Germicidal efficacy of continuous and pulsed ultraviolet-C radiation on pathogen models and SARS-CoV-2.

Ultraviolet radiation's germicidal efficacy depends on several parameters, including wavelength, radiant exposure, microbial physiology, biological matrices, and surfaces. In this work, several ultraviolet radiation sources (a low-pressure mercury lamp, a KrCl excimer, and four UV LEDs) emitting continuous or pulsed irradiation were compared. The greatest log reductions in E. coli cells and B. subtilis endospores were 4.1 ± 0.2 (18 mJ cm-2) and 4.5 ± 0.1 (42 mJ cm-2) with continuous 222 nm, respectively. The highest MS2 log reduction observed was 2.7 ± 0.1 (277 nm at 3809 mJ cm-2). Log reductions of SARS-CoV-2 with continuous 222 nm and 277 nm were ≥ 3.4 ± 0.7, with 13.3 mJ cm-2 and 60 mJ cm-2, respectively. There was no statistical difference between continuous and pulsed irradiation (0.83-16.7% [222 nm and 277 nm] or 0.83-20% [280 nm] duty rates) on E. coli inactivation. Pulsed 260 nm radiation (0.5% duty rate) at 260 nm yielded significantly greater log reduction for both bacteria than continuous 260 nm radiation. There was no statistical difference in SARS-CoV-2 inactivation between continuous and pulsed 222 nm UV-C radiation and pulsed 277 nm radiation demonstrated greater germicidal efficacy than continuous 277 nm radiation. Greater radiant exposure for all radiation sources was required to inactivate MS2 bacteriophage. Findings demonstrate that pulsed irradiation could be more useful than continuous UV radiation in human-occupied spaces, but threshold limit values should be respected. Pathogen-specific sensitivities, experimental setup, and quantification methods for determining germicidal efficacy remain important factors when optimizing ultraviolet radiation for surface decontamination or other applications.

The use of LEDs for the stomatal response, light compensation points, and storage of spinach and kale.

The spectral composition of some light-emitting diodes (LEDs) reportedly results in higher crop yield, prevents wilting, and reduces thermal damage to plants. The use of LEDs for postharvest storage and shelf-life extension has been limited, but the potential of this technology will allow for greater applications in horticulture and the food industry. In this experiment, 'Winterbor' kale (Brassica oleracea) and 'Melody' spinach (Spinacia oleracea) plants were measured for the light compensation point and stomatal response under 14 different wavelengths of light ranging from 405 to 661 nm. Data collected from these measurements were used to select two different wavelengths of LEDs and determine the proper irradiance levels for an LED irradiance storage test on spinach and kale. Treatments comprising blue, red, and amber lights were effective at increasing the stomatal opening, while the green light resulted in reduced stomatal opening. For spinach, the light response curve showed that light compensation points at 500 nm and 560 nm were 65.3 and 64.7 µmol m-2 s-1, respectively. For kale, the light compensation points at 500 nm and 560 nm were 50.8 and 44.1 µmol m-2 s-1, respectively. For the storage test experiment at room temperature, kale and spinach were stored under four different treatments: dark treatment (control), standard white fluorescent light, 500 nm, and 560 nm LED wavelengths. For spinach, the moisture content was 70.1% at 560 nm and 53.7% for dark, moisture losses of 41.5% under the 560-nm treatment and 52.0% for the dark treatment. The fresh basis moisture content was 74.6% at 560 nm and 59.3% in the dark. Moisture loss under the 560 nm treatment was 39.6% while the dark treatment had a 54.0% moisture loss. A visual assessment scale was monitored, 560 nm resulted in the top visual quality for kale compared to the other treatments with the lowest visual quality under the dark treatment at day 4. For spinach, the visual quality for 560 nm treatment was statistically the standard white fluorescent light and 500 nm, with poor-quality product occurring by day 4 and the lowest-quality product occurring at day 5. The LED treatments improved the shelf life of spinach and kale, likely as a result of stomatal aperture closure, photosynthetic rate near the light compensation point and stability of the atmospheric moisture content. This study provides valuable information on the extension of the shelf life of leafy greens during storage. Reducing fresh produce waste in grocery stores will increase revenue, thereby benefiting the Canadian economy while providing social and environmental benefits that entail increased food security and reduced food waste.

Re-interpreting the photosynthetically action radiation (PAR) curve in plants.

The basis of a plant's spectral response of photosynthesis, or the photosynthetically active radiation (PAR) curve, is derived from earlier studies nearly five decades ago. These studies reported that blue and red light were the primary wavelengths; however, shifting within red and blue peaks (10-40 nm) in addition to different PAR curve shapes was observed. In recent years, the McCree curve, which is considered the standard for spectral response of photosynthesis, has been challenged because of experimental design and differences between photosynthetic and whole-plant growth responses. Therefore, this overview provides an amalgamation of all the PAR curve studies, with a focus on narrow spectrum light characteristics, including light measurement units, full width at half maximums (FWHMs) of narrow light spectra, and light intensity levels. While replicating these pioneering works with higher wavelength resolution and narrower light spectrum across the whole visible spectrum is still challenging, we hope that this re-interpretation of PAR curves in plants can elucidate and provide in-depth insight into spectral responses of photosynthesis. We leave the readers with some different perspectives and prospects that need to be considered for future studies.

An Update on Plant Photobiology and Implications for Cannabis Production.

This review presents recent developments in plant photobiology and lighting systems for horticultural crops, as well as potential applications for cannabis (Cannabis sativa and C. indica) plant production. The legal and commercial production of the cannabis plant is a relatively new, rapidly growing, and highly profitable industry in Europe and North America. However, more knowledge transfer from plant studies and horticultural communities to commercial cannabis plant growers is needed. Plant photosynthesis and photomorphogenesis are influenced by light wavelength, intensity, and photoperiod via plant photoreceptors that sense light and control plant growth. Further, light properties play a critical role in plant vegetative growth and reproductive (flowering) developmental stages, as well as in biomass, secondary metabolite synthesis, and accumulation. Advantages and disadvantages of widespread greenhouse lighting systems that use high pressure sodium lamps or light emitting diode (LED) lighting are known. Some artificial plant lighting practices will require improvements for cannabis production. By manipulating LED light spectra and stimulating specific plant photoreceptors, it may be possible to minimize operation costs while maximizing cannabis biomass and cannabinoid yield, including tetrahydrocannabinol (or Δ9-tetrahydrocannabinol) and cannabidiol for medicinal and recreational purposes. The basics of plant photobiology (photosynthesis and photomorphogenesis) and electrical lighting systems are discussed, with an emphasis on how the light spectrum and lighting strategies could influence cannabis production and secondary compound accumulation.