Manipulating cinnamyl alcohol dehydrogenase (CAD) expression in flax affects fibre composition and properties.

BACKGROUND: In recent decades cultivation of flax and its application have dramatically decreased. One of the reasons for this is unpredictable quality and properties of flax fibre, because they depend on environmental factors, retting duration and growing conditions. These factors have contribution to the fibre composition, which consists of cellulose, hemicelluloses, lignin and pectin. By far, it is largely established that in flax, lignin reduces an accessibility of enzymes either to pectin, hemicelluloses or cellulose (during retting or in biofuel synthesis and paper production).Therefore, in this study we evaluated composition and properties of flax fibre from plants with silenced CAD (cinnamyl alcohol dehydrogenase) gene, which is key in the lignin biosynthesis. There is evidence that CAD is a useful tool to improve lignin digestibility and/or to lower the lignin levels in plants. RESULTS: Two studied lines responded differentially to the introduced modification due to the efficiency of the CAD silencing. Phylogenetic analysis revealed that flax CAD belongs to the "bona-fide" CAD family. CAD down-regulation had an effect in the reduced lignin amount in the flax fibre cell wall and as FT-IR results suggests, disturbed lignin composition and structure. Moreover introduced modification activated a compensatory mechanism which was manifested in the accumulation of cellulose and/or pectin. These changes had putative correlation with observed improved fiber's tensile strength. Moreover, CAD down-regulation did not disturb at all or has only slight effect on flax plants' development in vivo, however, the resistance against flax major pathogen Fusarium oxysporum decreased slightly. The modification positively affected fibre possessing; it resulted in more uniform retting. CONCLUSION: The major finding of our paper is that the modification targeted directly to block lignin synthesis caused not only reduced lignin level in fibre, but also affected amount and organization of cellulose and pectin. However, to conclude that all observed changes are trustworthy and correlated exclusively to CAD repression, further analysis of the modified plants genome is necessary. Secondly, this is one of the first studies on the crop from the low-lignin plants from the field trail which demonstrates that such plants could be successfully cultivated in a field.

Expression of the Tyrosine Hydroxylase Gene from Rat Leads to Oxidative Stress in Potato Plants.

Catecholamines are biogenic aromatic amines common among both animals and plants. In animals, they are synthesized via tyrosine hydroxylation, while both hydroxylation or decarboxylation of tyrosine are possible in plants, depending on the species, though no tyrosine hydroxylase-a counterpart of the animal enzyme-has been identified yet. It is known that in potato plants, it is the decarboxylation of tyrosine that leads to catecholamine production. In this paper, we present the effects of the induction of an alternative route of catecholamine production by introducing the tyrosine hydroxylase gene from rat. We demonstrate that an animal system can be used by the plant. However, it does not function to synthesize catecholamines. Instead, it leads to elevated reactive oxygen species content and a constant stress condition in the plant, which responds with elevated antioxidant levels and improved resistance to infection.

Lignin deficiency in transgenic flax resulted in plants with improved mechanical properties.

Flax (Linum usitatissimum L.) is a very important source of natural fibres used by the textile industry. Flax fibres are called lignocellulosic, because they contain mainly cellulose (about 70%), with hemicellulose, pectin and lignin. Lignin is a three-dimensional polymer with a high molecular weight, and it gives rigidity and mechanical resistance to the fibre and plant. Its presence means the fibres have worse elastic properties than non-lignocellulosic fibres, e.g. cotton fibres, which contain no lignin. The main aim of this study was to produce low-lignin flax plants with fibres with modified elastic properties. An improvement in the mechanical properties was expected. The used strategy for CAD down-regulation was based on gene silencing RNAi technology. Manipulation of the CAD gene caused changes in enzyme activity, lignin content and in the composition of the cell wall in the transgenic plants. The detected reduction in the lignin level in the CAD-deficient plants resulted in improved mechanical properties. Young's modulus was up to 75% higher in the generated transgenic plants (CAD33) relative to the control plants. A significant increase in the lignin precursor contents and a reduction in the pectin and hemicellulose constituents was also detected. A decrease in pectin and hemicellulose, as well as a lower lignin content, might lead to improved extractability of the fibres. However, the resistance of the transgenic lines to Fusarium oxysporum was over two-fold lower than for the non-transformed plants. Since Fusarium species are used as retting organisms and had been isolated from retted flax, the increased sensitivity of the CAD-deficient plant to F. oxysporum infection might lead to improved flax retting.

Pleiotropic effect of phenolic compounds content increases in transgenic flax plant.

The principal goal of this paper was to generate flax (Linum usitatissimum L.) plants with increased antioxidant properties. To accomplish this a vector containing a multigene construct was prepared, and transgenic plants overexpressing essential flavonoid biosynthesis pathway enzymes were generated and analyzed. The simultaneous expression of genes encoding chalcone synthase (CHS), chalcone isomerase (CHI), and dihydroflavonol reductase (DFR) resulted in a significant increase of flax antioxidant capacity. To investigate the determinants of higher antioxidant properties of transgenic plants, the phenolic acids and lignans compound contents were measured. In both green part and seed extracts from transgenic plants, the phenolic acids level was increased when compared to the control. The calculated correlation coefficient between phenolic acids content and antioxidant capacity (0.82 and 0.70 for green part and flaxseed, respectively) perfectly reflects their strong relationship. The increase in yield of transgenic plants and their higher resistance to Fusarium culmorum and Fusarium oxysporum when compared to the control plants was a characteristic feature. It was assessed a very high correlation (correlation coefficient = 0.9) between phenolic acids level in flaxseed extract and resistance to F. culmorum. The flowering date of transgenic plants was approximately 3 weeks earlier than that of the control plants. Interestingly, a significant increase in monounsaturated fatty acids and a slight increase in lignans content accompanied the increase in antioxidant properties of flaxseeds.

