11.2 degrees (group 3), and 0.2 degrees (group 4). Group 1 was not significantly different from group 4. CONCLUSIONS: A jig is not essential for osteotomy orientation, tibial plateau rotation, or fragment reduction. Comparable results were achieved performing a vertical osteotomy with the tibia slightly internally rotated (10 degrees -15 degrees) and parallel to the table surface. CLINICAL RELEVANCE: TPLO without use of a jig reduces surgical trauma, is less time consuming, and reduces cost.

Comparison of tibial plateau angles in normal and cranial cruciate deficient stifles of Labrador retrievers.

OBJECTIVE: To investigate tibial plateau angles (TPA) in normal and cranial cruciate ligament (CCL) deficient stifles of Labrador retrievers. STUDY DESIGN: Prospective clinical study. ANIMALS: Eighty-one client-owned purebred Labrador retrievers. METHODS: Lateral radiographs of the tibia were obtained from 2 groups of dogs. Group I (42 dogs) had CCL rupture diagnosed by arthrotomy or arthroscopy. Group II (39 dogs) had no history of orthopedic problems, no radiographic evidence of CCL rupture, and dogs were >8 years of age. The tibial axis and the tibial plateau were determined on the radiographs, and the TPA was measured using image measurement software. The TPA measurement results of groups I and II were compared. RESULTS: Group I (CCL rupture) had a mean TPA (+/-SD) of 23.5 (+/-3.1) degrees, and group II (normal) had a mean TPA (+/-SD) of 23.6 (+/-3.5) degrees. With a P value of.97, no statistical difference was detected between the 2 groups. CONCLUSIONS: No correlation between the magnitude of TPA and CCL rupture was identified in this group of Labrador retrievers. CLINICAL RELEVANCE: In Labrador retrievers, TPA should not be used as a predictor of CCL rupture.

Effect of tibial plateau leveling on stability of the canine cranial cruciate-deficient stifle joint: an in vitro study.

OBJECTIVE: To evaluate the effect of tibial plateau leveling on joint motion in canine stifle joints in which the cranial cruciate ligament (CCL) had been severed. STUDY DESIGN: In vitro cadaver study. ANIMALS: Six canine cadaver hind legs. METHODS: Radiographs of the stifle joints were made to evaluate the tibial plateau angle with respect to the long axis of the tibia. The specimens were mounted in a custom-made testing device to measure cranio-caudal translation of the tibia with respect to the femur. An axial load was applied to the tibia, and its position was recorded in the normal stifle, after transection of the CCL, and after tibial plateau leveling. Further, the amount of caudal tibial thrust was measured in the tibial plateau leveled specimen while series of eight linearly increasing axial tibial loads were applied. RESULTS: Transection of the CCL resulted in cranial tibial translation when axial tibial load was applied. After tibial plateau leveling, axial loading resulted in caudal translation of the tibia. Increasing axial tibial load caused a linear increase in caudal tibial thrust in all tibial plateau-leveled specimens. CONCLUSIONS: After tibial plateau leveling, axial tibial load generates caudal tibial thrust, which increases if additional axial load is applied. CLINICAL RELEVANCE: Tibial plateau leveling osteotomy may prevent cranial translation during weight bearing in dogs with CCL rupture by converting axial load into caudal tibial thrust. The amount of caudal tibial thrust seems to be proportional to the amount of weight bearing.

Influence of limb positioning and measurement method on the magnitude of the tibial plateau angle.

OBJECTIVE: To evaluate the effect of limb positioning and measurement technique on the magnitude of the radiographically determined tibial plateau angle (R-TPA). STUDY DESIGN: In vitro study, R-TPA was determined by 6 blinded observers and image measurement software. ANIMALS: Five canine cadaver hind limbs. METHODS: The legs were positioned on a custom-made positioning device simulating a radiographic tabletop technique in lateral recumbency. True lateral positioning was defined by superimposition of femoral and tibial condyles on the radiographic projection. Radiographs were taken while the specimens were relocated in a proximal, distal, caudal, and cranial direction with respect to the radiographic beam. For each specimen, 25 different radiographic views were obtained and 6 blinded observers determined the radiographic TPA using 2 different methods. The conventional method used precise anatomic landmarks to determine the tibial plateau. To simulate osteoarthritic changes complicating identification of these landmarks, the tangential method estimated the tibial plateau as the tangent to the central portion of the tibial plateau. After periarticular soft tissue dissection the anatomic tibial plateau angle (A-TPA) was determined. The A-TPA and the R-TPA were compared. RESULTS: The R-TPA significantly decreased as limb position with respect to the X-ray beam changed from cranial proximal to caudal distal. The maximal mean radiographic R-TPA difference was 3.6 degrees with the first and 5.7 degrees with the second method. Regardless of the method used there was no significant difference between A-TPA and R-TPA in the true lateral position. In the peripheral positions, however, significant differences between anatomic and radiographic TPA were seen. CONCLUSIONS: Limb positioning influenced the radiographic appearance of the tibial plateau and the magnitude of the measured TPA. Cranial and proximal positioning of the limb relative to the X-ray beam leads to overestimation whereas caudal and distal positioning leads to underestimation of the TPA. CLINICAL RELEVANCE: True lateral positioning of the tibia defined by superimposition of the femoral and tibial condyles should be used for accurate TPA determination before tibial plateau leveling osteotomy.