Yellow lupine gene encoding stearoyl-ACP desaturase--organization, expression and potential application.

A gene for the delta9 desaturase specific to stearoyl-ACP (acyl carrier protein) was identified from yellow lupine (Lupinus luteus) cDNA and genomic libraries through the differential display method. The desaturase transcript appears in plants infected with Bradyrhizobium sp. (Lupinus) as revealed by Northern hybridization, RT-PCR and expression of beta-glucuronidase under the desaturase promoter. A small amount of desaturase transcript was also detected in uninfected plants, which suggests that the gene does not belong to the strict nodule-specific sequences. The desaturase provides unsaturated fatty acids for additional cell membrane synthesis. During nodule and symbiosome development a peribacteroid membrane is formed and the requirement for membrane surface increases, thus the level of desaturase expression is also higher. Transgenic plants of Nicotiana tabacum with overexpression of the full-length lupine stearoyl-ACP desaturase sequence were obtained. They revealed higher content of unsaturated fatty acids (especially oleic acid) in comparison with control plants.

Does biopolymers composition in seeds contribute to the flax resistance against the Fusarium infection?

Over the last decades, the cultivation of fibrous flax declined heavily. There are number of reasons for that fact; one of them is flax susceptibility to the pathogen infection. Damages caused mainly by fungi from genus Fusarium lead to the significant losses when cultivating flax, which in turn discourage farmers to grow flax. Therefore, to launch the new products from flax with attractive properties there is a need to obtain new flax varieties with increased resistance to pathogens. In order to obtain the better quality of flax fiber, we previously generated flax with reduced pectin or lignin level (cell wall polymers). The modifications altered also plants' resistance to the Fusarium infection. Undoubtedly, the plant defense system is complex, however, in this article we aimed to investigate the composition of modified flax seeds and to correlate it with the observed changes in the flax resistance to the pathogen attack. In particular, we evaluated the content and composition of carbohydrates (cell wall polymers: pectin, cellulose, hemicelluloses and mucilage), and phenylpropanoid compounds (lignin, lignans, phenolics). From the obtained results we concluded that the observed changes in the vulnerability to pathogens putatively correlate with the antioxidant potential of phenylpropanoids accumulated in seeds, seco-isolariciresinol and coumaric acid diglycosides in particular, and with pectin level as a carbon source for pathogens. Surprisingly, relatively less important for the resistance was the physical barrier, including lignin and cellulose amount and cellulose structure. Certainly, the hypothesis should be verified on a larger number of genotypes.

Engineering Flax with the GT Family 1 Solanum sogarandinum Glycosyltransferase SsGT1 Confers Increased Resistance to Fusarium Infection.

The aim of this study was to engineer a flax with increased resistance to pathogens. The approach was based on the recent analysis of the Solanum sogarandinum -derived glycosyltransferase (UGT) protein, designated SsGT1 (previously called 5UGT). On the basis of enzyme studies, the recombinant SsGT1 is a 7-O-glycosyltransferase, the natural substrates of which include both anthocyanidins and flavonols such as kaempferol and quercetin. Because flavonoids act as antioxidants and glycosylation increases the stability of flavonoids, it has been suggested that the accumulation of a higher quantity of flavonoid glycosides in transgenic plants might improve their resistance to pathogen infection. Flax overproducing SsGT1 showed higher resistance to Fusarium infection than wild-type plants, and this was correlated with a significant increase in the flavonoid glycoside content in the transgenic plants. Overproduction of glycosyltransferase in transgenic flax also resulted in proanthocyanin, lignan, phenolic acid, and unsaturated fatty acid accumulation in the seeds. The last is meaningful from a biotechnological point of view and might suggest the involvement of polyphenol glycosides in the protection of unsaturated fatty acids against oxidation and thus improve oil storage. It is thus suggested that introduction of SsGT1 is sufficient for engineering altered pathogen resistance in flax.

Engineering of PHB synthesis causes improved elastic properties of flax fibers.

Flax stem is a source of fiber used by the textile industry. Flax fibers are separated from other parts of stems in the process called retting and are probably the first plant fibers used by man for textile purposes (1). Nowadays flax cultivation is often limited because of its lower elastic property compared to cotton fibers. Thus the goal of this study was to increase the flax fiber quality using a transgenic approach. Expression of three bacterial genes coding for beta-ketothiolase (phb A), acetoacetyl-CoA reductase (phb B), and PHB synthase (phb C) resulted in poly-beta-hydroxybutyrate (PHB) accumulation in the plant stem. PHB is known as a biodegradable thermoplastic displaying chemical and physical properties similar to those of conventional plastics (i.e., polypropylene). The fibers isolated from transgenic flax plants cultivated in the field and synthesizing PHB were then studied for biomechanical properties. All measured parameters, strength, Young's modulus, and energy for failure of flax fibers, were significantly increased. Thus the substantial improvement in elastic properties of fibers from the transgenic line has been achieved. Since the acetyl CoA, substrate for PHB synthesis, is involved not only for energy production but also for synthesis of many cellular constituents, the goal of this study was also the analysis of those metabolites, which interfere with plant physiology and thus fiber quality. The analyzed plants showed that reduction in lignin, pectin, and hemicellulose levels resulted in increased retting efficiency. A significant increase in phenolic acids was also detected, and this was the reason for improved plant resistance to pathogen infection. However, a slight decrease in crop production was detected.